We Finance 02 4x4 Magnum Cd Stereo 3rd Row Side Steps Power Seat Keyless Entry on 2040-cars

Auto blog

500+ hp Stellantis 'Hurricane' I6 previews a world without Hemis

After years of rumored development, Stellantis has revealed its new six-cylinder engine family. The 3.0-liter, twin-turbocharged "Hurricane" I6 will offer V8 power, forced induction torque and six-cylinder efficiency in a package designed to fit into any of the company's North American rear-wheel-drive platforms.  What is "V8 power," exactly? Well, in standard output guise, the new I6 cranks out more than 400 horsepower (the specific figure will vary by application) and 450 pound-feet of torque, while the high-output variant is good for more than 500 horses and 475 lb-ft. The final figures will be dependent on the application. We'll save you a little legwork: In current Ram, Jeep and Dodge products, the 5.7-liter Hemi tops out at about 395 hp and 410 lb-ft, give or take, and the 6.4-liter around 485 hp and 475 lb-ft.    This is a clean-sheet design that is only related to the company's turbocharged four-cylinder by some common measurements. The I6 is exclusively direct-injection (no hybrid/port-injection here) and the two I6 variants share 96 common parts, including the block and oil pan design. The differences are found in their internals, intake plumbing, valvetrain components and the turbochargers themselves. Stellantis is not yet ready to share specs or supplier info for the turbos but says announcements will come from its partners soon.  The standard-output I6 has a compression ratio of 10.4:1 and revs to 5,800 rpm. It will run on regular fuel, albeit with reduced performance; 91 octane is recommended for maximum output. The high-output variant has a compression ratio of 9.4:1 and will rev to 6,100 rpm. That one will require premium. The new I6's advantages go beyond basic power output. Every Hemi family engine currently in production is based on an iron block design, so they're heavy. The aluminum-block I6 shaves weight off the total engine package, even if some of that gets added back thanks to the turbos and their associated plumbing. The standard-output I6 weighs 430 pounds, Stellantis engineers told us; the high-output adds just another 11. Fully dressed 5.7-liter V8s are in the 550-560-pound ballpark, and 6.4-liters close in on 600 pounds.  You may be wondering, "Why a clean-sheet gasoline engine now, when the industry is moving toward battery-electrics?" A valid inquiry, and one Stellantis was prepared to address. While the company will be pivoting to electrification over the next decade, it won't be instantaneous.

The Dodge Challenger plays its trump card: all-wheel drive

Perennially stuck in third place behind the Ford Mustang and Chevy Camaro in sales and enthusiast comparisons, the Dodge Challenger is doing something unconventional for a muscle couple. It's adding all-wheel drive. It's a new feature for Detroit's pony cars – none of the three have ever had it – and it could be a game-changer. Called the Challenger GT, the Dodge launches this winter for a starting price of $34,490. The Challenger GT comes with the Pentastar 3.6-liter V6 rated at 305 horsepower and 268 pound-feet of torque. It teams with an eight-speed TorqueFlight automatic transmission and is estimated to get 18 miles per gallon in the city and 27 mpg on the highway. An FCA spokesperson said no manual transmission or V8 models will be offered on the all-wheel-drive Challenger. It will be on display in January at the Detroit auto show. View 8 Photos All-wheel drive is a widely expected addition for the Challenger. The coupe shares underpinnings with the four-door Charger, which offers an all-wheel drive variant and the cars have similar powertrain offerings (the AWD Charger is also V6 and automatic only). Naturally, the Challenger borrows the Charger's AWD system and during regular driving conditions, the front axle disengages and full torque goes to the back wheels, allowing the Challenger to function as a rear-wheel drive car. It automatically goes back to AWD when more traction is needed. Handling is also fortified with a vehicle dynamic control system. Conversely, the electronic stability control has three modes and can be switched off for drift-happy enthusiasts. The GT has features familiar to other Challenger and Dodge owners, including an 8.4-inch touchscreen radio, Performance Pages (accessible through the Super Trak Pack button), and paddle shifters. A Sport Mode changes shift points to improve acceleration. It all rolls on 19-inch wheels wrapped in all-season rubber. The exterior gets a hood bulge, LED head- and taillights, and a decklid spoiler. The Challenger GT also offers a $995-interior package different than RWD models, adding Nappa leather, Alcantara suede seats, a nine-speaker Alpine audio system, performance steering wheel, and more. All of that is just window dressing. It's all-wheel drive that could be a difference-maker for consumers. The Challenger won't likely be able to take down the Mustang, which will finish 2016 as the pony car sales king.

Fiat Chrysler CEO says final merger talks with Peugeot going well

BRUSSELS — Fiat Chrysler's chief executive Michael Manley said on Wednesday that merger talks with Peugeot owner PSA  to create the world's No. 4 carmaker are progressing well and he hopes to have a deal within 12-14 months. Speaking to Reuters on the sidelines of an industry meeting, he said he doesn't expect any major obstacles that could delay a final agreement. "Talks are progressing really well," Manley said about negotiations with the French carmaker ahead of a briefing by the European automotive association (ACEA), of which he is president. His comments come a month after the two carmakers agreed to a binding deal worth about $50 billion to combine forces in response to a slowdown in global demand and mounting costs of making cleaner vehicles amid tighter emissions regulations. Manley's timeline for completing the deal by early 2021 is in line with a forecast made by the companies in December. Fiat and Peugeot are now getting into the details of how the merger will work, including choosing which vehicle platforms — the technological underpinnings of a vehicle — will fit which products in a combined company. Because customers in different locations still prefer vastly different cars, there is room for multiple platforms in a combined group, Manley said. "That global platform is an elusive beast," he added. "This concept of a massive global platform in my mind is almost a myth, but that doesnÂ’t mean to say weÂ’re not going to recruit significant volume." Related Video: