13 F150 Cupercrew Xlt 4x2, 3.7l V6, Auto, Cloth, Pwr Equip, Cruise,clean 1 Owner on 2040-cars

Auto blog

VW going turbo-only in 3 to 4 years

This really was a matter of when, rather than if. Volkswagen will apparently be the first manufacturer to phase out naturally aspirated engines in favor of turbocharging its full slate. VW is kind of responsible for ushering in this push towards small-displacement, turbocharged engines that's taken the industry by storm. When it dropped its direct-injection, 2.0-liter turbo in the 2005 GTI it demonstrated that strapping an iron long to an engine can enhance the powertrain as a whole. VW made fuel economy gains, while also giving a linear, non-laggy turbo experience that it has replicated, model-after-model, to this day.
Speaking with The Detroit News, Volkswagen's executive Vice President of Group Quality, Marc Trahan, told the paper that, "We only have one normally aspirated gas engine, and when we go to the next generation vehicle that it's in, it will be replaced. So three, four years maximum."
Really, it's hard to get teary-eyed about either of these engines going away. VW has access to smaller powerplants that could easily match the performance of the 2.5 five-cylinder and the 3.6 V6, while gobbling up less fuel and providing a better driving experience. What we are sad about is that a similar statement about the extinction of NA engines came from the Vice President of Powertrain Engineering at Ford, Joe Bakaj. We'd certainly get teary-eyed over a world without Ford's excellent 5.0-liter V8.

Aluminum lightweighting does, in fact, save fuel

When the best-selling US truck sheds the equivalent weight of three football fullbacks by shifting to aluminum, folks start paying attention. Oak Ridge National Laboratory took a closer look at whether the reduced fuel consumption from a lighter aluminum body makes up for the fact that producing aluminum is far more energy intensive than steel. And the results of the study are pretty encouraging. In a nutshell, the energy needed to produce a vehicle's raw materials accounts for about 10 percent of a typical vehicle's carbon footprint during its total lifecycle, and that number is up from six percent because of advancements in fuel economy (fuel use is down to about 68 percent of total emissions from about 75 percent). Still, even with that higher material-extraction share, the fuel-efficiency gains from aluminum compared to steel will offset the additional vehicle-extraction energy in just 12,000 miles of driving, according to the study. That means that, from an environmental standpoint, aluminum vehicles are playing with the house's money after just one year on the road. Aluminum-sheet construction got topical real quickly earlier this year when Ford said the 2015 F-150 pickup truck would go to a 93-percent aluminum body construction. In addition to aluminum being less corrosive than steel, that change caused the F-150 to shed 700 pounds from its curb weight. And it looks like the Explorer and Expedition SUVs may go on an aluminum diet next. Take a look at SAE International's synopsis of the Oak Ridge Lab's study below. Life Cycle Energy and Environmental Assessment of Aluminum-Intensive Vehicle Design Advanced lightweight materials are increasingly being incorporated into new vehicle designs by automakers to enhance performance and assist in complying with increasing requirements of corporate average fuel economy standards. To assess the primary energy and carbon dioxide equivalent (CO2e) implications of vehicle designs utilizing these materials, this study examines the potential life cycle impacts of two lightweight material alternative vehicle designs, i.e., steel and aluminum of a typical passenger vehicle operated today in North America. LCA for three common alternative lightweight vehicle designs are evaluated: current production ("Baseline"), an advanced high strength steel and aluminum design ("LWSV"), and an aluminum-intensive design (AIV).

Chris Harris drives the 2015 Ford Mustang Over There

Ford makes some cars for America, and some cars for overseas. Sometimes those models cross over the ocean in one direction or another, but the Mustang has historically been a pony car meant for America. That all changes with the new model, though. It's not that Ford didn't design the new Mustang for American customers – it's just that it also refined it for markets overseas that aren't quite used to the live-axle brutality to which muscle car enthusiasts in the US have grown accustomed. Now that the Mustang is being offered in Europe – and in the UK with right-hand drive – it was only a matter of time before Chris Harris got his hands on one. And that's just what he's done for this latest video clip, taking a Mustang GT for a spin on both road and track in Wales. That's right, Harris is piloting the V8 model, not the EcoBoost four. So what does he think about an American expat shipped to the British isles? You'll want to watch the ten-minute clip yourself to gather his full impressions. But the long and short of it is that, while Harris doesn't think it's quite the match for something like a BMW M3, the Mustang doesn't cost anywhere near as much as the Bimmer. And that goes a long way, especially with all that rubber laid down on the track in the process.