2000 Ford Excursion Limited Sport Utility 4-door 5.4l-- 94k Miles on 2040-cars

Auto blog

NHTSA investigating 725k Ford, Mercury vehicles for stalling issue

Owners of Ford Escape, Mercury Mariner, Ford Fusion and Mercury Milan models, listen up. According to a report on Automotive News, the National Highway Traffic Safety Administration has opened an investigation into these four vehicles totaling an estimated 725,000 units. The investigation appears to center around a malfunctioning throttle body on non-hybrid models of the 2005-2012 Escape and 2011-2012 Fusion. With Mercury dying off after the 2011 model year, this probe will also apply to the 2005 through 2011 Mariner and the 2011 Milan. There has been some discussion around the Escape stalling issue for some time now, but this investigation appears to be larger in scope than before.
Though not a recall yet, NHTSA's Office of Defects Investigation (ODI) has received 123 complaints of stalling or surging vehicles, while Ford itself has logged 1,472 complaints. The investigation report, which is posted below, seems to indicate that a faulty circuit board for the throttle body could cause the vehicle to go into limp mode, which, according to NHTSA, could cause complaints of both stalling and surging.

Ford and Chrysler reducing summer plant shutdowns

Most domestic automaker assembly plants traditionally take a couple of weeks off during the summer. The shutdowns give each plant time for much needed repairs and maintenance, and in some cases, help better align production with demand. Not this year, though, as demand for many models is outstripping what Ford, Chrysler and General Motors plants can produce.
Ford has announced that it will shorten its annual summer shutdown for most North American plants from two weeks to one. The shorter shutdown will increase the carmaker's annual North American production by 40,000 units on top of the 200,000 extra units that it was already planning to produce this year versus last. Automotive News reports that Ford produced 2.8 million vehicles on this continent in 2012, and that output this year has already increased 13 percent through April.
Chrysler, meanwhile, is also operating at full tilt and plans to run some plants through the summer with no shutdown at all. Those not getting a break include Jefferson North where the Jeep Grand Cherokee and Dodge Durango are assembled, Toledo North that will assemble the new Cherokee, and Conner Avenue, home of SRT Viper production. Other assembly plants will be down for a single week, while all of Chrysler's engine and transmission plants except one in Indiana will continue operating with no shutdown this summer.

Ford Explorer, Expedition next to go aluminum?

Ford made some serious waves when it unveiled the latest F-150. Instead of making its bodywork out of steel, like just about every other truck on the market, Ford went with aluminum. And you can bet the F-150 won't be the last Ford model to go with the lightweight alloy construction, either.
Our compatriots at Edmunds report that Dearborn is considering replacing two of its most popular SUVs with aluminum versions. One candidate is the Expedition, which would make sense considering that the current model (like the two preceding generations and the fullsize Bronco before it) is based on the F-150's underpinnings. Another is the Explorer, which was traditionally based on the Ranger pickup but went with a car-like unibody chassis in its current iteration. If the Explorer does go the way of aluminum, don't expect it to be a part of its very next update, which is likely due too soon for such major changes.
It would stand to reason that, if the Expedition were to go aluminum, so would the next-generation Lincoln Navigator. Ditto the MKT together with the Explorer. But those aren't likely to be the only models in contention for aluminum construction. Like any other automaker, Ford is under pressure to steadily reduce its carbon emissions and improve its fuel economy figures, prompting it to look at a whole range of measures - including more efficient engines, lower rolling-resistance tires, active aerodynamics and lightweight construction. Expect aluminum to play a big part in that equation moving forward.