2011 Ford Escape Limited 4 Cylinder 4x4 Certified! on 2040-cars

Auto blog

Ford builds Lightweight Concept with Fusion shell [w/video]

It's a fairly well known fact that removing weight from a car is essentially a panacea for many of the modern automobiles problems. Does it handle like crap? Remove weight. Underpowered? Don't add power; trim the fat. Need to improve fuel economy? It's diet time.
Actually executing a major weight reduction program, though, much like with human beings, is no easy task. Unlike you or I, where motivation is the issue, the prohibitive measure in trimming a car's waistline is money. Lightweight materials are expensive, with carbon fiber and carbon-fiber reinforced plastic still primarily in the domain of higher end vehicles. Even aluminum construction, pioneered on a mass-produced level by Audi and Jaguar, is only now starting to make its way into the mainstream, thanks to the upcoming Ford F-150.
With this concept, though, Ford is attempting to show that a mass-produced, lightweight vehicle isn't too far off. This is the Lightweight Concept, and while it may look like a Fusion, it weighs as much as a Fiesta. For reference, the lightest Fusion available to the public is the 3,323-pound, 2.5-liter model with a manual transmission. A manually equipped, 1.6-liter Fiesta, meanwhile, is just 2,537 pounds.

Ford to auction Mustang Cobra Jet prototype for charity [w/video]

Prototypes developed by major automakers typically remain in said company's custody, but every once in a while, one trickles out into private hands. And that's just what we have here. Ford is donating a one-of-a-kind factory prototype for the 2014 Mustang Cobra Jet that will be auctioned off later this month by Barrett-Jackson in Las Vegas to benefit the National Multiple Sclerosis Society.
Powered by a 5.0-liter supercharged V8 mated to a T4 competition gearbox, this rare Cobra Jet prototype includes a wheelie bar, chromoly roll cage, Weld wheels, three-link rear suspension, racing brakes, 9-inch rear axle and more. It's painted in a unique satin orange with reflective gray striping scheme, bears the serial number 2014 BJMS CJXX1 and is fully ready for NHRA competition on the drag strip.
To be offered with no reserve on Saturday, September 28, 2013, the Cobra Jet prototype's winning bidder will also receive tutelage at Roy Hill's Drag Racing School in Sophia, NC, along with tours of the Ford Product Development Center, Ford Racing headquarters and Ford Design Studios with Mustang chief engineer Dave Pericak. Scope out the video and details below for what could be the ultimate Mustang experience for a good cause.

Hot sales have Detroit automakers shortening summer shutdowns

Back in May, there was speculation that the Detroit Three automakers would maintain or perhaps even extend their traditional summer shutdowns, mostly due to a bitingly cold winter that saw below-freezing temperatures infiltrate the southernmost reaches of the US, putting a chill on auto sales. Now, though, the numbers are in, and thanks to some promising sales figures, it looks like some domestic line workers are going to be working clear through July, in some cases.
According to Automotive News, Ford has slashed its traditional two-week hiatus for factory workers in half at four of its plants, while both Chrysler and General Motors will keep factories running nonstop (two plants in Chrysler's case and a third of GM's factories).
This is, as we said, thanks to some positive numbers. Chief among those is the Seasonal Adjusted Annual Rate, which was at an eight-year high of 17 million units. Individual figures were less promising. GM, embroiled in its recall scandal, still saw a one-percent increase while Ford dropped six percent in year-over-year sales. Chrysler was the big winner, though, with a nine-percent jump in June.