2003 Dodge 3500 Series, Maxi Van, 1 Ton on 2040-cars

Auto blog

Viper ACR privateers' Nurburgring runs detailed in new documentary

Discontinued in the summer of 2017, the Dodge Viper is out of production, relegated to the hearts and garages of those who love it. But as a last hurrah, a crowdfunded privateer team took two Viper ACRs to the famous Nurburgring racetrack to both celebrate the Viper's existence and to try and lap the long Nordschleife track in under 7 minutes. Going after the fastest recorded production car lap, they gunned for the Lamborghini Huracan Performante's 6:52 time, but hot August temperatures caused tire problems and the Viper remained on the wrong side of 7 minutes despite the best efforts of ex-Porsche cup driver Lance David Arnold and SRT driver Dominik Farnbacher. In essence, the team ran factory-spec Viper ACR Extremes on factory tires; showroom fresh, the cars were delivered straight from Texas. But despite not getting under the 7-minute mark, they still became the first non-automaker-affiliated team to set an official Nurburgring lap time — and the 7:01.3 they laid down on their best run made the Viper ACR the fastest RWD, fastest manual and fastest American-built car on the track. Now, a full documentary of the record attempt has been released to the public, detailing all the pain and exhilaration that goes into running this kind of cars on their absolute limit on one of the most demanding racetracks in the world. It's 24 minutes of pure excellence. You can also re-view the record lap here in its entirety: This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings. Dodge Videos dodge viper acr

Fiat Chrysler Automobiles: The next five years

Unless you've been living under a rock for the past 24 hours, you've no doubt read about all of the big future product news coming out of Fiat Chrysler Automobiles today. We had individual brand reports from Chrysler, Dodge, Jeep, Ram, Alfa Romeo, Fiat, Maserati and even Ferrari, but in the interest of simplifying and summarizing, we're going to list out the hard facts once more. Of course, with all of this still off in the future, there's still the possibility that a few changes will be made. But as of what we know right now, here's what's coming, and what's going away.
Chrysler
2014: Refreshed 300/300C, debuting at Los Angeles Auto Show

Chrysler says its 8-speed transmissions will save 700 million gallons

Chrysler Group's TorqueFlite eight-speed transmission could be earning some serious green bragging rights if the company's projections are correct. The recently widely proliferated automatic gearbox, which is now in more than a million vehicles around the world, is poised to save drivers an estimated 700+ million gallons of fuel over the vehicles' lifetimes (an expected cost savings of $2.5 billion). In addition, Chrysler expects a reduction in CO2 emissions by more than six million metric tons. According to Chrysler, and depending on the vehicle, the TorqueFlite can improve fuel economy. The TorqueFlite autobox features particularly close ratios from fifth to eighth gear (see the press release below for the specific numbers), and uses low-viscosity fluid that doesn't need to be replaced. Transmission software adapts to the driving situation to optimize efficiency based on driver behavior, temperature, grade, stability control, and longitudinal and lateral acceleration. The TorqueFlite is capable of handling a variety of duties. As evidenced by the wide range of vehicles Chrysler Group has seen fit to equip with the eight-speed transmission, the TorqueFlite is capable of handling a variety of duties. Since its 2012 introduction, the TorqueFlite has gone from performing cog-swapping duties in Dodge Charger and Chrysler 300 models equipped with the 3.6-liter Pentastar V6 to changing gears in vehicles such as the Pentastar- and Hemi-powered Dodge Durango, Jeep Grand Cherokee and even the Ram 1500 EcoDiesel. For the 2015 model year, the eight-speed is finding its way into even more vehicles with the addition of a third version. In addition to the American-made TorqueFlite 845RE and 8HP70, the new 8HP90 will be manufactured in Saarbrucken, Germany. The 8HP90 is designed for higher torque loads, making it ideal for high-performance vehicles like the 2015 Dodge Challenger SRT Hellcat. The already-in-use 8HP70 will expand its duties to be used in 2015 Hemi models such as the Dodge Charger, Challenger, and Challenger SRT8. You can see the list of those benchmarks in Chrysler's press release below.