Find or Sell Used Cars, Trucks, and SUVs in USA

2010 Sierra 2500hd V8 4x4 Sle Z71 Leather Rear Camera Crew Texas on 2040-cars

US $25,780.00
Year:2010 Mileage:94545
Location:

Mansfield, Texas, United States

Mansfield, Texas, United States

Auto Services in Texas

Zepco ★★★★★

Automobile Parts & Supplies, Speedometers, Truck Equipment, Parts & Accessories-Wholesale & Manufacturers
Address: Kemp
Phone: (972) 690-1052

Xtreme Motor Cars ★★★★★

Used Car Dealers
Address: 1025 1/2 North Loop, West-University-Place
Phone: (713) 863-1165

Worthingtons Divine Auto ★★★★★

New Car Dealers
Address: 2412 E Trinity Mills Rd, Bartonville
Phone: (972) 820-0980

Worthington Divine Auto ★★★★★

Auto Repair & Service
Address: 1325 Whitlock Ln, Lake-Dallas
Phone: (972) 335-9823

Wills Point Automotive ★★★★★

Auto Repair & Service, Wheels-Aligning & Balancing, Wheel Alignment-Frame & Axle Servicing-Automotive
Address: 712 Houston St, Canton
Phone: (903) 873-5900

Weaver Bros. Motor Co ★★★★★

Auto Repair & Service, New Car Dealers, New Truck Dealers
Address: 2035 S Wheeler St, Newton
Phone: (409) 384-6847

Auto blog

GM recalls Chevy Express, GMC Savana over rollaway concern

Mon, 21 Jan 2013

The National Highway Traffic Safety Administration has issued a recall notice for a small number of General Motors fullsize vans due to possible rollaway concerns. On certain 2013 Chevrolet Express and 2013 GMC Savana models, it is possible to remove the key from the ignition without the shifter being in park.
Only 980 total units are being affected by this recall, and GM is fixing the issue by replacing the ignition cylinder and associated keys. Affected Chevy vans were built during most of November and December while its GMC counterpart was only built for a week in November. The recall goes into effect on January 23, and to find out if your vehicle applies to the recall, the GM and NHTSA contact numbers can be found on the official recall notice, which is posted below.

2015 GMC Yukon erupts into flames during Anaheim test drive [w/video]

Mon, 24 Mar 2014

A 2015 GMC Yukon burst into flames while on a test drive in Anaheim, CA on Sunday after smoke filled the cabin. Residents of the neighborhood where the driver abandoned the redesigned Yukon reported hearing a series of small explosions (likely the tires, based on the video), according to a report from KTLA and The Los Angeles Times.
No one was injured in the incident, which The Times reports occurred after a possible oil or fluid leak. As you can see in the image above, the Yukon was engulfed in flames, although the Anaheim Fire Department was able to put out the blaze in about 15 minutes.
"We're very lucky that no one got hurt, and it was in an area that... was safe," Lt. Tim Schmidt of the Anaheim Police Department told KTLA reporters. "If there was any place that was going to be safe, it would be this area. It's very open. It worked out for us."

GM readying aluminum-body fullsize pickups

Wed, 19 Feb 2014

Ford's extensive use of aluminum in its 2015 F-150 is a big deal. A really big deal. Big enough, in fact, that General Motors is reportedly changing its fullsize pickup strategy. According to The Wall Street Journal, The General has locked in partnerships with Alcoa Inc. and Novelis Inc. - companies that will supply aluminum for the next-generation Chevrolet Silverado and GMC Sierra trucks.
"Ford's introduction of the 2015 F-150 pickup truck was a game changer, and it's the first, not the last, conversion of this type," Novelis spokesperson Charles Belbin told the Journal. The switch to aluminum has allowed Ford to shave roughly 700 pounds off its fullsize truck's curb weight. And while official mileage ratings have not been announced, the weight loss should go a long way for improving efficiency, especially when combined other efficiency-minded improvements including better aerodynamics and new, turbocharged V6 engines.
Of course, aluminum-bodied cars are nothing new. But extensive use of aluminum in a major, best-selling product like the Ford F-150 is expected to kick off widespread use of this weight-saving material as availability rises and cost decreases. The WSJ reports that GM had originally explored the idea of moving to aluminum pickups back in 2008, but abandoned the idea due to cost concerns amid economic woes.