2012 Toyota Tacoma 4.0l V6 Rwd 6" Lift Banks Exhaust Airaid One Owner Clean L@@k on 2040-cars

Auto blog

How Toyota's 100-year textile history influenced FCV hydrogen fuel cell car

Turns out, Toyota had a surprising ace in the hole when it came to building the new fuel tanks for the FCV hydrogen fuel cell car, which is coming next year. Well before Toyota became the Toyota Motor Company, it was the Toyota Industries Corporation and it made textile looms. This is important because the main structure of the hydrogen tank is wound carbon fiber. When Toyota set out to increase the strength of the tanks to hold hydrogen stored at 10,000 psi (up from 5,000 in the previous tanks), it was able to draw on its 100-year-old history as it designed its car of the future. "A lot of that textile experience came back when we did the tank wrapping." – Justin Ward "We have a lot of experience with textiles," Justin Ward told AutoblogGreen at the 21st World Congress on Intelligent Transport Systems (ITS) in Detroit this week, "and a lot of that textile experience came back when we did the tank wrapping." On top of being able to hold the higher-pressure hydrogen, Toyota's first attempt to build its own hydrogen tank was six times faster than the industry standard, so it saved time and money as well as working better. The company will also be able to inspect its own tanks. Ward is the general manager of powertrain system control at the Toyota Technical Center and hydrogen vehicles are something he knows a lot about. The reason for the stronger, 10,000-psi tanks is because the 5,000-psi tanks only offered around 180-200 miles of range, even with four tanks in the early $129,000 FCHV Highlander hydrogen prototypes. The FCV only has two, but they will able to deliver the 300-mile range that customers told Toyota they wanted. Dropping the number of tanks not only obviously reduced the cost for the tanks themselves but also the number of valves and hoses and other components you need. Despite the benefits of higher compression, going much higher doesn't make sense. 10,000 psi is the "natural progression," Ward said, because "you start to bump up against compression inefficiencies." Think of an air compressor. When hydrogen is produced at a wastewater treatment plant or a reforming site, Ward said, is it at around ambient pressure (14 psi). That has to be raised, using compressors, all the way to 10,000 psi. "That takes energy," Ward said, "and every doubling of pressure adds another doubling of energy needed, so it starts to add up pretty fast if you go too high." Component specifications are also fine at 10,00 psi, but more difficult at higher levels.

Would you pay $17 a month to give your older Ford connectivity?

When it was first introduced in 2007, there was nothing like the original Ford Sync system, since it allowed car owners to connect and use a portable device better than anything that came before it. And because it was a brought-in/tethered and software-based system, Sync leveraged a device's connectivity and was easily updated. It took competitors awhile to catch up: Toyota Entune wasn't available until 2011, and Chevy MyLink didn't roll out until 2012. But now Ford is the one playing catchup since it stuck with the brought-in strategy while most other automakers were quicker to add connectivity via an embedded cellular modem. Ford initially installed 2G/3G modems in its small fleet of electric and plug-in electric vehicles starting in 2012 so that owners could keep tabs on charging. Embedded connectivity came to Lincoln in 2014, and Ford began adding onboard 4G LTE via Sync Connect to select cars starting with the Escape in 2015. To get more cars connected more quickly, last week the automaker rolled out its FordPass SmartLink solution that plugs into the OBD port of 2010 to 2017 model year vehicles. This lets owners retroactively get onboard Wi-Fi, set up a "geo-fence" to keep tabs on a car's location, receive vehicle health reports and allows remote engine starting and door locking/unlocking using a smartphone app, among other features. But to connect older Ford vehicles will cost owners $16.99 a month for two years, not including installation. Ford throws in 1 GB of data or a 30-day trial, whichever comes first, after which owners have to add the vehicle to their Verizon shared data plan, which supplies connectivity for SmartLink, or establish a new account. (Disclosure: Autoblog is owned by Verizon.) By comparison, GM's 4G LTE data plans start at $10 a month for 200 MB and goes up to $30 for 3 GB, and owners can also add a car to an AT&T shared-data plan. But OnStar doesn't have a separate monthly subscription for the embedded modem or an installation charge, and standard features via the RemoteLink Mobile App are free for the first five years of ownership. FCA's Uconnect Access service also uses an embedded modem to provide similar telematics features for $20 per month following a free one-year trial, while a la carte in-car Wi-Fi is offered for $10 per day, $20 per week or $35 per month.

Toyota will race C-HR CUV in 2016 Nurburgring 24 Hours

There won't just be traditional racecars competing in the 2016 Nurburgring 24 Hours; Toyota Gazoo Racing will take the bizarre route of prepping the C-HR crossover for the grueling event. The squad will enter more conventional machines, too, including a Lexus RC and RC F for the race that will run from May 26-29. Details about the C-HR Racing are scant at the moment. "We decided to take on the new challenge of creating ever-better cars using a crossover rather than a pure sports car," the company's announcement said. It makes no mention of the vehicle's specs, but the included photo show the CUV with a more aggressive front fascia, vents along the hood, and a big wing at the rear. The driver lineup includes Masahiko Kageyama, Kumi Sato, and another person to be announced later. Toyota will reportedly introduce the production version of the C-HR at the Geneva Motor Show, and the final one will allegedly carry over the current rakish shape and hybrid powertrain. The company also showed it with Scion badging at the 2015 LA Auto Show to suggest a likely arrival in the US. This year will mark a decade of Gazoo Racing's competition in the 24 Hours of the 'Ring. The squad notably raced the LFA there for several years, but it showed a willingness to bring weirder vehicles too like a Lexus CT 200h in 2011. Nothing has been quite as odd as racing a crossover there, though. Toyota GAZOO Racing Celebrates Decade of Participation in the 24 Hours of Nurburgring with Triple Entry for 2016 Race Toyota City, Japan, January 15, 2016-Toyota GAZOO Racing announces the entry of three vehicles-a Toyota C-HR Racing*, a Lexus RC, and a Lexus RC F-in the 44th 24 Hours of Nurburgring endurance race to be held in Germany from May 26 to 29, 2016. The 24 Hours of Nurburgring plays an important role in Toyota's motorsports activities for building ever-better human resources and vehicles under intense racing conditions. Beginning in 2007, the 2016 event marks the 10th year of Toyota's participation in the race under the banner of GAZOO racing. When asked to look back over the last ten years, team representative Akio Toyoda said, "I remember GAZOO Racing first taking on the challenge of the Nurburgring in 2007 in an Altezza like it was yesterday. There are so many memories running through my mind–the interaction with the roads of the Nurburgring, whose characteristics seem to change with each shift in the weather, the meeting and parting with new and valuable friends.