E150 Cargo W/ Adrian Bulkhead And Bin Package Stow All Floor Draws We Finance! on 2040-cars

Auto blog

Mustang Cobra Jet prototype garners $200k for charity at Barrett-Jackson

A few weeks ago we brought you news of a one-off Mustang Cobra Jet that Ford was donating to charity. The car was set to be auctioned off by Barrett-Jackson in Las Vegas to benefit the National Multiple Sclerosis Society. Now that auction has taken place, bringing in an impressive $200,000 for MS research.
That's a lot of zeros for a Mustang, much less one you can't even drive on the street. But the unique pony car, bearing serial number 2014 BJMS CJXX1, packs a 5.0-liter supercharged V8, competition gearbox, wheelie bar, roll cage... all you could want, in short, in a turn-key drag racer. And all that for a good cause.

Jay Leno drives postcard-perfect '32 Ford Highboy Roadster

At the turn of the century, it was arguably the Honda Civic that best defined inexpensive performance tuning, and in the '50s it was the Tri-5 Chevys. One of the earliest platforms to gain a huge following among young people looking for a cheap way to go fast was the classic '32 Ford Highboy Roadster. This week, Jay Leno's Garage looks at one of the very first vehicles that defined the look of the hot rod heyday.
This '32 Ford was built in the '40s and graced the cover of the fourth issue of Hot Rod Magazine back in 1948. All of the hot rods that you see shining at car shows today owe a serious debt of gratitude to this roadster. It bears all of the cues that define the look, including a notched frame and hidden door hinges. Under the three-piece hood is a flathead V8 boasting all sorts of period modifications, including copper cylinder heads. It was seriously fast in its era too, and proved it by reaching 112.21 miles per hour on a dry lakebed in 1947.
These days, this hot rod is on display at the Petersen Automotive Museum. Although, if you can't make it to California to see it, the United States Postal Service is celebrating this Ford with one of its two hot rod Forever stamps. Like Jay says in the video, in terms of hot rodding, "it all comes back to this." Check out the video to learn more about this rolling piece of tuning history.

Ford and Chrysler reducing summer plant shutdowns

Most domestic automaker assembly plants traditionally take a couple of weeks off during the summer. The shutdowns give each plant time for much needed repairs and maintenance, and in some cases, help better align production with demand. Not this year, though, as demand for many models is outstripping what Ford, Chrysler and General Motors plants can produce.
Ford has announced that it will shorten its annual summer shutdown for most North American plants from two weeks to one. The shorter shutdown will increase the carmaker's annual North American production by 40,000 units on top of the 200,000 extra units that it was already planning to produce this year versus last. Automotive News reports that Ford produced 2.8 million vehicles on this continent in 2012, and that output this year has already increased 13 percent through April.
Chrysler, meanwhile, is also operating at full tilt and plans to run some plants through the summer with no shutdown at all. Those not getting a break include Jefferson North where the Jeep Grand Cherokee and Dodge Durango are assembled, Toledo North that will assemble the new Cherokee, and Conner Avenue, home of SRT Viper production. Other assembly plants will be down for a single week, while all of Chrysler's engine and transmission plants except one in Indiana will continue operating with no shutdown this summer.