Find or Sell Used Cars, Trucks, and SUVs in USA

1964 Dodge Dart 270 Convertible With A 273 Motor , . Push Button Trans , on 2040-cars

Year:1964 Mileage:35654
Location:

Allentown, Pennsylvania, United States

Allentown, Pennsylvania, United States

 very good project car that wont cost a fortune . a new top and new interior will help bring back the joyride . turned motor over a few  cranks and stopped before the old fuel got through the system .a little rust underside driver and trunk , seems minor to me. had the car in the family since the early eighties. fun and fast ....

 

Auto Services in Pennsylvania

Yardy`s Auto Body ★★★★★

Automobile Body Repairing & Painting
Address: 5410 Progress Blvd, Mc-Murray
Phone: (412) 854-5070

Xtreme Auto Collision ★★★★★

Automobile Body Repairing & Painting, Automobile Parts & Supplies, Auto Body Parts
Address: 9907 Bustleton Ave, Holland
Phone: (215) 676-2660

Warwick Auto Park ★★★★★

Auto Repair & Service, Used Car Dealers
Address: 700 Furnace Hills Pike, Willow-Street
Phone: (717) 625-3500

Walter`s General Repair ★★★★★

Auto Repair & Service
Address: 195 N Spruce St, Watsontown
Phone: (570) 584-2257

Tire Consultants Inc ★★★★★

Auto Repair & Service, Tire Dealers, Tires-Wholesale & Manufacturers
Address: 560 N Reading Rd, Reamstown
Phone: (717) 733-0388

Tim`s Auto ★★★★★

Used Car Dealers, Wholesale Used Car Dealers
Address: 379 Gravity Rd, Archbald
Phone: (570) 937-9248

Auto blog

Dodge Viper recall requires small-handed mechanics

Fri, 25 Apr 2014

It has been over a year since Chrysler first announced its recall of 3,660 2003-2004 Dodge Vipers because the airbag could suddenly deploy. The repairs are finally beginning, and it appears to be a nightmare for mechanics.
According to the automaker's filing with the National Highway Traffic Safety Administration, the airbag control module can fail, which causes the bag or the seatbelt pre-tensioner to deploy without warning. It took over a year to design the new parts, according to The New York Times. However, Chrysler finally has a new "jumper harness with an in-line diode filter circuit" ready to fix the problem.
The dilemma now moves to the mechanics who have to actually install the part. A 47-step guide from Chrysler explains that the procedure should take about two hours. It's not an easy job, though. Most of the dashboard has to be taken apart, and the instructions include this helpful bit of advice: "Installing the jumper harness and filter box into position is not an easy task. Patience, perseverance, and small hands are required." We wish the best of luck to them. The fix comes just in time for the Vipers to enjoy the summer sun.

Chrysler recalls 1.2 million Ram pickup trucks

Sat, 09 Nov 2013

Chrysler has announced that it will issue three separate recalls that will cover as many as 1.2 million Ram pickup trucks for "steering-system tie rods that may have been misaligned during assembly or steering-system service." The vast majority of these trucks were sold in the United States, though some trucks in Mexico, Canada or overseas will be called in, as well.
The largest of the three recalls covers an estimated 842,400 model-year 2003-2008 Ram 2500 and 3500 trucks. Two smaller campaigns will bring 294,000 model-year 2008-2012 Ram 2500 and 3500 pickups, chassis cabs and 2008 Ram 1500 4x4 Mega Cabs; plus 43,500 model-year 2008-2012 Ram 4500 and 5500 4x4 chassis cabs into the dealer to be checked and repaired if necessary.
This is a very large recall, and Chrysler says it is "casting the net wider than necessary to identify those vehicles that require repair." The automaker estimates that "as many as 726,000 may not need repair."

Chrysler readying Hellcat V8 with Viper-like power

Tue, 21 May 2013

A monstrous supercharged V8 engine could be in store for Chrysler and SRT products, if recent rumors are to be believed. Allpar is reporting that the forced-induction V8 - Chrysler's first, if this goes down - could make its debut this summer.
The story goes that the Hellcat would be based on a 6.2-liter Hemi engine, rather than on the existing 5.7- or 6.4-liter versions of the company's vaunted mill. In any case, the general consensus is that the motor will have gobs of power. Modest estimates call for between 500 to 570 horsepower, with some outliers predicting a figure as high as 600 hp. That figure would put the output would place the Hellcat awfully close to that of the 640-hp V10 in the SRT Viper, too. Allpar contends that a slightly lower powered version would allow Chrysler to keep costs below that of the more powerful Ford Shelby GT500, which might be a sweet spot.
The Hellcat could debut in a number of SRT products. SRT versions of the Charger, Challenger and 300 are all up for grabs, as is the rumored SRT Barracuda.