2013 Dodge Avenger Sxt on 2040-cars

Auto blog

2021 Dodge Charger SRT Hellcat Redeye Widebody: Bring your friends on a 797-hp thrill ride

For a couple years now, if you wanted the ultimate in Dodge performance, your only option was the Dodge Challenger SRT Hellcat Redeye. The 797-horsepower engine was exclusive to it and its widened body, and if you needed four-doors, you were out of luck. But following the addition of a widebody Charger, the company has finally seen fit to create the 2021 Dodge Charger SRT Hellcat Redeye, complete with the monster Hemi. Unsurprisingly, the addition of 90 extra horsepower makes the Charger Redeye significantly quicker than the standard Hellcat. On a 2.1-mile road course Dodge tested at, the Redeye lapped 1.2 seconds faster than the regular car. The Redeye also finishes the quarter-mile in 10.6 seconds, close to 0.4 second faster than the standard Hellcat Widebody. Top speed also increases from 196 mph to 203 mph. Visually, there are a few subtle cues that distinguish the Redeye from the Hellcat Widebody. It of course gets Hellcat badges with red eyes, but it also gets a unique hood. The hood, in combination with the Widebody front fascia and a special air intake opening near the wheel liner give the Redeye the maximum amount of air flow to the engine bay of any Charger variant. While the big news is the Redeye coming to the Charger, prospective Hellcat buyers have some good news, too. All 2021 Hellcats pick up 10 horsepower for 717 total. This matches the limited-edition Charger Hellcat Widebody Daytona 50th Anniversary Edition. So even if you can't reach a Redeye, the regular Hellcat will be even more potent than before. Pricing for the new Redeye has not yet been announced. Dealers will be able to start ordering 2021 Chargers this fall, so we should have pricing around that time. Cars should begin arriving at lots in early 2021. Related Video:    

A look at the Dodge Demon's drag settings, modes, and go-fast tech

In the same video that gave us a peek at the 2018 Dodge Challenger SRT Demon's performance stats, there's a serious dump of info on the tech and tools that will likely help this muscle coupe slaughter drag strips. Dodge has outlined a few of them for us and we're using the power of inference to figure out the rest. Here's what we've gathered. A lot of these hints come from the Demon's version of Performance Pages, the infotainment screens that show what SRT models are doing and let the driver change the powertrain and chassis setup. There are a lot of Demon-only features, including line lock, a quick cooldown mode for the supercharged engine, and data recording. And of course there are pages to show a digital time slip with acceleration and braking figures, a g-load plot, and lots of gauges to track temps and levels. The engine output is shown in the video on a special Dyno page. It tracks horsepower and torque over time on the upper graph, and engine rpm and shift points on the lower graph. And we think it's still hiding something. This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings. Any good drag car has a line lock, allowing the driver to lock the front brakes and leave the rears free to do a nice tire-warming (or tire-shredding, depending on length) burnout. Ford has it on the Mustang, Chevy puts it on the ZL1, and now Dodge is adding it to the Demon. It should help get the giant Nitto tires up to temp for a drag run. And once the tires are warm, there's launch control, just like on the SRT Hellcat, with selectable rpm to dial things in for the conditions. The Demon also has a shift light in the cluster, and the driver can set a shift point individually for each gear. After each drag run, you can activate Quick Cooldown, which Dodge says uses the first production application of After-Run Chiller – it runs the cooling fan and intercooler coolant pump with the engine off until the coolant reaches its target temp. It's shown in one of the slides above. The checklist on the left side of that page suggests it requires a set of conditions be met to work: engine off, hood open, and sufficient battery level. This further reinforces our theory that the supercharger is going to make big boost, beyond the Hellcat's 11.6 psi. And while you're waiting for the supercharger to cool off for another run, you can review the performance data the car records.

Junkyard Gem: 1986 Dodge Ram 50

After years of selling the Isuzu Faster with Chevrolet LUV badges here, GM replaced it with the S-10 in 1982. Ford sold Mazda Proceeds with Courier badges for even more years, but ditched the Courier once the Ranger became available as a 1983 model. Chrysler was able to put truck beds on Omnirizons at that time, but didn't have the deep pockets to develop its own rear-wheel-drive small pickup; for this reason, Dodge-badged Mitsubishi Forte pickups continued to be available in the United States all the way through the 1994 model year. Here's one of those trucks, found in a Colorado car graveyard. The first Chrysler-imported Mitsubishi Fortes showed up in the United States as 1979 models. The Dodge-badged version was known as the D-50, while Plymouth dealers got theirs with Arrow badges. The Dodge D-50 became the Ram 50 for the 1981 model year, while the final Plymouth Arrow trucks were sold as 1982 models. Just to make things more interesting, Mitsubishi started selling its own vehicles in the United States beginning with the 1983 model year. That meant that the Ram 50 had to compete for sales with a near-identical twin sporting Mitsubishi badges. Things in the Chrysler-Mitsubishi universe got even more exciting a bit later, when there were four marques selling essentially the same car here simultaneously: the Mitsubishi Mirage, Plymouth Colt, Dodge Colt and Eagle Summit. All of the Dodge D-50s and Ram 50s came with Mitsubishi power under their hoods. This one has a 2.0-liter SOHC straight-four rated at 88 horsepower and 108 pound-feet. For a while, a 2.3-liter Mitsubishi diesel was available in the Ram 50. It had been discontinued by 1986, however. This one has the base five-speed manual transmission. It appears that this truck was being used for long-term storage of many, many boxes of random household stuff when it was banished to this place. Much of the stuff was scattered on the ground nearby. Perhaps it was parked at a rent-a-storage facility and got evicted for lack of rent payments. Much of the contents consisted of stacks of newspapers and magazines from the 1960s and 1970s. Here's an Art Buchwald column about then-Vice President Spiro Agnew from February 23, 1971. Here's a Beetle Bailey strip from the same year. There's plenty of history in the junkyard, if you know where to look. There must have been a half-ton of paper in this truck when it arrived here. Sadly, some family's photo albums were here as well.