1966 Ford Galaxie 390 4 Speed on 2040-cars

Auto blog

Ford, Samsung shack up to bring regen braking to non-hybrid models [w/video]

Ford must be desperate to get itself ready for the beach this summer because it is really trying to get into shape. Shortly after unveiling the Lightweight Concept that cut the weight of a Fusion down to that of a Fiesta, it's now the rest of the line's turn for improvement. The company is wrapping up a 10-year research project aimed at developing next-gen automotive batteries to improve efficiency.
Ford claims that 70 percent of its lineup will have stop/start tech by 2017. The key to this massive proliferation is its new dual-battery system that combines a lithium-ion battery with a lead-acid one and regenerative braking. The setup works by harvesting braking energy and converting it to electricity. When the vehicle stops, the engine shuts off, but the Li-ion battery has enough juice to keep the accessories running. The engine starts up again as drivers take their foot off the brake. The layout would mean less wasted gas while idling. It's already available on Ford hybrids and is somewhat similar to the i-Eloop capacitor-based system from Mazda.
The bigger challenge is tuning the regenerative braking right. While hybrid drivers may be a little more adventurous, when it comes to getting a hang of regen braking, conventional buyers might not be so open-minded. The systems have a tendency to be a little grabby at first and then taper off at very low speeds. Ford needs to make sure it's just right to avoid turning off buyers.

NHTSA opens investigation into Ford Explorer PI brakes

This year more than most, it's pleasant when we can string together a few days without word of an automaker or the National Highway Traffic Safety Administration announcing a bunch of new recalls. It's seemingly been a little quiet on this front lately (barring a spider-related Suzuki issue revealed early today), but now we have word of the government safety agency opening a Preliminary Evaluation into the 2013 Ford Explorer Police Interceptor, a probe that could potentially affect an estimated 20,000 vehicles.
The issue being investigated concerns failures of the front brake hose on the vehicle that show "small splits in the hoses near the body side ferrule of the hose assembly," according to the agency, and the issue could result in longer stopping distances. The feds have reports of 13 malfunctions affecting 11 Explorer units. However, it's important to note that all of the incidents come from a single, unnamed metropolitan police fleet that operates 46 of them. According to The Detroit News, the failures generally took place between December and July.
NHTSA is investigating further to find if this is a more widespread issue than just this one fleet. Ford spokesperson Kelli Felker confirmed to us, "We are cooperating with NHTSA on this investigation, as we always do." Scroll down to read the agency's report.

NHTSA closes Ford F-150 EcoBoost acceleration probe

Typically when we report on the findings of an investigation from the National Highway Traffic Safety Administration, it's because the government body has discovered a safety issue and prescribed a recall. In this case, however, NHTSA has closed an investigation into a reported performance deficit without ever getting to the recall stage.
The issue revolves around the Ford F-150 - specifically those equipped with the 3.5-liter EcoBoost engine - of which some 360,000 were built in the 2011, 2012 and 2013 model years. After receiving an initial 95 complaints, NHTSA opened an investigation last May - almost a year ago - into the reported issue of reduced engine power under hard acceleration. The agency has since received a total of 525 such complaints, and Ford itself reported receiving over 4,000.
Together, NHTSA and Ford determined that the problem resulted from cylinders misfiring, an issue itself stemming from water getting into the charge air cooler (CAC) mated to the turbochargers. In particularly humid or rainy conditions, water was found to get into the CAC, causing some of the cylinders to misfire, which in turn triggered the ECU to disable those cylinders in order to protect the catalytic converter from damage.