1997 Ford Mustang Gt Coupe 2-door on 2040-cars

Auto blog

Ford confirms 1.5-liter EcoBoost four-cylinder engine for 2014 Fusion

Earlier this week, reports were swirling 'round the internet about the 2014 Ford Fusion getting a new 1.5-liter three-cylinder EcoBoost engine. That was... half correct. Ford today confirmed that the 2014 Fusion is, in fact, getting a new 1.5-liter EcoBoost mill, but it has four cylinders, not three.
The new 1.5-liter engine will be the fifth EcoBoost powerplant from Ford Motor Company. Initially to be built at the automaker's Craiova, Romania plant, it will also be offered in the Fusion's twin, the Mondeo, in other markets. This engine will debut at the Shanghai Motor Show next month, and the 1.5-liter is of particular importance in the Chinese market - there is significant tax relief in the People's Republic for vehicles powered by engines with a capacity of 1.5 liters or less.
At a media briefing Thursday, Ford declined to divulge exact power or fuel economy numbers, though Joe Bakaj, vice president of powertrain engineering, told Autoblog that power output should be similar to that of the current 1.6-liter inline-four, and that overall efficiency will be "better than the 1.6." Our earlier report stated that the 1.5-liter four will produce 177 horsepower and 177 pound-feet of torque - losses of 1 hp and 7 lb-ft versus the 1.6-liter engine. Ford states that the 1.5-liter four will feature many of the same technologies used on the company's 1.0-liter EcoBoost inline-three, including an integrated exhaust manifold that recaptures much of the engine's heat.

Ford recalling 126,000 Fusions and Milans over wheel separation concern

Ford has announced a recall of certain Ford Fusion and Mercury Milan vehicles after an investigation by the National Highway Traffic Safety Administration. A total of 128,616 2010 and 2011 models equipped with steel wheels may have been manufactured with wheel studs that could crack and split over time. If that happens, the vehicle may experience a wheel separation.
According to The Detroit News, the company is aware of a total of 30 wheel separation incidents, one of which occurred on the front of the vehicle. Even so, no injuries have been reported as a result of the defect.
The problem apparently stems from the fact that the mounting pads on the vehicles' steel wheels may have been faulty from the factory. In addition, the wheel mounting face on rear disc brakes may not have been installed properly. Ford will inspect the rear disc face and replace them as necessary. In addition, the company will replace all of the vehicle's wheel studs free of charge. Head to the NHTSA website for more information, and click past the jump to view the full recall notice.

Ford recalling 65k Fusions from 2014 and 2015 because key can be removed

Ford is recalling an estimated 64,869 examples of the 2014-2015 Fusion, Fusion Energi and Fusion Hybrid in North America because the key can be removed when the vehicle isn't in Park under certain conditions. Specifically, the campaign covers 56,479 units in the US, 6,048 in Canada and 2,342 in Mexico, according to the automaker's tally on November 11.
Ford says a programming problem in the instrument cluster means that the key can be removed 30 minutes after the ignition is turned off, even if the transmission is not in Park. The situation where this could happen seems quite limited, and the company is not aware of any accidents or injuries related to the issue. However, the fault puts the vehicle out of compliance with federal regulations covering theft protection and rollaways, and must be repaired.
The fix is easy: Ford will reprogram the instrument cluster at no cost to consumers. According to Ford spokesperson Kelli Felker in an email to Autoblog, "We will notify customers the week of January 5th." Scroll down to read Ford's announcement.