2022 Toyota Supra Base on 2040-cars

Auto blog

Toyota Yaris Hybrid-R zips in on its way to Frankfurt

Toyota has been known to make some exciting cars over the years, but its hybrids, well... let's just say a Prius appeals to a different kind of buyer. The TS030 Hybrid LMP1, on the other hand, now that's more our speed. And at the Frankfurt Motor Show next week, the Japanese industrial giant will bridge the gap with the concept car you see here. Previewed in bits and pieces along the way, Toyota has now revealed the full details and array of photos of its new Yaris Hybrid-R concept. And what the full picture reveals is a Prius C that's gone to the gym - or more appropriately, the track.
Powering this little pocket rocket is TMG's Global Racing Engine: a 1.6-liter inline-four with direct injection and a Garett turbocharger to drive 300 horsepower to the front wheels through a six-speed sequential gearbox. A pair of electric motors provide an extra 60 hp to each of the rear wheels for a combined output of 420 hp and through-the-road all-wheel drive. A third 60hp electric motor serves as traction control under acceleration and acts as a generator under braking to feed the TS030-derived super capacitor that boasts a higher power density and faster charge/discharge speed than a traditional battery. The system can provide a 40-horse boost for ten seconds in Road mode, or the full 120hp for five seconds in Track mode.
Though based on the three-door Yaris, there'd be no mistaking this for any ordinary econo-hatch. 18-inch TRD alloys with Michelin Pilot Sport Cup tires pack the wheel wells and a wider grille dominates the front fascia, while black and blue trim contrast sharply with the white bodywork. The rear pillar incorporates a quick-fill competition-spec fuel cap, LED daytime running lights illuminate the way and oversized brakes keep it all under control. The interior boasts Recaro racing buckets in black leather and blue Alcantara. There's more to digest in the press release below, but the bottom line is that if this is where Toyota is taking its hybrids, we want to climb into the driver's seat, and we're looking forward to seeing the concept in the flesh next week.

Ford Fusion production scaled back just 3 months after it was accelerated

Three months after kicking off production of the Ford Fusion at its Flat Rock, MI factory, Ford Motor Company is taking steps to trim output in the face of heavily discounted competition from Toyota and a growing supply of vehicles.
The addition of Fusion production in Flat Rock - which also builds the Mustang - was meant to be what pushed the handsome mid-sizer past its arch-nemesis, the Toyota Camry. An extra facility building Fusions was also meant to curb the growing demand for Ford's highly profitable sedan.
But with word that Flat Rock would take "approximately" one extra week off for the holidays combined with an 88-day supply of Fusions - reportedly due in no small part to what Morgan Stanley analyst Adam Jonas called "aggressive discounting of the Camry" - some analysts are now beginning to wonder if Ford may have overextended itself by adding a second Fusion facility to the mix.

Toyota to ramp up Tacoma production in Mexico by 41%

The Toyota Tacoma may be getting on in age, but that isn't stopping the Japanese manufacturer from ramping up production at the pickup's Baja California factory. The Mexican plant will soon be home to another 300 jobs as it increases total capacity by 41 percent. The increase is slated for April 2015.
The move is a curious one, considering the Tacoma's age and the fact that General Motors is preparing what, on the surface, appear to be two very competent challengers. The factory increase could be in preparation for the 2016 Taco (spy photos shown above), which is expected to represent a significant overhaul of the long-serving truck.
Toyota's decision to increase capacity could also be due to the factory building freeze implemented by President Akio Toyoda, according to Automotive News. Toyoda put a hold on new factories until 2016, asking executives to squeeze as much production as possible out of remaining factories before bringing any additional facilities online.