2010 Sxt 3.5l Auto Brilliant Black Crystal Awd on 2040-cars

Auto blog

2014 Challenger R/T Shaker, Mopar '14 Challenger bring back iconic hood

Enamored of the Dodge Challenger but wish you could get one with a shaker hood? We've got good news, because Dodge and Mopar have teamed up to bring it back.
The 2014 Dodge Challenger R/T Shaker packs the same 5.7-liter Hemi V8 as the standard Challenger R/T, but upgrades the business end with a through-the-hood exposed cold-air intake system. The retro hood scoop protrudes from the center of the hood in satin black (matching the decklid spoiler) to feed the Hemi and shakes with the engine just like the original from 1970. The Shaker model also comes with a Super Track Pak that adds a new steering rack, brake linings, shocks and 20-inch Goodyear Eagle F1 Super Car rubber. You can also shut off the stability management system completely in this car. A series of interior and exterior trim enhancements round out the look. The whole package adds $2,500 to the price of a Challenger R/T Classic for an all-in MSRP of $36,995.
In case that's not enough, Dodge is also offering a limited-edition Mopar Challenger that follows the 2010 Mopar Challenger, 2011 Mopar Charger, 2012 Mopar 300 and 2013 Mopar Dart. Limited to just 100 examples, the 2014 Mopar Challenger gets the same Shaker hood intake, unique graphics and wheels, an enhanced interior and a long list of optional extras from the Mopar parts catalog. Dodge isn't saying just yet how much the Mopar Challenger will cost, but you can bet it will command a considerable premium for the exclusivity alone.

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.

2015 Dodge Viper getting small increase in power

The Viper is used to being the most powerful car in the Dodge and SRT stables, but the arrival of the 2015 Dodge Challenger SRT Hellcat means that's no longer the case. The serpentine supercar is, however, reportedly getting a small boost in output for 2015, amounting to all of five horsepower.
The increase was uncovered by Road & Track courtesy of the SAE J1349 certification process to which Detroit's Big Three automakers submit themselves and which reports the Viper's output at 645 hp instead of the 640 it was rated at until now. There are a hundred factors that could have contributed to the relatively mild boost in output (best guess? nothing at all changed...), but we doubt anyone's going to complain about some extra horses under the hood.
The five-horsepower boost brings the Viper that much closer to the 650-hp Chevy Corvette Z06, not to mention the 707-hp Hellcat, but the Viper's impressive power-to-weight ratio ought to mean it'll have little problem keeping up in a straight line - which is just one of the reasons why Chrysler won't shoe-horn the Hellcat into the Viper: as R&T points out, the supercharged engine is too heavy and the blower makes it too tall to fit in the Viper's engine bay.