1997 Chevroletc/k Pickup 3500 Dually 6.5 Liter V8 Diesel on 2040-cars
Clarkston, Michigan, United States
300k + miles engine rebuilt at 200k. 2 wheel drive, runs and drives good, tires decent, very little rust on passenger side. Would make a great workhorse for hauling or towing business. Any question ask :248-821-6087 David |
Chevrolet C/K Pickup 3500 for Sale
2008 chevrolet silverado 3500hd lt1 4x4 crew cab flatbe(US $21,999.00)
1999 chevrolet c3500 automatic bucket truck with working lift(US $15,495.00)
2009 chevrolet 3500hd 6.0l gas 4x4
1987 chevy c30 dump truck runs good needs work
1987 chevy sierra classic 3500 duly. brown. good condition. 4 speed manual trans(US $5,000.00)
1972 1 ton stake body / flat bed, ready to work(US $6,000.00)
Auto Services in Michigan
Waterford Collision Inc ★★★★★
Varney`s Automotive Parts ★★★★★
Tuffy Auto Service Centers ★★★★★
Tuffy Auto Service Centers ★★★★★
Tri County Motors ★★★★★
The Brake Shop ★★★★★
Auto blog
GM recalls 8,500 Chevrolet Malibu models for rear suspension glitch
Mon, 04 Feb 2013According to a letter from General Motors to the National Highway Traffic Safety Administration, flaws in the build process of the 2013 Chevrolet Malibu have led to the recall of 8,519 cars. Units built between December 6, 2011 and January 15, 2013 may have been assembled with rear suspension cradles that had insufficient torque applied to certain bolts. That out-of-spec assembly could lead to issues ranging from slight noises to a loss of vehicle control.
The problem was first noticed in December of last year by a GM test fleet driver and eventually tracked back to the improperly torqued bolts on the suspension cradle assembled through July 2012 by a supplier located not too far from the Malibu's Detroit/Hamtramck Assembly Plant. Since an official NHTSA recall notice has not been issued yet, it isn't clear whether or not Detroit-built Malibus were the only ones affected (the 2013 Malibu is also built at GM's Fairfax Assembly Plant in Kansas City, Kansas). Dealers will fix the problem by inspecting vehicles for proper torque specs, retightening if not within specs and, in some cases, perform a rear-wheel alignment.
Driving Granatelli's turbine-powered 1978 Chevy Corvette [w/video]
Thu, Jan 8 2015With its curvy snout and feminine haunches, the third-gen Chevrolet Corvette looks like a dreamy – if dated – exemplar of Sports Car Fantasy 101 when viewed through modern eyes. This particular specimen circa '78, clad in silver and black paint with red pinstripes, appears to be a well-preserved example from the era. Apart from its low-profile Pirellis, slightly raised and slotted hood, spacious stance and a certain hand-painted descriptor alongside its crossed flag logos, you'd never guess there's a Space-Age propulsion unit powering this Coke bottle-bodied ride. Climb inside, and you're presented with aircraft gauges and big, colorful square buttons in the center panel. It takes a push of the "Ignitor" button, a tap of the starter button, and a slide of a T-handle for this nearly 40-year-old sports car to start sounding like Gulfstream G650 ready for takeoff. Yep, you're sitting in an 880-horsepower, turbine-powered Corvette, the only one of its kind in the world. Welcome to the whoosh. What The...? Built by Vince Granatelli, son of Indy 500 guru Andy Granatelli, this curious Corvette came into being by cramming a Pratt & Whitney ST6N-74 gas turbine engine into the donor car's lengthy front end. The same type of Jet A-burning mill powered Granatelli Senior's STP-sponsored racecar at the 1967 Indianapolis 500, where it famously led most of the 198 of 200 laps until a $6 transmission bearing failed, knocking it out of the race. The idea of turbine power usurping internal combustion was so threatening that Indy's governing body restricted turbine performance into obsolescence thereafter. A turbine-powered Corvette sounds excessive because it is. But there are also things about this 880-horsepower, 1,161-pound-feet monster that might surprise you. While it smacks of futurist exoticism and cost a then-dizzying $37,000 in 1967, the Canadian-built powerplant uses 80 percent fewer parts than an internal combustion V8 and will run on virtually anything combustible – whiskey, diesel, even Chanel No. 5. Though it's triple the length of a V8, the Pratt & Whitney beast weighs only 285 pounds. It's also one hell of a robust workhorse, typically serving as an auxiliary power unit for commercial aircraft or a generator in oil fields, where it can run for tens of thousands of consecutive hours before needing an overhaul. To adapt the Chevrolet for jet duty, the nose section was gutted and a sub-frame was built to compensate for the loosey-goosey front end.
NHTSA closes book on Ford, GM probes of 600,000 vehicles
Thu, Nov 27 2014US safety regulators have closed a pair of investigations into some 500,000 Ford Crown Victoria, Mercury Grand Marquis and Marauder sedans built between 2004 to 2007, and 100,000 Chevrolet Impala models from 2014. The Ford investigation focused on rusting heat shields, which may become dislodged and jam the steering, according to Reuters. The National Highway Traffic Safety Administration found that this happened very rarely. In fact, of the ten incidents filed with the government safety watchdog, six came from a single police department, which evidently had some sort of problem with its reporting. As for the Impala, the NHTSA investigators attributed two incidences of "unintended autonomous braking" to user error. In both cases, the vehicles were involved in rear-end collisions. According to GM investigators, it's believed that drivers accidentally activated the electric parking brake, causing the collisions. The vehicles in question were rental cars. Featured Gallery Ford Crown Victoria Related Gallery 2014 Chevrolet Impala View 10 Photos News Source: ReutersImage Credit: Ford, Chevrolet Government/Legal Chevrolet Ford Safety Sedan ford crown victoria mercury grand marquis