Find or Sell Used Cars, Trucks, and SUVs in USA

1988 Ford Ranger Stx Standard Cab Pickup 2-door 2.9l on 2040-cars

US $2,250.00
Year:1988 Mileage:35511
Location:

Brattleboro, Vermont, United States

Brattleboro, Vermont, United States
Advertising:
Fuel Type:GAS
Transmission:Manual
Engine:2.9L 177Cu. In. V6 GAS OHV Naturally Aspirated
Vehicle Title:Clear
Body Type:Standard Cab Pickup
For Sale By:Private Seller
VIN: 1ftcr11t4jua14575 Year: 1988
Make: Ford
Mileage: 35,511
Model: Ranger
Trim: STX Standard Cab Pickup 2-Door
Warranty: Vehicle does NOT have an existing warranty
Drive Type: 4WD
Options: 4-Wheel Drive
Number of Cylinders: 6
Disability Equipped: No
Condition: Used: A vehicle is considered used if it has been registered and issued a title. Used vehicles have had at least one previous owner. The condition of the exterior, interior and engine can vary depending on the vehicle's history. See the seller's listing for full details and description of any imperfections. ... 

                               I have a 1988 ford ranger lifted truck that has 35" tires and I think its 7"  lift total it does run but has been sitting for a couple of years. when I went to start it back fired and with no exhaust on it, it caught fire and burn pressure regulator some vacuum  lines and couple wires you can see in pics. it also needs brakes lines seat bolted down and steering column. needs body and paint work as you can see, it would make someone a great project and toy. it is sold with bill of sale and paper from state so you will have no problem getting title and reg. my state don't have title after 15 years old. it is sold as is were is no warranty. thanks and happy bidding.  miles say 35511 on odometer but it could be over that because on the old rigs the did not read out 6 digit. and the paper work I got is abandoned motor vehicle. from my state. so I don't know I lot about the truck but when it sat here it did run and move so I'am letting you know what I know.

Auto Services in Vermont

North Country Auto Glass ★★★★★

Automobile Parts & Supplies, Glass-Auto, Plate, Window, Etc, Windshield Repair
Address: 64B Hammond Ln, Grand-Isle
Phone: (518) 324-7200

Krueger Autosport ★★★★★

Auto Repair & Service
Address: 398 Route 12A, Taftsville
Phone: (603) 298-2988

TNT Autobody ★★★★

Automobile Body Repairing & Painting, Automobile Body Shop Equipment & Supply-Wholesale & Manufacturers, Automobile Repairing & Service-Equipment & Supplies
Address: 2678 County Route 17, East-Poultney
Phone: (866) 595-6470

Peloquin`s Body Shop & Wrecker ★★★★

Auto Repair & Service
Address: 976 S Barre Rd, East-Barre
Phone: (866) 595-6470

Pearl Street Mobil ★★★★

Auto Repair & Service
Address: 281 Pearl St, Burlington
Phone: (866) 595-6470

Legacy Glass ★★★★

Automobile Parts & Supplies, Glass-Auto, Plate, Window, Etc, Windows
Address: 56 Howe St Bldg E, Rutland
Phone: (802) 775-1400

Auto blog

Ford Fiesta banned from SCCA autocrossing because of rollover risk

Wed, Jan 14 2015

Autocross can be a great way to break into motorsports, especially at SCCA events that allow run-of-the-mill, street-legal vehicles to be run through the cones in parking lots across the country. But while a wide array of vehicles are eligible, not every one is. And now the Ford Fiesta has been removed from the list of qualifying vehicles in the Sports Car Club of America's Street category for solo events. The removal of the Fiesta was publicized in the latest issue of the SCCA's Fastrack News bulletin, which stated that, due to roll-over risk, Fiestas "do not meet the requirements and are to be removed" from the HS category of eligible vehicles. H Stock (or HS for short) is the lowest category of vehicles certified by the SCCA for use in sanctioned events. The disqualification applies to Fiestas from the 2011 model year onwards, and does not apply to the Fiesta ST, which remains eligible. Of course the Fiesta isn't the only model deemed ineligible for SCCA autocross events. According to Jalopnik, other small hatchbacks and crossovers including the Dodge Caliber, Fiat 500, Scion xB and iQ, Nissan Juke and Mini Countryman are also prohibited from competition. We've reached out to both Ford and the SCCA for clarification on the issue, and will issue an update if and when we receive any substantial information.

A cool boost to turbocharger performance

Fri, Jul 17 2015

Since the advent of the forced-induction engine, we have been looking for ways to get every drop of performance we can. There are many approaches to getting additional power using better intercooling, water injection, or even adding nitrous oxide. One take on a short instant burst of power is being researched by Mahle and involves providing supercooled air to an engine, which allows it to burn a leaner fuel mixture and produce more power. The supercooling idea is not new and was examined by Ford in 1993 on the Mustang Mach III concept car, then brought up again in 2003 with the SVT F-150 Lightning concept. Ford called its system the SuperCooler; it was designed to work with any turbocharged or supercharged engine equipped with a water-to-air intercooler. The system on the Lightning concept used a small tank of antifreeze that was hooked up to the truck air conditioning compressor. The air conditioning compressor cooled the antifreeze down to about 30 degrees. The other side of the tank was hooked up to the air-to-water intercooler, which usually had a temperature over 100 degrees. Once the antifreeze was circulated from the tank into the intercooler, it would lower the intercooler temperature and provide for a cooler, denser air charge into the engine; the result was around 50 extra horsepower for a burst of about 30 seconds to a minute, depending on the size of the tank. The system for the Lightning was to be offered as a $750 option and would have been targeted towards drag racers and the like, as it could be used for a run down the drag strip and then re-cooled by the time the truck was back in line. The system was fairly non-intrusive – it only weighed about 25 pounds and did not require a new compressor or intercooler. But as with many concepts, it was ultimately scrapped. The technology was always stuck in the back of my mind, but with larger and more powerful engines being produced it could not find its place. With the advent of new fuel economy standards, we have seen small-displacement turbocharged engines pop up and they seem like the perfect candidate for this type of technology. Ford's EcoBoost 1.0-liter three-cylinder turbocharged engine, as used in the Fiesta and Focus, is one such candidate for this technology. It would add a negligent amount of weight but could provide a boost of 10 to 20 horsepower when needed, like merging onto the highway or catching up to traffic.

Next Ford Mustang to drop 400 pounds

Thu, 15 Aug 2013

The Ford Mustang is already the lightest of the current crop of muscle cars, at around 3,600 pounds for a GT coupe with the six-speed manual transmission. That's almost 260 pounds less than a Chevrolet Camaro SS and about 450 pounds less than a Dodge Challenger R/T, which means the Mustang has a pretty big advantage when it comes to handling, braking, accelerating and economy. More good news: The next Mustang will be even lighter.
According to a report from Edmunds, the sixth-generation Mustang, which is set to debut at the 2014 North American International Auto Show, will shed an additional 400 pounds of body fat. That 11-percent weight reduction will be thanks to lightweight materials, with a particular focus on using stronger, but less material in construction. Aluminum will feature heavily, but Edmunds' inside source warns that there is "nothing terribly exotic" coming to the original pony car.
The other big news is that the new Mustang will be smaller overall. It's going to be 15-inches shorter than the 188.5-inch Mustang on sale today, while it'll also be 6.5 inches narrower. Shorter overhangs, both in the front and rear, are also good signs for those that want an agile Mustang.