2008 Ford E150 Xlt E-series Van 8 Captain Chairs on 2040-cars

Auto blog

Ford recalls 83k Taurus and crossover models for halfshaft issue

Ford and the National Highway Traffic Safety Administration have issued a recall for some 83,250 vehicles in the US, for an issue with halfshafts. More specifically a "halfshaft retention circlip" might not have been properly installed on affected vehicles, with the result being halfshafts that may move improperly or disengage completely from the linkshaft while driving. The NHTSA release also notes that the issue may occur "without prior warning" which obviously factors in to the timeliness of getting this checked.
Should the halfshaft disengage, a few troubling things could happen. If it occurs while driving, power from the engine will no longer be transmitted to the wheels. And, if the vehicle is parked without the parking brake applied after disengagement of the circlip, vehicles may roll away even if they're transmissions have been placed in "Park."
Affected vehicles are as follows: Ford Edge and Lincoln MKX crossovers from model years 2012 to 2014; Ford Taurus and Lincoln MKS sedans from model years 2013 to 2014; Ford Flex and Lincoln MKT vehicles from model years 2013 to 2014.

Ford confirms 1.5-liter EcoBoost four-cylinder engine for 2014 Fusion

Earlier this week, reports were swirling 'round the internet about the 2014 Ford Fusion getting a new 1.5-liter three-cylinder EcoBoost engine. That was... half correct. Ford today confirmed that the 2014 Fusion is, in fact, getting a new 1.5-liter EcoBoost mill, but it has four cylinders, not three.
The new 1.5-liter engine will be the fifth EcoBoost powerplant from Ford Motor Company. Initially to be built at the automaker's Craiova, Romania plant, it will also be offered in the Fusion's twin, the Mondeo, in other markets. This engine will debut at the Shanghai Motor Show next month, and the 1.5-liter is of particular importance in the Chinese market - there is significant tax relief in the People's Republic for vehicles powered by engines with a capacity of 1.5 liters or less.
At a media briefing Thursday, Ford declined to divulge exact power or fuel economy numbers, though Joe Bakaj, vice president of powertrain engineering, told Autoblog that power output should be similar to that of the current 1.6-liter inline-four, and that overall efficiency will be "better than the 1.6." Our earlier report stated that the 1.5-liter four will produce 177 horsepower and 177 pound-feet of torque - losses of 1 hp and 7 lb-ft versus the 1.6-liter engine. Ford states that the 1.5-liter four will feature many of the same technologies used on the company's 1.0-liter EcoBoost inline-three, including an integrated exhaust manifold that recaptures much of the engine's heat.

Ford dealers offered discounts on tools to fix aluminum

With the introduction of the aluminum-bodied 2015 Ford F-150 (and the likely use of aluminum in future Ford products), Ford is looking to help its dealerships reduce costs related to repairing this more labor-intensive material. Automotive News is reporting that Ford dealers with body shops will require an estimated $30,000 to $50,000 in equipment and training to work on aluminum, and to help alleviate the financial burden of the new F-150, Ford has announced a special 20-percent discount on this equipment.
Dealers will be able to save up to $10,000 on tools such as welders, air-filtration systems and rivet guns and to create aluminum-specific work stations. The new F-150 goes on sale in the fourth quarter, and dealers have until October 31 to take advantage of this deal, according to the report.