1930 Ford Model A Pick Up Truck on 2040-cars

Auto blog

Watch Tanner Foust hustle the Fiesta ST 'round the 'Ring

The last time we saw Tanner Foust at the Nürburgring he was sloshing an SVT Raptor from kerb to kerb. Sticking with Ford but swapping keys, this time the drift champion and Top Gear USA host goes to the opposite end of the manufacturer's tuner garage and plucks a Fiesta ST for 'Ring duty.
The 179-horsepower front-wheel-driver acquits itself well by the end of the video. But be warned, Foust doesn't set a 'Ring time and it's shot like a commercial... because that's what it is. Still, you can enjoy all two minutes and 31 seconds of it below.

Ford confirms 1.5-liter EcoBoost four-cylinder engine for 2014 Fusion

Earlier this week, reports were swirling 'round the internet about the 2014 Ford Fusion getting a new 1.5-liter three-cylinder EcoBoost engine. That was... half correct. Ford today confirmed that the 2014 Fusion is, in fact, getting a new 1.5-liter EcoBoost mill, but it has four cylinders, not three.
The new 1.5-liter engine will be the fifth EcoBoost powerplant from Ford Motor Company. Initially to be built at the automaker's Craiova, Romania plant, it will also be offered in the Fusion's twin, the Mondeo, in other markets. This engine will debut at the Shanghai Motor Show next month, and the 1.5-liter is of particular importance in the Chinese market - there is significant tax relief in the People's Republic for vehicles powered by engines with a capacity of 1.5 liters or less.
At a media briefing Thursday, Ford declined to divulge exact power or fuel economy numbers, though Joe Bakaj, vice president of powertrain engineering, told Autoblog that power output should be similar to that of the current 1.6-liter inline-four, and that overall efficiency will be "better than the 1.6." Our earlier report stated that the 1.5-liter four will produce 177 horsepower and 177 pound-feet of torque - losses of 1 hp and 7 lb-ft versus the 1.6-liter engine. Ford states that the 1.5-liter four will feature many of the same technologies used on the company's 1.0-liter EcoBoost inline-three, including an integrated exhaust manifold that recaptures much of the engine's heat.

Ford to auction Mustang Cobra Jet prototype for charity [w/video]

Prototypes developed by major automakers typically remain in said company's custody, but every once in a while, one trickles out into private hands. And that's just what we have here. Ford is donating a one-of-a-kind factory prototype for the 2014 Mustang Cobra Jet that will be auctioned off later this month by Barrett-Jackson in Las Vegas to benefit the National Multiple Sclerosis Society.
Powered by a 5.0-liter supercharged V8 mated to a T4 competition gearbox, this rare Cobra Jet prototype includes a wheelie bar, chromoly roll cage, Weld wheels, three-link rear suspension, racing brakes, 9-inch rear axle and more. It's painted in a unique satin orange with reflective gray striping scheme, bears the serial number 2014 BJMS CJXX1 and is fully ready for NHRA competition on the drag strip.
To be offered with no reserve on Saturday, September 28, 2013, the Cobra Jet prototype's winning bidder will also receive tutelage at Roy Hill's Drag Racing School in Sophia, NC, along with tours of the Ford Product Development Center, Ford Racing headquarters and Ford Design Studios with Mustang chief engineer Dave Pericak. Scope out the video and details below for what could be the ultimate Mustang experience for a good cause.