Chevrolet: Corvette Convertible on 2040-cars

Auto blog

Experimental mid-engine XP-819 Corvette going up for auction

It seems to be commonplace that when a new Corvette is in development, rumors swirl about a possible mid-engine layout. As is the case of Chevy's most recent C7 Corvette, these rumors never pan out.
In any case, the idea for a 'Vette with an engine mounted behind the driver can probably all be traced back to a single car, the 1964 XP-819 prototype. Built as an "engineering exercise" back in 1964, the prototype was designed with a rear-mounted engine. History tells us that the idea of a rear-engine Corvette fizzled, and the XP-819 was eventually cut up into pieces and stored at a shop in Daytona Beach, FL.
After sitting for untold years, a restoration project started on the car, and while it isn't yet fully completed, the current owner of the car, Mid America Motorworks, will have the car on display at the 2013 Amelia Island Concours d'Elegance as a "driveable chassis" with hopes of having a fully completed car ready to bring to next year's show.

Sunday Drive: Trucks and SUVs of all shapes and sizes

The American automotive marketplace is dominated by trucks and SUVs, and so was the last week of coverage on Autoblog. By far, the most popular story of the week was our First Drive of the 2018 Lincoln Navigator. It may look like an old-school lumberer, but in reality Lincoln's flagship is a thoroughly modern, turbocharged-V6-powered, three-row, luxury people mover. The Jeep Wrangler is the world's most recognizable vehicle. So it's no surprise that the next version looks a whole heck of a lot like the last one, and the one before. It's all in the details, which is why we were so excited when Jeep decided to unleash a trio of images showing both two- and four-door Wranglers for us to dissect ahead of the SUV's official debut at the L.A. Auto Show later this year. Past that, spy photos of the next Chevy Silverado and Ram 1500 were predictably popular. See both of those below, and the cap it all off, check out the entire week's worth of SEMA coverage – including the bonkers Hennessey VelociRaptor 6x6 – in our mega image gallery at the bottom of this post. Enjoy! As always, tune in to Autoblog next week for a front-row seat to all the happenings worth following in the automotive industry. 2018 Lincoln Navigator First Drive | From black sheep to flagship 2018 Jeep Wrangler revealed: First photos released before L.A. Auto Show debut 2019 Chevy Silverado looks slim and clean beneath the camo 2019 Ram 1500 gets vertical touchscreen infotainment system 2017 SEMA Show Mega Photo Gallery Chevrolet Jeep Lincoln RAM Truck SUV recap sunday drive

GM recalls 8,500 Chevrolet Malibu models for rear suspension glitch

According to a letter from General Motors to the National Highway Traffic Safety Administration, flaws in the build process of the 2013 Chevrolet Malibu have led to the recall of 8,519 cars. Units built between December 6, 2011 and January 15, 2013 may have been assembled with rear suspension cradles that had insufficient torque applied to certain bolts. That out-of-spec assembly could lead to issues ranging from slight noises to a loss of vehicle control.
The problem was first noticed in December of last year by a GM test fleet driver and eventually tracked back to the improperly torqued bolts on the suspension cradle assembled through July 2012 by a supplier located not too far from the Malibu's Detroit/Hamtramck Assembly Plant. Since an official NHTSA recall notice has not been issued yet, it isn't clear whether or not Detroit-built Malibus were the only ones affected (the 2013 Malibu is also built at GM's Fairfax Assembly Plant in Kansas City, Kansas). Dealers will fix the problem by inspecting vehicles for proper torque specs, retightening if not within specs and, in some cases, perform a rear-wheel alignment.