2006 Silverado 2500 Regular Cab 4x2!flatbed W/litegate on 2040-cars

Auto blog

Recharge Wrap-up: Chevy hits CO2 goal, eVgo and BMW build fast charging

Chevrolet has met its goal of preventing 8 million metric tons of CO2 emissions over the last five years. Through its community-based carbon reduction initiative, Chevy invested $40 million and took part in 38 different projects in 29 different states. The projects included supporting wind farms, powering a hospital with landfill gas, helping truckers reduce their idle time and helping create the ongoing #CleanEnergyU dialogue between students and clean energy leaders. In the end, Chevy retired all its carbon credits rather then spending them to offset its own emissions. Read more from Chevrolet. NRG eVgo and BMW are partnering to add DC Fast Combo charging to locations around the country. Over the next two years, the groups will bring hundreds of the 50-kW chargers to 25 cities, with 24 of those markets getting at least one installed by the end of 2015. "eVgo will add reliable DC Fast Combo capability to what is already America's largest DC Fast charging network," says eVgo President and CEO Arun Banskota. "This will be the fastest and most cost effective build out of a new network ever – thanks in large part to our existing infrastructure and committed retail host partners." Read more in the press release from eVgo. The EPA has settled with a Utah gasoline refiner over Clean Air Act violations. The HollyFrontier Corporation subsidiaries will pay $1.2 million for producing about 42 million gallons of gas that didn't adhere to Reid Vapor Pressure standards, resulting in 10 excess tons of volatile organic compound emissions. Its Salt Lake City refinery will also implement a program to offset past emissions. "This agreement will benefit public health by requiring retrofits of storage tanks at HollyFrontier facilities that will reduce volatile organic compound emissions and use next generation technology to verify these reductions," says Assistant Attorney General John Cruden. "This settlement shows that fuel refiners can and must meet the nation's standards for controlling the emissions that cause ground level ozone and serious health problems for Americans." Read more in the press release below. U.S. Settles with Gasoline Refiner to Reduce Emissions at Utah Facility WASHINGTON -- The U.S.

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

2014 Chevrolet Corvette C7 Convertible offers a few more views before reveal

Over the weekend, Chevrolet released its first images of the new 2014 Corvette Stingray Convertible. Now, ahead of the droptop's official introduction tomorrow at the Geneva Motor Show, the automaker has given us a few more shots of the softop C7 showing off the car's rump albeit from a high, strategically positioned angle.
From this angle, it's hard to get a sense for how long and flat the decklid really is, but we can easily see that, like the rest of the C7's design, the new convertible's decklid and tonneau cover are far more detailed than the current car. We also get a better look at the rear haunches sans brake vents, which have apparently been moved to underneath the car in order to accommodate the top's hard cover.
As for the overall styling of the C7 convertible, with the top erected, we get some idea of what a coupe design (as opposed to the Stingray's fastback shape) would look like on this car. The C5 Corvette most recently had a coupe model that did away with the large glass hatchback, and we recently reported on a low-cost "coupe" model potentially being added to the C7's repertoire.