2011 Bmw 750li 4dr Sdn Rwd on 2040-cars

Auto blog

BMW 1 Series with B38 three-cylinder engine

Downsizing For BMW's Front-Wheel-Drive And i Futures
Output is quoted at 175 horsepower and BMW says it will hit 62 mph in 7.0 seconds.
The red five-door BMW 1 Series seen in this photo gallery has little to do with what is actually of importance here. What we've just tested at an airfield not far from Munich, Germany, is a new 1.5-liter TwinPower Turbo inline three-cylinder gas engine that we'll be hearing an awful lot about in the coming few years.

2014 BMW 320i

When BMW switched its entry level 3 Series, the 328i, from a naturally aspirated, 3.0-liter six-cylinder to a turbocharged, 2.0-liter four-cylinder, we weren't entirely sure what to think. Sure, from a pure numbers perspective, the new 2.0-liter cooked the old 3.0's goose, delivering more torque at far more accessible engine speeds while boosting horsepower and fuel economy.
While we miss that revvy six-pot, the numbers for the 2.0 were just way too good to pass up. Then we received news of an even less-powerful 2.0-liter 3 Series - the 320i. This was interesting, as it saw BMW delving into a power level previously owned solely by the anemic Lexus IS 250 and its six-cylinder engine.
Could BMW make a sub-200-horsepower sedan that still drove the way we expected a 3 Series to drive? To find out, we borrowed the new 320i for a week of testing.

Researchers halfway to cutting carbon fiber costs by 90%

Carbon fiber has been utilized for decades to build racecars, as a means to cut weight while maintaining strength. But until recently, the space-age material has been largely absent from the street on anything but supercars because of the expense to use it. Recently, BMW signaled a major shift in that trend when it starting using carbon fiber reinforced plastic panels on the i3 and i8. This relatively small scale start might be just the beginning; the German company believes that a breakthrough to inexpensively manufacture the lightweight stuff is just on the horizon.
MAI Carbon Cluster Management GmbH counts BMW, Audi, Airbus, the German government and many other organizations as supporters, and it's researching how to make carbon fiber cheaper to produce, according to Automotive News Europe. The company thinks it can reduce costs by 90 percent in the near future. "We've certainly reached a halfway point on our cost-cutting target for suitable carbon-fiber parts," said project head Klaus Drechsler to Automotive News Europe.
Unfortunately, it isn't entirely clear just what MAI Carbon is doing to make such a huge leap possible. However, a recent post on the company's website talks about a new form a carbon fiber using a thermoplastic matrix that could be cured in less than three minutes. That's compared to about 90 minutes in the traditional process with an autoclave.