1955 Chevrolet on 2040-cars
North Brunswick, New Jersey, United States
Body Type:Sedan
Engine:454cu.
Vehicle Title:Clear
Fuel Type:GAS
For Sale By:Private Seller
Used
Year: 1955
Interior Color: Black
Make: Chevrolet
Number of Cylinders: 8
Model: Bel Air/150/210
Trim: 150
Drive Type: Rear Wheel
Mileage: 1,000
Exterior Color: Lemans Blue
Warranty: Vehicle does NOT have an existing warranty
|
1955 150 Chevy Gasser is what I have up for auction...I built it in 2008 and has less then 1000 miles on it...it has a straight axles with coilovers and four link suspension...my friend owns the original Two Lane Blacktop car from the movie and I copied it right from his car including the firewall...It has a 454cu. with less then 400 miles on it...new clutch and steel flywheel...scattershield...M-22 Muncie trans...60 Olds rear with a new 4 series posi unit and 390 gears...Morrison ladder bars with original leaf springs...new wiring harness...new interior...new Lemans Blue paint with a fiberglass tilt nose...everything on this car has been replace when built with new...These are the engine specs...NEW 4.00" stroke steel crank with hardened racing bearings NEW 6.135" 4340 I-beam rods with high performance rod bolts 10 to 1 compression so it will run on pump gas
NEW Forged domed pistons with file fit moly rings seasoned 4-bolt main block Deck head gasket surface on block to ensure good seal NEW hydraulic flat tappet cam with .574"int/.578exh valve lift NEW aluminum rectangular port heads 2.250"int/1.880"exh stainless swirl polished valves with 11/32" undercut stems for improved flow. both intake and exhaust valves feature an undercut stem in the head area. in addition to reducing weight(which provides benefits in opening rate and rpm limits) the radius is such that it significantly improves air/flow. fully swirl polished, chrome stems, and stellite tips 119cc combustion chambers 1.460" high performance valve springs and chrome moly retainers set up to match camshaft 3-angle valve job Dart guide plates for 3/8" diameter hardened push rods installed ARP rocker studs made of 8740 chrome moly steel and heat treated to a tensile strength of 200,000psi installed manganese bronze valve guides set up for use with leaded or unleaded fuel 320cc intake runners exhaust ports are deburred and polished NEW 1.7 full roller rockers - these rockers require the use of tall valve covers installed NEW double roller timing set NEW high volume oil pump with steel drive shaft and steel guide with extra capacity oil pickup tube NEW extra capacity oil pan with trap door to control oil NEW edelbrock air gap intake manifold NEW revolutionary 1-pc design molded rubber oil pan gasket with load limiters to prevent overtightening and higher temperature resistance NEW brass expansion plugs all parts are painted separately before assembly for the quality show look NEW race-type harmonic balancer NEW msd big block chevy kit includes distributor 6al box coil and wires NEW 950 cfm carb with a line and guage kit...Please don't ask me my reserve because I will not answer you...Bid what you feel the car is worth to you...I will look at trades...or partial trades...I'm a Chevy guy...66-67 Chevelle's...68-69 Camaro's...4 speed big block cars...any questions for serious inquires....Call...732-489-2201...Thanks On Sep-09-14 at 04:45:03 PDT, seller added the following information: You will need to leave a $500.00 paypal deposit 24hrs. after the auction ends and the rest in cash when you pick it up.!!! |
Chevrolet Bel Air/150/210 for Sale
Auto Services in New Jersey
West Automotive & Tire ★★★★★
Tire World ★★★★★
Tech Automotive ★★★★★
Surf Auto Brokers ★★★★★
Star Loan Auto Center ★★★★★
Somers Point Body Shop ★★★★★
Auto blog
GM, UAW poaching Nissan workers in Tennessee
Tue, Sep 8 2015General Motors and the United Auto Workers are going on a recruitment drive at the Spring Hill factory in Tennessee, and they're hoping to poach some skilled workers from Nissan's nearby plant in Smyrna, TN. The General and the union even bought a billboard advertising for industrial electricians near the Japanese automaker's facility, according to the Daily News Journal. The reason for the billboard was simple. "GM was short of electricians," said Tim Stannard, the president of the UAW local at Spring Hill, to the Daily News Journal. The factory currently builds the Chevrolet Equinox but has a contract to assemble the next generation of Ecotec engines and the Cadillac XT5, which replaces the SRX. Thanks to the $185-million deal, employment there is expected to double by May 2016, according to Stannard, with roughly 1,800 additional union jobs. Beyond just several billboards, GM has job postings online for the Spring Hill plant looking for workers with specific skills. There has already been some interest in the positions among Nissan employees, Stannard indicated. According to a recent study by the Center for Automotive Research, the average GM worker currently makes $58 an hour, including benefits. Comparatively, Nissan pays an average of $42 an hour with benefits. The General's number could change in the coming weeks because its contract with the UAW is about to expire, and higher wages are among the major negotiating points.
Fernando Alonso just misses qualifying for Indy 500 on first day
Sun, May 19 2019Former Formula One world champion Fernando Alonso will need a clutch run on Sunday to qualify for the Indianapolis 500 on May 26 after he failed to seal a guaranteed spot on Saturday. The Spaniard tried fives times to put his McLaren Racing Chevrolet in the top 30, but wound up one spot short. He can make the 33-car field only through a six-car shootout on Sunday that will determine the race's final three drivers. "We have another chance to be in the race," Alonso, who is seeking to make his second Indy 500 field, told IndyCar TV. The Spaniard twice got inside the top 30 but both times was bumped outside the mark, with JR Hildebrand and Graham Rahal the final two drivers to seal qualifying spots. Britain's Pippa Mann will be the only woman in the race, qualifying 30th in 227.244 mph. Race positions 10-30 were determined during the day-long qualifying with Saturday's nine fastest drivers set to return on Sunday to decide pole. Spencer Pigot, driving the Ed Carpenter Racing Chevrolet, led qualifying with a four-lap average of 230.083 mph. He was followed by 2018 winner Will Power of Australia (230.081) and Simon Pagenaud of France (229.854). The troubles for Alonso, whose top four-lap average was 227.224 mph, were exacerbated by a punctured tire in his first qualifying run. "That didn't help," Alonso told reporters. "But, obviously, our performance has been quite bad all week. Quite poor." The Spaniard crashed his Chevrolet in practice on Wednesday and missed nearly two full days of practice while a backup car was prepared. He returned on Friday. Alonso said he was worried the McLaren team was "not ready for the challenge." "We've been slow. You see Juncos Racing crashing yesterday and being ready at 6 o'clock. That's impressive," he said. "For us, we've been a little bit slow on everything." Alonso is bidding to join Graham Hill as the only drivers to achieve the 'Triple Crown of Motorsport' with an Indy 500 victory. He previously won the Monaco Grand Prix and Le Mans 24 Hours race. He also won two Formula One drivers' titles. (Reporting by Gene Cherry in Raleigh, North Carolina; Editing by Greg Stutchbury)Related Video: Motorsports Chevrolet McLaren IndyCar
Sunday Drive: A tale of old favorites and upcoming challengers
Sun, Oct 8 2017Sedans and crossovers dominated the attention of our readers last week, led by the completely redesigned 2018 Honda Accord. It's the Japanese automaker's flagship, and people are seriously interested in finding out how good the latest Accord is. So interested, in fact, that no other single story came close to the brand-new Accord in Autoblog reader interest. Moving down the list we find the equally new 2018 Buick Enclave. The three-row crossover has a lot to offer a family, especially one looking for a nice, quiet ride. If you're looking for the exact opposite of nice and quiet, but still want enough room for you and your significant others, the Subaru WRX that we tested last week may be the perfect ride for you. Or, if you just want to drive fast and aren't at all worried about space, there's the Camaro SS. See? We offer something for everybody. From there, we look to the future. Who isn't interested in seeing the first fully electric vehicle from Porsche? And who isn't intrigued to see the Mission E testing alongside a gaggle of Teslas? A brand-new Jeep is always a big deal, especially when it's the revival of a classic nameplate like the Grand Wagoneer. And finally, we have something completely different: the Rezvani Tank. As always, tune in to Autoblog next week for a front-row seat to all the happenings worth following in the automotive industry. 2018 Honda Accord First Drive | Feels like home again 2018 Buick Enclave First Drive Review | Fortress of quietude 2018 Subaru WRX Drivers' Notes | Turbo traditionalist 2018 Chevy Camaro SS Drivers' Notes | Demonstrative power, middling interior Porsche Mission E caught testing against Teslas Jeep three-row SUV caught on public roads — Grand Wagoneer, perhaps? Rezvani Tank: It's like a Hot Wheels car brought to life Green Buick Chevrolet Honda Jeep Porsche Subaru Crossover SUV Electric Future Vehicles Luxury Off-Road Vehicles Special and Limited Editions Performance Sedan porsche mission e sunday drive
2040Cars.com © 2012-2025. All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.
Use of this Web site constitutes acceptance of the 2040Cars User Agreement and Privacy Policy.
0.04 s, 7948 u









1954 chevy muscle car 210 2 door hot rod pro street 502ci fuel injected
1956 chevrolet bel air base 4.3l
1955 chevy gasser
1957 chevrolet bel air
1956 chevy belair hardtop
1955 chevy belair 2 door post frame off restoration every nut and bolt !!!