2012 Dodge Ram Slt Crew 4x4 6-pass Park Assist Tow 34k Texas Direct Auto on 2040-cars

Auto blog

Dodge Challenger spied exercising supercharged Hellcat Hemi V8

One of the prime complaints against the Dodge Challenger is that, even in SRT8 guise, its 470 horsepower is responsible for hauling over 4,200 pounds of vehicle. For comparison, the 420 hp in the Ford Mustang GT only has to deal with 3,618 lbs. Things only get worse from there, as the higher-performance variants of both the Mustang and the Chevrolet Camaro are far more powerful than an SRT8 without adding on much heft.
So what is Chrysler to do? The correct answer is add a whole lot more grunt to its hefty two-door and even the odds. That's where the all-new Hellcat engine comes into play. We reported on this engine in May, and suggested that the Hellcat, a supercharged powerplant based on a 6.4-liter V8, would easily generate 500 to 570 hp and could likely arrive boasting more than 600 ponies.
Chrysler's ace in its sleeve has now been spied testing, with a number of Hellcat-equipped Challengers running the potent new engine both in more urbanized areas and under the sun of Death Valley. The hoods on these testers have been raised to accommodate the engine, and that camouflage over the fascias of these prototypes is there to hide a larger air intake. We also note what appears to be a new split grille under wraps. As for power output, our spies are now suggesting a Viper-equalling 640 hp from the Hellcat-equipped cars.

Chrysler recalls AWD 300, Charger, Ram 1500 over ZF transmission

What do the Chrysler 300, Dodge Charger and Ram 1500 all have in common? Yes, they're all Chrysler products, and two of them are based on the same platform. And we're sure you could find more similarities between them all, but the common trait we're looking at here is that, while they all come standard in rear-drive form, they're also available with all-wheel drive. And it's the transmission in those models that's the subject of the latest recall notice issued by the National Highway Traffic Safety Administration.
The output shaft on the eight-speed automatic transmission supplied by ZF to Chrysler for the AWD versions of the 300, Charger and Ram 1500 is apparently prone to fracture. That in the end could leave the vehicle without power and could, according to the NHTSA investigation, increase the chance of a crash. The vehicle could also roll away if even if left in Park without the handbrake applied.
That's why Chrysler is calling in 4,194 examples of those three models from the 2013 model year. Dealers will be responsible for inspecting the transmissions and, where necessary, replace the entire unit. See the full recall notice below for all the details.

Dodge idles Viper production again at Conner Avenue

You've got to hand it to Dodge for having the gumption to put the original Viper into production in the first place. It was, after all, much more of an emotional decision than a practical one, and a move which saw the first production V10 engine placed in a road car - long before the advent of the Lamborghini Gallardo, Audi R8, Porsche Carrera GT or Lexus LFA, not to mention the other Ford, BMW and Volkswagen Group models that used such engines.
It's now been 22 years since the first Viper entered production and the Viper still rolls on several generations later, but we're sad to say that courageous decision has not always been met with overwhelming sales success. In fact parent Chrysler was forced to idle the Conner Avenue plant where the Viper is made back in April due to slow sales. And while production resumed again as planned on June 23, it apparently didn't do the trick.
As a result, Chrysler corporate communications chief Shawn Morgan revealed to Autoblog that the assembly line has been shut down again for another two weeks. The line was up and running for nearly two full work weeks from June 23 until the holiday weekend that started on Thursday, July 3. But instead of coming back online today as planned, it's been idled again for the weeks of July 7 and 14. That means it will be July 21, at the earliest, before the serpentine supercars start slithering down the assembly line at Conner Avenue again. Once it does, however, production is set to resume at the same pace it was before the shutdown.