2006 Ford F250 Diesel 4x4 Xlt 20s Crew Powerstroke Texas on 2040-cars

Auto blog

Ford Mustang Shelby GT500 has a bit of a dyno issue

We're of the mind that each and every dyno should come with Murphy's Law painted in big, visible letters down the side. For every ten successful dyno runs out there, it seems there's one where events to horribly wrong. Take, for example, the video below. The clip shows what happens when a Ford Shelby GT500 and a mobile dyno have a bit of a disagreement at the Performance Expo 24 in Sherbrooke, Quebec. We won't spoil the results for you, but we will say there's some substantial carnage involved.
It's unclear just how much damage ensues from the dust up or whether anyone was harmed in the incident, but from the looks of things, everyone made it out without serious injury. If only we could say the same for the machines involved. Check out the video below.

Ford car-camo artist works his craft on Australia's new Falcon XR8

Ford is among the kings of concealment when it comes to test cars. On one recent Mustang SVT mule, the automaker went to the extreme of putting baffles over the exhausts to hide how many there were. Sounds like a lot of work, right? In a new video, the Blue Oval has decided to take fans behind the scenes to show them what it takes to camouflage a prototype. In this case the subject was the recently unveiled 2014 Falcon XR8 for Australia.
Ford's prototype build coordinator Down Under has the very appropriate name of Neil Trickey, and it's his job to obfuscate the important bits of test cars to keep them out of spy shooters' camera lenses. Trickey calls his job a "dark art," and he shows off some of the tricks of his trade in the video. It turns out that the fabric we often see on mules is a type of lycra, but his team isn't above getting out a can of spray paint to conceal parts, too.
Scroll down to watch a video about a man who you probably wish could be a little worse at his job.

How Ford made its 2015 Ford Mustang safer for toupee wearers [w/video]

Ford is ready to tell the story of its 2015 Mustang Convertible, the can't-miss bits being the easier, quicker and quieter roof operation, a more robust roof build for a coupe-like cabin noise, more trunk space, better visibility and reduced in-cabin buffeting. The top release system has been completely redesigned with a single, center-mounted latch on the windshield frame instead of the dual latches of before. The driver can now release the roof without having to lean over into the passenger space, after which the top goes down fully automatically with the press of a button. Ford doesn't say how long it takes to stow, but it's apparently done in half as much time as before, so figure around 8 seconds.
The roof uses a five-bow structure, with the fabric outer and full inner headliner sandwiching ten millimeters of insulation. Detailing work on the top has eliminated "unsightly folds" in the corners when the roof is up and made it more compact when down; its Z-fold assembly is 6.7 inches lower than before at its highest point when put down. Ford says the new electric drive internals make less noise when in operation, and the fully-finished droptop look is achieved with snap-in caps that flank the rear seating and stow in the trunk when not in use (the outgoing Mustang's top was higher and the front when folded and always looked like it was catching air and creating drag).
The compact roof and newly independent rear suspension setup in back means liberated trunk space, 11.4 cubic feet ready to swallow golf bags and tourist swag. You can read a lot more about it in the press release below, check it out in the short video of running footage and learn about the aerodynamic improvements made to the entire Mustang lineup that decrease drag and increase fuel economy.