Posi Rear End Sbc 350 Chevy El Camino on 2040-cars
Kent, Washington, United States
|
1967 el camino has rust on body and hood posi rear end sbc 350 drum brakes runs really good.. I can e mail more pictures and information.. buyer is responsible for shipping...
On May-03-14 at 09:14:22 PDT, seller added the following information: 1967 chevy el camino sbc 350 posi rear end.. has some rust on body and hood.. for more information and pictures text or call 5032587543 |
Chevrolet El Camino for Sale
1967 chevrolet el camino base standard cab pickup 2-door 5.3l(US $7,000.00)
1959 fully restored chevrolet el camino
327 ss great project car, all parts for restore
1982 gmc caballero amarillo standard cab pickup 2-door 4.4l
1977 chevrolet el camino classic-103k actual miles-runs like new!(US $2,000.00)
4 spd trany, engine redone 500hp, good project car
Auto Services in Washington
Womack Auto Body Inc ★★★★★
Trusted Choice Auto Care ★★★★★
Tire Store ★★★★★
Thurston County Transmission ★★★★★
Thunderbird Vintage ★★★★★
Taskar Garage ★★★★★
Auto blog
2015 Chevy Spark will have lighter, smaller battery
Thu, May 15 2014As General Motors gets ready to release the 2015 Chevy Spark EV, it is retooling the Brownstown Battery Assembly to build a new battery system for the chirpy little electric car. The new Spark will lose a few pounds and kWh from its lithium-ion pack, but it will keep all of it's performance specs. The current Spark EV uses a 21-kWh lithium-ion battery pack with bits made by A123 Systems (known as B456 Systems during bankruptcy). For the 2015 model, GM is going to build a 19-kWh battery system in-house that will use 192 LG Chem cells. Losing a bit of energy capacity means that the battery system for the 2015 Spark EV will be 86 pounds lighter but it will keep the EPA-rated 82-mile range and 119 MPGe. The 2015 Spark EV also keeps its $26,685 (plus destination) starting price from the 2014 model. The car will once again qualify for a federal tax credit of up to $7,500. LG Chem also supplies the cells for GM's other plug-in vehicles from its facility in Western Michigan. The Brownstown production line currently builds the battery packs for the Chevy Volt, the Opel Ampera and the Cadillac ELR. You can read our first drive of the 2014 Chevy Spark here. Brownstown Battery Assembly Expands Capabilities Will build battery system for 2015 Chevrolet Spark EV 2014-05-14 DETROIT – General Motors will bring all its electric vehicle battery building capabilities in-house with production of battery systems for the 2015 Chevrolet Spark EV at its battery assembly plant in Brownstown, Mich. "Using our in-house engineering and manufacturing expertise enabled us to deliver a battery system that is more efficient and lighter than the 2014 Spark EV without sacrificing range," said Larry Nitz, executive director of GM global transmission and electrification engineering. "Our successful working relationship with LG Chem has allowed us to deliver a new battery system for the Spark EV that helps us to better leverage our economies of scale." A newly designed battery system features an overall storage capacity of 19 kWh and uses 192 lithium ion cells. The cells are produced at LG Chem's plant in Holland, Mich. The battery system weight of 474 lbs. is 86 pounds lighter than the system in the 2014 Spark EV. The Spark EV battery is built on a dedicated production line at Brownstown, which also manufactures complete battery packs for the Chevrolet Volt, Opel Ampera and Cadillac ELR.
Next-gen Chevy Silverado and GMC Sierra may use carbon fiber
Thu, Dec 7 2017It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck
Chevy Bolt name just might get through US trademark office
Sat, May 30 2015UPDATE: GM told AutoblogGreen on June 1 that, "Our Chevrolet Legal team has been working closely with the USPT on the Chevrolet Bolt trademark. As of last week, our legal staff received consent from Yamaha to use the Bolt name. According to our legal team, our USPT application is back to active status." Also, it appears that GM has further trademarked Bolt EV and Chevrolet Bolt EV. Chevy wants to sell a 200-mile electric vehicle for around $35,000 in a few years. The Detroit automaker wants to call that car the Bolt, not to be confused with the company's other plug-in, the Chevy Volt. Unless something changes, the United States Patent and Trademark Office (USPTO) is going to crush GM's Bolt-flavored dreams. The USPTO has suspended GM's trademark application. The USPTO said in its suspension that there was a "likelihood of confusion" with another Bolt trademark, No. 4429759, which applies to a Bolt trademark filed by Yamaha on August 09, 2012. That's well before GM's effort to trademark the Bolt name in 2014. GM's application will remain suspended, the USPTO said, "until the earlier-filed referenced application(s) is either registered or abandoned." Maybe GM will use this setback to respond to the many criticisms of the Bolt name we've heard since it was first announced. There is another page on the USPTO's website that says GM's Bolt application is still live, but we assume that just hasn't been updated yet. Related Video:













