2000 Ford Taurus Ses 24-v Dohc 6cyl on 2040-cars

Auto blog

Total auto recalls already on record pace in 2014

If you've noticed that there have been more recalls than usual this year, you may be on to something. According to a report from the National Highway Traffic Safety Administration, the US market is on pace to break a record for recalls. In 2013, 22 million cars were recalled. We're only a third of the way through 2014, though, and we've already halved that figure, with 11 million units recalled. That's wild.
Considering the past few months, it shouldn't be a surprise that General Motors is leading the charge, with six million of the 11 million units recalled coming from one of the General's four brands. Between truck recalls, CUV recalls and the ignition switch recall, 2014 hasn't been a great year for GM.
Other recall leaders include Nissan (one million Sentra and Altima sedans), Honda (900,000 Odyssey minivans), Toyota (over one million units in a few recalls), Volkswagen (150,000 Passat sedans), Chrysler (644,000 Dodge Durango and Jeep Grand Cherokee SUVs) and most recently, Ford (434,000 units, the bulk of which were early Ford Escape CUVs). So while it's been a bad year for GM so far, its competitors aren't doing too well, either.

Ford recalls more than 550,000 trucks and SUVs for various safety issues

Ford announced safety recalls for its current F-150 pickup along with several Ford and Lincoln crossovers early Wednesday. The recalls cover more than 550,000 vehicles and address various safety defects, ranging from a fire hazard to potential loss of braking power.  The most far-reaching of the recalls covers approximately 550,000 examples of the 2015-2018 Ford Edge and 2016-2018 Lincoln MKX, which may have been assembled with defective front brake jounce hoses (also commonly referred to as "flex lines"). These hoses run from fixed points on the chassis to the individual front brake calipers. Defective hoses could potentially rupture, allowing brake fluid to leak and resulting in a loss of braking function. Ford will replace the components in question with revised parts.  The next-largest recall is for roughly 3,000 2020 Lincoln Corsair crossovers. The affected models may have been assembled without proper clearance between their rear suspension springs and toe link brackets. The components could potentially make contact, wearing down the protective coating on the rear coil springs, allowing corrosion to occur over time. This corrosion could eventually lead to a failure of the spring. If this happens while the vehicle is being driven, it could result in a sudden change to the vehicle's handling characteristics, and the spring fragments could potentially cause further damage to the car or surrounding traffic.  Ford says owners will be notified that their Corsairs need to be inspected; if there is not adequate clearance between the rear suspension components, Ford's service technicians will remove material from the toe link bracket to allow for operation without contact.  The final (and by far the smallest) recall is for the 2020 F-150. Some units may have left the factory with the incorrect retention nut on the hot lead to the starter motor. Ford says it can cause increased heat generation or electrical arcing, which could potentially result in a fire. Ford says this issue is limited to just a few hundred examples sold in the United States. Dealers will inspect the vehicles and replace the nut if necessary.       

Project Ugly Horse: Part VI

Solid axle? What solid axle?
I was fully prepared to embark on a seven-day journey down a rabbit hole of broken bolts, internet hearsay and consternation.
This should not have gone this easily. Having a long and checkered history of simple projects punctuated by much wailing and gnashing of knuckles, I was fully prepared to embark on a seven-day journey down a rabbit hole of broken bolts, internet hearsay and consternation when I finally decided to lay hands on the '89 Mustang with the goal of relieving the car of its stock rear axle. Instead, it took less than a full morning's worth of work to carve the old 7.5-inch solid axle from its moorings and mock up something, well, different.