1962 Ford Falcon Futura 4 Door - Daily Driver on 2040-cars

Auto blog

Next-gen Ford Cobra Jet development underway, but will it be a Mustang?

Ford might be stepping away from the NHRA, but it isn't abandoning drag racing altogether. Hot Rod says that Ford confirmed a next-gen Cobra Jet factory drag racer is in the works, but the report also speculates that a new Cobra Jet could switch away from the Mustang nameplate.
Even though talk of a new Cobra Jet coincides with the all-new 2015 Mustang, the lack of confirmation for the dragster's platform leaves Hot Rod to guess that the car might switch to another platform - specifically a front-drive-based, unibody car like the Fusion or Taurus. We'd hate to think of a world with a NASCAR-ized dragster from Ford Racing, but it's also highly unlikely that the Mustang Cobra Jet would step away from its quarter-mile rivals like the Chevy COPO Camaro and Dodge Challenger Drag Pak.

William Clay Ford Sr. dead at 88

William Clay Ford, retired vice chairman of Ford Motor Company and the last surviving grandchild of company founder Henry Ford, died this morning after a bout with pneumonia. He was 88.
Ford spent 57 years with his grandfather's company, joining the board of directors in 1948 before graduating from college. Ford also held a position as chairman of the design committee, as well as the chairman of the executive committee and vice chairman of the Board of Directors during his tenure with the company. In a 2013 Detroit Free Press story, retired CFO Allan Gilmour said Ford had an eye for design, and was once able to pick out when a fiberglass model of a Ford Contour was asymmetrical, off by an inch on one side. He retired and assumed the position of director emeritus in 2005.
"My father was a great business leader and humanitarian who dedicated his life to the company and the community," said Bill Ford, Jr., Ford's current executive chairman. "He also was a wonderful family man, a loving husband, father, grandfather and great-grandfather. He will be greatly missed by everyone who knew him, yet he will continue to inspire us all."

Ford builds Lightweight Concept with Fusion shell [w/video]

It's a fairly well known fact that removing weight from a car is essentially a panacea for many of the modern automobiles problems. Does it handle like crap? Remove weight. Underpowered? Don't add power; trim the fat. Need to improve fuel economy? It's diet time.
Actually executing a major weight reduction program, though, much like with human beings, is no easy task. Unlike you or I, where motivation is the issue, the prohibitive measure in trimming a car's waistline is money. Lightweight materials are expensive, with carbon fiber and carbon-fiber reinforced plastic still primarily in the domain of higher end vehicles. Even aluminum construction, pioneered on a mass-produced level by Audi and Jaguar, is only now starting to make its way into the mainstream, thanks to the upcoming Ford F-150.
With this concept, though, Ford is attempting to show that a mass-produced, lightweight vehicle isn't too far off. This is the Lightweight Concept, and while it may look like a Fusion, it weighs as much as a Fiesta. For reference, the lightest Fusion available to the public is the 3,323-pound, 2.5-liter model with a manual transmission. A manually equipped, 1.6-liter Fiesta, meanwhile, is just 2,537 pounds.