Lariat Red Adobe Tan Leather 4wd 4x4 Awd Supercrew 3.5 V6 Eco Boost Sync Sunroof on 2040-cars

Auto blog

How Ford made its 2015 Ford Mustang safer for toupee wearers [w/video]

Ford is ready to tell the story of its 2015 Mustang Convertible, the can't-miss bits being the easier, quicker and quieter roof operation, a more robust roof build for a coupe-like cabin noise, more trunk space, better visibility and reduced in-cabin buffeting. The top release system has been completely redesigned with a single, center-mounted latch on the windshield frame instead of the dual latches of before. The driver can now release the roof without having to lean over into the passenger space, after which the top goes down fully automatically with the press of a button. Ford doesn't say how long it takes to stow, but it's apparently done in half as much time as before, so figure around 8 seconds.
The roof uses a five-bow structure, with the fabric outer and full inner headliner sandwiching ten millimeters of insulation. Detailing work on the top has eliminated "unsightly folds" in the corners when the roof is up and made it more compact when down; its Z-fold assembly is 6.7 inches lower than before at its highest point when put down. Ford says the new electric drive internals make less noise when in operation, and the fully-finished droptop look is achieved with snap-in caps that flank the rear seating and stow in the trunk when not in use (the outgoing Mustang's top was higher and the front when folded and always looked like it was catching air and creating drag).
The compact roof and newly independent rear suspension setup in back means liberated trunk space, 11.4 cubic feet ready to swallow golf bags and tourist swag. You can read a lot more about it in the press release below, check it out in the short video of running footage and learn about the aerodynamic improvements made to the entire Mustang lineup that decrease drag and increase fuel economy.

Ford paying $750 million just to close plant in Belgium

According to a report from Reuters, Ford is shelling out $750 million in a severance deal that will see the automaker close its facility in Genk, Belgium. The automaker reached this deal with the 4,000 hourly workers employed at the plant last week, which means the company will pay out an average of $187,500 per worker.
Ford is still negotiating with the 300 salaried workers at the factory, which currently produces the Mondeo sedan. All told, Ford expects to lose around $2 billion in Europe thanks in no small part to the region's ongoing economic downturn, and two more plants are scheduled to be shut down in Europe this year. The company will log its $750 million payout under "special items" for this quarter.
As you may recall, Ford took a similar path in the US back in 2009 when the domestic market took a spill. Back then, the company shelled out around $50,000 per employee with at least one year of experience, plus either $25,000 toward a new car or an extra cash payment of $20,000. It would seem the cost of closing plants in Belgium is a much harder pill to swallow than in the States...

Ford bringing production F-150 to Detroit with Atlas styling and Alcoa blast shields

According to a report in Bloomberg, the 2015 Ford F-150 will indeed be showing up at the Detroit Auto Show next month. It will bring attitude with it, not only in the form of sheetmetal inspired by the Atlas concept (pictured) that appeared at the 2013 Detroit show but also in the Alcoa military blast shields among the display being used to showcase the ruggedness of aluminum.
There's been a lot of talk about the F-150 switching to aluminum body panels (although maintaining a steel frame), and for good reason. The lightweight body is expected to shed more than 700 pounds and greatly increase its highway mileage, but production-line issues and possible delays have been a major focus of attention concerning the best-selling vehicle in America for 32 years, meaning Ford has to get it right. F-150 is responsible for a massive portion of the company's global profits and it will come in a year when company profits are already predicted to decline because of new car launches.
When it comes to dings, the Bloomberg story says Ford wants Alcoa to supply some of the military-grade aluminum it uses for blast shields on battlefield vehicles to help it talk up the toughness of aluminum. Reading commentary on the many stories about the F-150 reveals there are many more little questions about the aluminum overhaul, like "How much will it cost to repair and insure?" and "How will companies hang their magnetic signs?" Answers should start coming in a couple of weeks.