Find or Sell Used Cars, Trucks, and SUVs in USA

1972 Chevy Chevelle, #'s Matching 350, Very Solid, Auto, Runs Great, Disc Brakes on 2040-cars

Year:1972 Mileage:67000 Color: Black /
 Black
Location:

Creswell, Oregon, United States

Creswell, Oregon, United States
Transmission:Automatic
Body Type:Coupe
Engine:350
Vehicle Title:Clear
Fuel Type:Gasoline
For Sale By:Private Seller
VIN: 1d37j2l517233 Year: 1972
Interior Color: Black
Make: Chevrolet
Number of Cylinders: 8
Model: Chevelle
Trim: 2-Door
Drive Type: RWD
Mileage: 67,000
Exterior Color: Black
Condition: Used: A vehicle is considered used if it has been registered and issued a title. Used vehicles have had at least one previous owner. The condition of the exterior, interior and engine can vary depending on the vehicle's history. See the seller's listing for full details and description of any imperfections. ... 

 1972 Solid West Coast Chevy.  This Chevelle comes with the original numbers matching 350ci engine (see pic).  I am assuming the transmission and rear-end are original also due to the fact this car was unmolested and still had the original paint on it when I got the car.  The car has 67,000 original miles.  The carb looks very original.  It has the original air cleaner.  It is also a power steering, power disc brake, air conditioning car. Another rare option and still has the original switch just to the left of the radio is factory rear defrost. The car drives great.  It has good rubber and the brakes work great.  Steering is nice and tight.  You can steer it with 1 finger if you'd like.  The interior has all new door panels, sill plates, carpet, front seat cover.  Other than that all pieces are original inside the car including the dash which is basically perfect.  All the lights work.  Both floor lights and dome light as well.  All seat belts are there.  The heater works.  All glass functions as it should.  New weatherstripping throughout the car, door, roofrail, and trunk. All new window wiskers as well.  The body of the car is very very solid.  Paint shows very well, it is base coat clear and was just completed.  Trunk is 100% solid,  Floors are 100% solid, the frame is 100% solid.  The car has a new front bumper.  This is a car you can get in and start enjoying instantly.  Very rare options.  Cared for and preserved over the years.  If you have any questions call 651-208-5196

Auto Services in Oregon

Uncle Al`s Automotive Service ★★★★★

Auto Repair & Service
Address: 180 E Clarendon St, Canby
Phone: (503) 655-9977

Toyota of Gladstone ★★★★★

Auto Repair & Service, New Car Dealers, Used Car Dealers
Address: 19375 SE McLoughlin Blvd, Gladstone
Phone: (866) 381-9457

Tommy`s Window Tinting ★★★★★

Auto Repair & Service, Window Tinting, Glass Coating & Tinting
Address: 915 SE 12th Ave, Portland
Phone: (503) 963-8468

Three Sisters Automotive ★★★★★

Auto Repair & Service, Automobile Air Conditioning Equipment, Automobile Air Conditioning Equipment-Service & Repair
Address: 177 W Sisters Park Dr, Sisters
Phone: (541) 549-1890

Peoria Electric ★★★★★

Auto Repair & Service, Automobile Parts & Supplies, Automobile Accessories
Address: 33901 SE Peoria Rd, Shedd
Phone: (541) 753-9191

Oak Valley Honda ★★★★★

Auto Repair & Service, New Car Dealers, Used Car Dealers
Address: 8515 Lone Oak Rd N, Lafayette
Phone: (503) 472-0465

Auto blog

Why does the Corvette Stingray have so many vents? Here's why

Sun, 27 Jan 2013

Just looking at the new 2014 Chevrolet Corvette Stingray, it's not hard to see that the car's design was created with aerodynamics at the forefront, but Chevrolet designers point out exactly what went into designing the iconic coupe in a pair of recently released videos. The videos show the Corvette going through early design phases, including clay models and wind tunnel tests, as well as talking to the car's chief engineer, Tadge Juechter.
Both videos help explain various aspects of the C7 Corvette, but it's the aero tuning of the car that is most interesting. This includes extra attention paid to the lower air dam and vented hood to help reduce drag and lift, while the rear quarter inlets are for differential and transmission cooling. Juechter said that some of these aero-tuned elements were inspired from GM's involvement in racing.
If you have about five minutes and you can't get enough information about the new 'Vette, then check out the videos posted below.

Chevy Corvette Stingray picks up another award, this time from Automobile

Mon, 18 Nov 2013

The new Chevrolet Corvette Stingray has picked up another buff book accolade after capturing Road and Track's Performance Car of the Year award. The seventh-generation of America's sports car (sorry Viper, Mustang, et al.) has been named Automobile Magazine's Automobile of the Year.
Automobile's award to the Corvette over competitors is the mirror image of its rival Motor Trend, which named the Cadillac CTS its car of the year over the C7. The CTS was, according to the Automobile team, the closest contender to the mighty Stingray. Great news all around for General Motors it seems.
As for what pushed the Corvette past its distant, four-door cousin, Automobile commended its excellent, 6.2-liter V8 calling the car's performance "simply awesome" while also remarking that it is easier to drive fast than ever before thanks to steering and chassis tweaks. Following a theme set by other publications, there were also plaudits for the interior, of all things, with the buff book complimenting the car's ergonomics and material quality, while also praising the standard seats.

UAW to vote on strike at Kentucky Corvette plant

Tue, 08 Apr 2014

The current wait time for a new Chevrolet Corvette Stingray is well, not short. With word of a strike at the Bowling Green, KY factory responsible for seventh-generation sports car, though, that wait time could end up growing substantially.
Now, a strike is still a ways off. UAW Local 2164, which represents the 800 workers responsible for screwing the Corvette together, is set to vote on authorizing a strike today, but even if the employees give the action a go, it's far from a sure thing. According to The Tennessean, both regional and national union officials would need to put their stamp of approval on strike action.
"The membership has to vote to strike, but it's just a step in the process," said Gary Casteel, the UAW's Region 8 director and one of the people that would need to authorize a strike action. Casteel told The Tennessean, "It's purely a local situation, though. They are having some issues with the local management."