2024 Gmc Sierra 1500 At4 on 2040-cars

Auto blog

NHTSA opens safety investigations into Toyota, GM and Honda crossovers

The National Highway Traffic Safety Administration is evidently keeping itself very busy these days, as the federal agency has just announced it is launching or renewing investigations into Toyota, Honda and General Motors crossovers.
2006-2008 model year Toyota RAV4 crossovers are under review for allegations of rear tie-rod rust which can result in failure. NHTSA also said it is probing some 35 complaints about 2005 Honda Pilot models with inappropriate activation of the vehicles' stability control system. The alleged malfunction can cause the vehicles to slow down or stop in bad unsafe situations. At the moment, NHTSA is reviewing a petition regarding the Pilot issue, a move that will determine whether it needs to open a full-blown investigation.
In addition, Saturn Outlook and GMC Acadia three-row crossovers built in 2007-2009 are getting looked at for "loss of low beam headlamp" function. One complainant said the wiring in his Outlook overheated and melted. NHTSA says it has received 415 complaints about the problem and a GM spokesman confirmed that the automaker already started a "Customer Satisfaction Program" in December to address the issue.

Chevy Colorado and GMC Canyon get trim levels reworked again

GM Authority reports that GM has fiddled with trim packages on the Chevrolet Colorado and GMC Canyon for the 2021 model year, eliminating the base trims on both pickups and implementing small price changes. When the new model year goes on sale, the Chevy will lose the rear-wheel drive Base Extended Cab with the automatic transmission that starts at $22,395 after a $1,095 destination charge. The new entry-level is going to be the Work Truck model with the extended cab in rear-wheel drive, starting at $26,595 assuming the destination charge holds steady. That represents a $4,200 jump over the base 2020 model. MSRPs for the entire Work Truck lineup, from base to the Crew Cab Long Box, rise by $400. Elsewhere in the Colorado line, the four Z71 trims go down by $100, while the two ZR2 trims increase by the same amount. Only the six LT trims don't see any change.  The GMC side is a bit more involved due to previously announced changes. The 2020 Canyon comes in SL, Base Canyon, SLE, SLT, All Terrain, and Denali steps. Last month, GM Authority reported the 2021 Canyon would give all that up for the new names Elevation Standard, Elevation, AT4, and Denali. Since the SL base model retires in 2021, the Elevation Standard takes over at the entry level. Unlike on the Colorado, which sheds one trim, the Canyon lineup gets pared from 20 total combinations of trims, cab sizes, and bed lengths, to 14 total combinations. But like the Colorado, due to the loss of the cheapest configuration, the least expensive 2021 Canyon becomes $4,200 more expensive than in 2020, assuming the destination price remains the same. What's more, the 2021 Elevation Standard pricing adds $700 or $800 to the prices of the 2020 Canyon base and SLE models. There are more increases up the range. The 2021 Elevation trim replaces a combination of SLE and SLT models, bumping prices up by up to $900. In 2020, the least expensive All Terrain model is the Extended Cab Cloth for $37,695. For next year, the least expensive AT4 trim is the Crew Cab Short Box for $39,295. Like-for-like, though, the AT4 represents a $300 premium over the 2020 All Terrain Crew Cab Short Box. Three Denali trims will still stand at the top of the heap, each one going up by $400 in 2021. Until GM details the equipment changes, we won't know how the new pricing equates to value.

GM Design shows another early Hummer EV sketch

Like a new mother who's still so excited about her one-year-old baby that she can't stop showing ultrasound photos, General Motors is so excited about its biggest new baby, the battery-electric GMC Hummer, that it can't stop showing off development design sketches. The off-road monster with the 200-kWh Ultium battery pack debuted online on October 21 last year. The next day, the GM Design Instagram page posted some of the Hummer's early "theme sketches" leading to the production version. These had a conceptual flair to them, but were rather restrained. A month later, GM uncovered a series of development renderings showing off a much wilder truck bursting with more angles than a geometry text book. The archives have opened up again with a new "ideation sketch," this one between the first believable sketches and the second truck that Master Chief and Doomguy share on their days off.  All three sets of drawings show similar three-box proportions, it's the details that got a ton of love. On this newest sketch, the fenders flare a touch more than on the production truck, but the wheel wells are cut with the kind of clearance found on a Baja 1000 Trophy Truck. Out back, save for the tow hooks, the rear end is totally different than production. The sketch puts illuminated Hummer script across a narrow tailgate flanked by small square, taillights housing six individual elements. Beneath that, a bumper-less rear end puts nothing more than a sloped bash pate between the truck and the rocks it's just scrambled over. To our eyes, this is the best blend of production-ready comfort from the first sketches and zoot suit angles from the second that we've seen so far.  First deliveries of the GMC Hummer EV Edition 1 are expected before the year is out. When we get a chance to absorb the truck in its native habitats, we'll know whether there's cause for disappointment at what could have been. If so, with all this hunger among the monied for something different, we feel like restomodders have been given the perfect head starts on custom rebodied Hummers that would make things right. Related video: This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings.