1987 Chevrolet Caprice Classic Coupe 2-door 5.0l on 2040-cars

Auto blog

2016 Chevrolet Camaro powers up, slims down

Don't be fooled by its familiar appearance, the 2016 Chevrolet Camaro is vastly different than its iconic predecessors. It has a new chassis, a fresh engine lineup, and is loaded with clever technologies that promise to invigorate and improve the sixth generation of Chevy's legendary sports car. It was revealed Saturday before a crowd of enthusiastic Camaro revelers on Belle Isle in Detroit. Redesigning the sports coupe was a heady task, especially as its archrivals, the Ford Mustang and Dodge Challenger, drive better and are more powerful than ever. But the new Camaro is aiming to be the best combination of handling and raw performance, with quick acceleration and competitive fuel economy. "Redesigning the Camaro is thrilling and challenging all at once, but the secret is to offer something more," Mark Reuss, General Motors executive vice president of product development, said in a statement. It all began with a weight-loss plan. The new Camaro shed more than 200 pounds compared with the outgoing car, with 133 pounds coming from a lighter body-in-white. Then engineers culled weight nearly everywhere, using aluminum for the instrumental panel frame and some suspension components to trim as much fat as possible. The slimmer body rests on new bones. The Camaro's rear-wheel-drive platform is lighter and stiffer in a bid to improve handling. It's a modified version of the underpinnings used by the Cadillac ATS, though about 70 percent of the architecture is unique to the Camaro. Chevy said structural rigidity is improved by 28 percent. As you'll see, healthy doses of Cadillac and Corvette technologies have been used to bolster the Camaro's drive character and performance. The new car is also expected to handle better thanks to a slightly smaller footprint. It is about two inches shorter in length, with most of that due to the more compact wheelbase. It's also an inch shorter in height and an inch slimmer in width. So yes, the Camaro will be leaner, but it will still be plenty mean. The Camaro SS tops the range (for now) with the Corvette's 6.2-liter V8 pushing put 455 horsepower and 455 pound-feet of torque. Known as the LT1, is has a cast aluminum block and cast aluminum cylinder heads, and it's fortified with direct injection, variable valve timing, and cylinder deactivation. About 20 percent of the engine's parts are said to be unique to the Camaro, including the exhaust manifolds.

Next-gen Chevy Silverado and GMC Sierra may use carbon fiber

It's been generally accepted that the next generation of full-size GM trucks will use some sort of strong, lightweight material for the beds while retaining steel for the cab. While aluminum seems like the most obvious choice, according to Automotive News, the Chevy Silverado and GMC Sierra will incorporate both aluminum and carbon fiber in their beds. The publication cites sources from within GM, though it seems the introduction of this comparatively exotic material mix is still a few years off. While carbon fiber is both stronger and lighter than steel and aluminum, it takes significantly more time and money to produce, essentially relegating the material to small-volume cars. The main benefit for trucks is the resulting reduction in weight to improve fuel economy without sacrificing the tough, rugged capabilities truck buyers expect. The Ford F-150 made the switch to aluminum for the 2015 model year and it's proved highly successful. It seemed like it was only a matter of time before the competition followed suit. Automotive News says that the next-gen trucks will launch with aluminum beds and that it will take a couple of years before we'll see any carbon fiber incorporated into the design. Even then, only look for the composite material on higher-trim models, with a trickle down to lower-spec trucks possible further in the future. In 2011, GM announced it was working with Japan-based Teijin Limited on a carbon fiber reinforced thermoplastic. There's a good chance that material's introduction will be on trucks. Related Video: News Source: Automotive News Plants/Manufacturing Rumormill Chevrolet GM GMC Truck

The story of the 2014 Chevrolet SS: "Luxury, power, refinement, handling"

Not including the women and men who built it, the 2014 Chevrolet SS has only been seen in person by a piddling number of people - fewer humans than would fill the gymnasium at a high school volleyball game. Not including the men and women who built it, no one has driven it. Even so, it is already saddled with two controversies: the way it looks and the way it shifts.
First to that shifting. Did we love the last Americanized Holden, the awesomely sportsome Pontiac G8 GXP, and its six-speed manual? Of course. Do we wish the SS came with a six-speed manual? Of course. But we'd like a toboggan to come with a manual transmission. We'd put a manual transmission on a weasel if we could because we're just wired that way; if it moves, it should come with a stick and a clutch. Or at least the option.
Let's climb down off the ledge, though. We haven't driven the SS and we have no idea how good (or not) the automatic is. And the Hobson's Choice in transmissions when it comes to sport sedans like the BMW M5, Mercedes-Benz E63 AMG and Jaguar XFR-S and, oh yeah, cars-that-really-should-have-manuals like the Audi R8 and Nissan GT-R and Porsche 918 and every single Lamborghini and Ferrari, for instance, hasn't stopped us from enjoying what is clearly the gruesome, dual-clutched demise of Western automotive civilization. Because in spite of our ululations at the dying of the six-speed light, we understand.