Dodge : Ram 2500 5.7 Hemi Magnum 4 Door Crew Cab Service Bed Truck Low Mileage on 2040-cars

Auto blog

Dodge Challenger R/T Shaker and Mopar '14 Challenger up the retro appeal

The reborn Dodge Challenger might be getting a bit long in the tooth, having been on the market in its current form since 2008, but Chrysler isn't going to give up on its brutish, full-size two-door just yet. For this year's SEMA Show, the Challenger will be getting a new Mopar edition, as well as a retro-cool shaker hood on the 5.7-liter, Hemi-equipped R/T models.
As we mentioned last night, the Shaker Package will cost $2,500, but includes the Super Track Pak (new steering rack, brake linings, upgraded shocks and 20-inch Goodyear Eagle F1 Super Car tires), a $595 option on its own. The shaker hood result in a performance bump of any kind, but the blacked-out, pop-up scoop is a nifty feature that hasn't been seen on a production car since the Ford Mustang Mach 1 in the early 2000s.
The Mopar '14 Challenger (pictured right) follows the cues of previous Mopar Editions, which have included the 2010 Challenger, 2011 Charger, 2012 300 and 2013 Dart. Only 100 Mopar '14 Challengers will be produced, and they'll include the new shaker hood, Mopar's distinctive blue graphics and wheels, and whatever is pilfered from the accessory catalog.

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.

Chrysler readying Hellcat V8 with Viper-like power

A monstrous supercharged V8 engine could be in store for Chrysler and SRT products, if recent rumors are to be believed. Allpar is reporting that the forced-induction V8 - Chrysler's first, if this goes down - could make its debut this summer.
The story goes that the Hellcat would be based on a 6.2-liter Hemi engine, rather than on the existing 5.7- or 6.4-liter versions of the company's vaunted mill. In any case, the general consensus is that the motor will have gobs of power. Modest estimates call for between 500 to 570 horsepower, with some outliers predicting a figure as high as 600 hp. That figure would put the output would place the Hellcat awfully close to that of the 640-hp V10 in the SRT Viper, too. Allpar contends that a slightly lower powered version would allow Chrysler to keep costs below that of the more powerful Ford Shelby GT500, which might be a sweet spot.
The Hellcat could debut in a number of SRT products. SRT versions of the Charger, Challenger and 300 are all up for grabs, as is the rumored SRT Barracuda.