1989 Dodge 3/4 Ton Work Van...low Low Mileage!! on 2040-cars
Gadsden, Alabama, United States
Body Type:Van
Engine:V-8
Vehicle Title:Clear
Fuel Type:Gasoline
For Sale By:Private Seller
Exterior Color: White
Make: Dodge
Interior Color: Blue
Model: Ram Van
Trim: 3/4 Ton
Drive Type: 2 wd
Mileage: 21,800
This a great running and driving van that would make a great work vehicle. I bought this from the Federal Government where it was used at a golf course on an Air Force Base. The Manager of the Golf Course told me that the mileage was correct and it was just driven around the Base most of it's life.
-When I went to pick it up, it had not been started in almost a year. The Manager hooked up; a jumper box and it started right up with no unusual noises and no smoke.
The Good:
-New battery
-New electric fuel pump
-Runs and drives great
-Exhaust quiet
-Tires good
-No rust or body damage
-Ready toi drive anywhere
The Bad:
-Driver door hinge has some play in it
-A/C needs charged
Dodge Ram Van for Sale
- 2001 dodge ram 3500 2500 14 passenger high top van shuttle bus only 55k miles!!!
- 2003 dodge ram 2500 slt 4x4 quad cab, custom paint, hemi, super sharp in & out(US $11,995.00)
- Great shape dodge conversion van-only 65,000 mile in great shape
- 2000 dodge ram 3500 - 12 passenger van!
- 1997 dodge ram van 1500 3.9l v6
- Dodge ram van custom camper style with 114,000 orignal miles
Auto Services in Alabama
Tire City & Automotive Service ★★★★★
Tint Spectrum ★★★★★
Southern Armature Works Inc ★★★★★
Shorty`s Car Care ★★★★★
Pruitt Radiator & Auto Repair ★★★★★
Premier Truck Centers ★★★★★
Auto blog
Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut
Mon, 08 Oct 2012Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.
Diesel Power finds the ultimate modified oil-burner
Sat, 24 Aug 2013For nine years, Diesel Power magazine has run the Diesel Power Challenge, this year's grindfest being "a week-long torture test that features seven events, nine trucks, 8,000 horsepower, and nearly 15,000 pound-feet of torque." The road to being crowned "the most powerful truck" starts with a dyno run, and then continues through the completion of a CDL-style obstacle course, an eighth-of-a-mile drag race while towing a 10,000-pound trailer, a quarter-mile drag race without a trailer, a fuel economy test in the mountains and finally a sled-pulling test through a 300-foot-long packed-mud pit.
What kind of trucks get into such a fight? Last year's winner, for instance - who upgraded his truck this year to prove he didn't "luck into the win" - drives a 2008 Ford F-250 Super Duty with a 6.4-liter Power Stroke V8 upgraded with a custom intake, Elite Diesel triple turbos and a two-stage nitrous system. Another competitor has a 2005 Dodge Ram 2500 powered by a 5.9-liter Cummins inline-six, upgraded with Garrett turbos, dual-stage nitrous, a seven-inch exhaust stack and twin fans built into the bed to cool the Sun Coast Omega transmission. The numbers on that truck: 1,255 horsepower, and 2,063 pound-feet of torque at the wheels. Naturally, as the image above might suggest, things don't always end well.
You'll find all five videos covering this years challenge below. A scene in the dyno video sums it all up perfectly: a competitor leaves his nitrous on too long and the crew is treated to some ominous poppings, he leans out the window, throws both hands up and shouts, "Amer'ca!"
Dodge Scat Pack for 5.7L Hemi V8 detailed, priced
Sat, 05 Apr 2014Dodge revived the Scat Pack name back in November at the 2013 SEMA show. At the time, though, we were short of details on forthcoming upgrade packages, which were destined to add some oomph to the Challenger, Charger and Dart. We're still waiting to hear about the upgrades to the Dart's 2.4-liter four-pot, but Dodge has gone ahead and released the details on the upgrades to the 5.7-liter Hemi V8 in the Challenger and Charger R/T.
As we detailed in our original post, three different Scat Packs will be available that will allow customers to upgrade their cars without voiding the warranties. Starting with the $2,195 Stage 1 kit, owners will net an extra 18 horsepower and 18 pound-feet of torque thanks to a Mopar-branded cold-air intake, exhaust and ECU ref lash. Stage 1 is also the only package that could be installed outside of a Chrysler-authorized service center without voiding the warranty (a mechanically competent owner could even do it at home, we're told by Dodge). Stage 2 builds on the entry level Scat Pack, and adds performance camshaft kit, which boosts output over the stock 5.7 by up to 30 hp for $1,895. As with the Stage 1, the ECU is tweaked.
For those that want to go whole hog, they can add the Stage 3 for $4,995. The top-tier gets quite serious, adding CNC-ported cylinder heads, as well as high-flow headers and cats. Output over stock is 58 hp and 47 lb-ft of torque. Each kit comes with a pair of badges, just in case owners want a bit of visual flair.