Dodge Ram 2500 Crewcab Laramie Longhorn Edition Turbo Cummins Diesel on 2040-cars

Auto blog

Is Mopar readying a special-edition Dart for Chicago?

Chrysler has released the above teaser of a limited-edition Mopar 2013 model that will be unveiled at next month's Chicago Auto Show. Although the automaker doesn't announce what vehicle will get the Mopar treatment, closer investigation of the seats and center console suggest that this car will be a special version of the 2013 Dodge Dart.
This will be the fourth Mopar model in as many years, following on the heels of the Mopar 2010 Challenger, Mopar 2011 Charger and the Mopar '2012 300. There are no details for the Mopar '13 Dart, but we do see that the car will retain the signature black-and-blue color scheme as past Mopar editions. Like these previous models, we expect production of Mopar '13 Dart to be limited to just 500 units.
Scroll down for Chrysler's press release teasing the new Mopar model, and we'll be sure to bring you plenty of live images from the show floor in a couple weeks.

Chrysler investing $20M in Toledo plant to support 9-speed auto production

In 2011, Chrysler announced a $72-million investment in its Toledo Machining Plant to modernize production of the eight- and nine-speed torque-converters for automatic transmissions made there. That upgrade work won't be finished until Q3 of this year, but Chrysler has already announced a further $19.6-million investment to increase production capacity for the nine-speeders.
The extra units will be necessary because the nine-speed transmission they'll be mated to is going into three popular models: it will debut on the 2014 Jeep Cherokee, then go into the Chrysler 200 and Dodge Dart. The company predicted that this year alone it would sell 200,000 units equipped with the nine-speed tranny, and it is spending some $374 million in addition to the investment in Toledo to upgrade production capacity for it.
The work attached to this new investment won't begin until Q3 of 2014, and it will be finished by the end of that year. There's a press release below with all the details.

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.