1968 Dodge Coronet Superbee on 2040-cars

Auto blog

Dodge revives Challenger T/A and Charger Daytona trims for 2017

Dodge is reviving the Challenger's T/A trim and the Charger's Daytona line for 2017. Introduced on iconic Woodward Avenue just days before the annual Woodward Dream Cruise kicks off, the new variants promise more performance hardware and sportier aesthetics. We'll start with the two-door. The Challenger T/A, available with either the R/T trim's 5.7-liter V8 or the fire-breathing 6.4-liter Hemi V8, is inspired by the Challenger T/As of old. That means a less restrictive, 2.75-inch active exhaust system and a conical Mopar air filter. But there's no clear bump in output – Dodge still lists the base 5.7-liter at 375 horsepower and the 6.4-liter model at 485 hp. But hey, they're going to look cooler. Unlike the Challenger Hellcat, which should have it as standard, Dodge is including a Satin Black hood on every Challenger T/A. In fact, Satin Black is a recurring theme on this Challenger's front fascia, roof, rear decklid, and T/A bodyside stripes. And yes, the 20-inch Mopar wheels are black, too – they're also an inch wider than normal. Dodge is offering the T/A in three different trims. The base T/A has everything we described above, while the T/A Plus adds some comfort features like heated and vented Nappa leather seats, an 8.4-inch UConnect system with Apple CarPlay/Android Auto, a six-speaker stereo, and a shortcut button for the Dodge Performance Pages. The T/A 392, meanwhile, adds the 6.4-liter V8, even wider wheels, and Brembo six-pot calipers. If you prefer smoking tires with four doors, there's the new Charger Daytona. No, there's not an enormous wing on the back. But Dodge added the same kind of engine/exhaust upgrades found on the T/A while upping the top speed from 135 to 150 miles per hour. Satin Black features prominently again, with hood and rear fender graphics. The roof is also black. Unlike the Challenger, Dodge is only offering two different versions of the Daytona – the 5.7-liter base model and the 6.4-liter version, called the Daytona 392. Prices for the Challenger T/A start at $38,485, including a $1,095-destination charge, while the T/A Plus adds $2,750. Adding the 392 means shelling out $45,090. For the Daytona, you'll need a check for $40,985 for the 5.7-liter or $46,090 for the 6.4-liter. Orders for the Charger Daytona open in September, while the T/A is a month later. Related Video:

Junkyard Gem: 1987 Dodge Ram 50 with V8 swap

Chrysler did very well selling Mitsubishi Forte pickups with Plymouth and Dodge badging in the United States, even after Mitsubishi began moving the same trucks out of their own American dealerships in 1982. The 1987 Ram 50 2WD short bed weighed in at just over 2,500 pounds, so it was reasonably perky with its 2.0-liter G63B four-banger making 90 horsepower… but there's no replacement for displacement! At some point along the line, a Chrysler small-block V8 engine found its way into the engine compartment of this truck, now residing in a car graveyard in Sparks, Nevada. This was the cheapest new Dodge-branded pickup Americans could buy as a 1987 model, though it had to compete with its near-identical Mitsubishi Mighty Max twin for sales. The 1980s were great times for little pickups in the United States, but a desire for bigger cabs and more creature comforts doomed them by the dawn of the following decade. The most interesting thing about this engine swap is that it didn't involve a Chevrolet or Ford small-block V8. Both the Chevy small-block and Ford Windsor V8s are a few inches narrower than the Chrysler LA-series V8, which makes them easier to stuff into a small vehicle. It appears that engine length was the critical dimension in this case, since the Mopar seems to have had enough side-to-side clearance to avoid any slicing of Mitsubishi steel to make it fit. My guess is that whoever did the swap happened to have the engine handy and that's why it's here. Keeping it all Dodge might have been a factor in the decision as well, though the truck's Mitsubishi ancestry makes that unlikely. It was over 100°F out when I found this truck, so I wasn't motivated to check block casting numbers to determine exactly which LA engine we're dealing with here. The easiest LAs to get cheap for the last four or so decades have been the 318 (5.1-liter) and the 360 (5.8-liter), so one of those two is the most likely candidate here. Power levels for these engines got pretty dismal during the Malaise Era, but anyone with the wrenching skills to do this swap would have applied some basic power-enhancing wizardry before the engine went in. We can see there's an Edelbrock Performer intake manifold, and you might as well stab in a better camshaft if you're upgrading the intake. How much power? With a four-barrel carburetor on a dual-plane intake plus a meaner cam, 300 to 350 horsepower is easily achieved with one of these engines, even with stock exhaust manifolds.

Subaru Legacy pitted against Roadkill project cars

There's an evergreen debate among auto enthusiasts about whether they would prefer to have the latest and greatest car of today or a certified classic from yesteryear. What if you had to further define that, though, and the choice was between a brand new 2015 Subaru Legacy or a turbocharged Datsun 240Z with a hatch that wouldn't close? Roadkill aimed to find out that and more in one of its best videos to date.
According to the hosts, Subaru came to them, handed over some money and challenged Roadkill's project cars against its latest Legacy. The result is every bit as good (or better) than any automotive-themed show you could find on television.
Things start simple with a figure-eight race in a rodeo arena with the Subaru taking on Roadkill's 1968 Ford Ranchero, originally built for ice racing. From there the Legacy races a 1968 Dodge Charger with no windows around and off-road rally stage. Finally, the Subie goes head-to-head against the Rotsun, the aforementioned turbocharged 240Z, through an abandoned neighborhood. Plus, there's a bonus drag race challenging them all.