Find or Sell Used Cars, Trucks, and SUVs in USA

2008 Ford Taurus Sel, Good Condition on 2040-cars

US $3,000.00
Year:2008 Mileage:141805
Location:

Highland Mills, New York, United States

Highland Mills, New York, United States
Advertising:

The car is in good condition. No major accidents, just minor scratches and dents (almost invisible on the photos). There are 2 minor leaks in engine and tranny, which were quoted by a local mechanic easy fixable for around $700-$900. I have had the car for 4 years and put on around 55K miles 26K of which were long distance. The million dollar question - why change? Since I am not traveling to work anymore it doesn't pay to own a car, so I just leased. Was always very gentle with it and drove with RPM below 2 (kind of gas saving habit). There are some minor scratches on the body and bumpers. Front bumper is a little cracked at the right bottom, almost not visible if you don't know its there. The car has a remote started which works either from one of the 2 remotes or from the key pad. 

Auto Services in New York

Zafuto Automotive Service Inc ★★★★★

Auto Repair & Service
Address: 7400 Porter Rd, Ransomville
Phone: (716) 297-0607

X-Treme Auto Glass ★★★★★

Automobile Parts & Supplies, Glass-Auto, Plate, Window, Etc, Windshield Repair
Address: 2561 Genesee St, Athol-Springs
Phone: (716) 542-1100

Willow Tree Auto Repair ★★★★★

Auto Repair & Service, Engine Rebuilding & Exchange, Auto Engine Rebuilding
Address: 248 Lansingville Rd, Lansing
Phone: (607) 533-3525

Willis Motors ★★★★★

Used Car Dealers
Address: 1128 Dix Ave, Hudson-Falls
Phone: (866) 595-6470

Wicks Automotive Inc ★★★★★

Auto Repair & Service, Automobile Parts & Supplies, Automobile Accessories
Address: 1159 Kennedy Blvd, Castleton
Phone: (201) 339-4668

Whalen Chevrolet Inc ★★★★★

Auto Repair & Service, New Car Dealers, Automobile Body Repairing & Painting
Address: 1528 State Route 29, Galway
Phone: (518) 692-2241

Auto blog

Aluminum lightweighting does, in fact, save fuel

Mon, Apr 14 2014

When the best-selling US truck sheds the equivalent weight of three football fullbacks by shifting to aluminum, folks start paying attention. Oak Ridge National Laboratory took a closer look at whether the reduced fuel consumption from a lighter aluminum body makes up for the fact that producing aluminum is far more energy intensive than steel. And the results of the study are pretty encouraging. In a nutshell, the energy needed to produce a vehicle's raw materials accounts for about 10 percent of a typical vehicle's carbon footprint during its total lifecycle, and that number is up from six percent because of advancements in fuel economy (fuel use is down to about 68 percent of total emissions from about 75 percent). Still, even with that higher material-extraction share, the fuel-efficiency gains from aluminum compared to steel will offset the additional vehicle-extraction energy in just 12,000 miles of driving, according to the study. That means that, from an environmental standpoint, aluminum vehicles are playing with the house's money after just one year on the road. Aluminum-sheet construction got topical real quickly earlier this year when Ford said the 2015 F-150 pickup truck would go to a 93-percent aluminum body construction. In addition to aluminum being less corrosive than steel, that change caused the F-150 to shed 700 pounds from its curb weight. And it looks like the Explorer and Expedition SUVs may go on an aluminum diet next. Take a look at SAE International's synopsis of the Oak Ridge Lab's study below. Life Cycle Energy and Environmental Assessment of Aluminum-Intensive Vehicle Design Advanced lightweight materials are increasingly being incorporated into new vehicle designs by automakers to enhance performance and assist in complying with increasing requirements of corporate average fuel economy standards. To assess the primary energy and carbon dioxide equivalent (CO2e) implications of vehicle designs utilizing these materials, this study examines the potential life cycle impacts of two lightweight material alternative vehicle designs, i.e., steel and aluminum of a typical passenger vehicle operated today in North America. LCA for three common alternative lightweight vehicle designs are evaluated: current production ("Baseline"), an advanced high strength steel and aluminum design ("LWSV"), and an aluminum-intensive design (AIV).

Motor Trend pits Camaro 1LE vs Mustang with Performance Pack, surprises ensue

Thu, 16 Oct 2014

With the 2015 Ford Mustang firmly on the scene, the inevitable comparisons with its arch rival, the 2015 Chevrolet Camaro are just starting to trickle out. Over the next several months, you're likely to be inundated by every outlet's muscle car comparison, whether it be the turbocharged Ford against the V6 Chevy, a V8-powered convertible comparo or what we have here, a competition between each vehicle's performance upgrade.
Motor Trend has pitted the Camaro SS 1LE against a Mustang with the GT Performance Pack for a comprehensive series of comparisons on the test stage, street and finally, at Willow Springs with ace Randy Pobst behind the wheel. As per usual, we aren't about to spoil this one for you.
So, hit the play button, have a look and then let us know what you think in Comments.

Ford moving medium-duty F-Series production from Mexico to Ohio

Thu, 27 Feb 2014


A few more Ford trucks will be built in the US in the near future with news that production of the F-650 and F-750 medium-duty trucks will move from Mexico to Ford's Ohio Assembly Plant in Avon Lake, OH. Ford hasn't confirmed a precise timeline for the move, but The Detroit News claims the Blue Oval will make the shift later this year or in early 2015.
As Ford spokesperson Mike Levine reminded us, back in 2011, Ford announced in an investor release that it would shift production "after the [Ohio] plant stops current production of the Ford E-Series vans." According to that release, the Ohio factory will also receive $128 million in upgrades to build the new trucks, plus the F53 motorhome chassis and F59 commercial chassis.