Vic Customized By Larry Cerney on 2040-cars

Auto blog

Ford recalling 2015 Mustang for fuel line leak, 20K Transit Connects for plastic panel

Ford is recalling 738 examples of the 2015 2015 Mustang with the 2.3-liter EcoBoost engine – 712 in the US, 16 in Canada. A fuel pressure sensor might have been installed incorrectly on the affected cars, and that could result in a fuel leak. At the time of writing the company hasn't heard any reports of any incidents related to the issue, and parties with affected vehicles can take them to the dealer to have the fuel tube assembly replaced free of charge. The 2014 Transit Connect Cargo Van is also the subject of a safety recall, due to a possible problem with adhesive used on the exterior plastic panel on the sliding doors. There are 19,825 units covered by that recall, which dealers will also repair free of charge. You can find more information on both bulletins in the press releases below. Ford Issues Safety Recall for Certain 2015 Mustang Vehicles in North America for Fuel Pressure Sensor Issue Dec 4, 2014 | DEARBORN, Mich. - Ford is issuing a safety recall for approximately 730 2015 Ford Mustang vehicles in North America (actual 728) for a potential fuel line leak. A fuel pressure sensor, which is part of the fuel supply tube assembly, may have been installed incorrectly, potentially resulting in a pressurized fuel leak. A fuel leak in the presence of an ignition source may result in a fire. Ford is not aware of any fires, accidents or injuries related to this condition. Affected vehicles include certain 2015 Ford Mustangs equipped with 2.3-liter engines built at Flat Rock Assembly Plant, Sept. 25, 2014 to Oct. 9, 2014. Ford is aware of 712 vehicles in the United States and federalized territories and 16 in Canada. These totals are as of Dec. 3, 2014. Dealers will replace the fuel supply tube assembly at no cost to the customer. *** Ford Issues Safety Recall for Certain 2014 Transit Connect Cargo Van Vehicles in North America for Issue with the Plastic Panel on the Sliding Doors Dec 4, 2014 | DEARBORN, Mich. - Ford is issuing a safety recall for approximately 20,000 2014 Transit Connect cargo van vehicles in North America (actual 19,825) for an issue with adhesion of an exterior plastic panel to the sliding doors. This issue may result in noise, a water leak, a loose panel, or separation of the plastic panel from the vehicle while driving, potentially increasing the risk of an accident or injury. Ford is not aware of any accidents or injuries related to this condition.

Why Edmunds took a sledgehammer to its 2015 Ford F-150

The discussion around repair bills for the aluminum-bodied 2015 Ford F-150 pickup continued from the beginning of last year to the end, and haven't abated; as an aside, some Tesla Model S owners have been shocked at disquieting repair estimates for minor damage to their aluminum wunder-sedans. Edmunds decided to inject some fact into the fray: it bought a $52,000 long-term 2015 F-150 and clouted it with an eight-pound sledgehammer. Twice. The rear of the bedside took the impacts since it couldn't be replaced, it would have to be repaired. To the pickup's credit, the only reason associate editor Travis Langness hit it twice was that the first sledgehammer blow didn't do as much damage as Edmunds wanted. After the second, the visible damage included the two direct impacts, a few creases, and a cracked taillight, so they drove the pickup to Santa Monica Ford to get an estimate, complete with a fictitious story about how the damage occurred and the mercy plea that Langness was paying for the repair out-of-pocket. In Part 2 Langness hits on some of the details with getting the truck fixed, such as the massively expensive taillight and the list of tools Ford recommends dealers have to work on aluminum. But he was promised he'd have his truck back in seven days, and Santa Monica Ford got it back to him in seven days. In Part 3 we get the bill. It's not small, but it's quite a bit less than it could have been if the service manager had charged Edmunds the official labor rate for aluminum. We're not going to spoil it here, so check out the videos above and below for the beginning and the end, and head over to Edmunds for the complete story about how it all happened and some riffing on the repair numbers. This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings. Related Video:

How the Ford F-150 SVT Raptor became a reality

The camouflaged Ford F-150 SVT Raptor prototype captured above blazing its way across the desert during a test run left company engineers giggling in amazement, reveals Jamal Hameedi in a new Autoweek video. Ford's global performance vehicle chief engineer, accompanied by senior exterior designer Bruce Williams, sat down with the publication to discuss the concept and development of the automaker's super off-road F-150.
Designing a high-performance pickup in 2008, right when the cost of gasoline was going through the roof, seemed insane at the time, but the team pushed forward with the innovative vehicle regardless. The interview includes plenty of Ford B-roll footage as visual candy, and the conversations include discussions about exterior design, ride comfort, anti-lock brake tuning, suspension engineering, weight reduction and why it was necessary to make the Raptor visually different than Ford's standard F-150. The model's origin story is very interesting, and you can learn more about it by watching the video below.