2007 Toyota Solara Se Sport on 2040-cars

Auto blog

Toyota to pay $11 million after trial for fatal Camry crash

Years after Toyota's unintended acceleration fiasco, the company is still making headlines for cars with sticky gas pedals. A federal jury in Minnesota decided yesterday that Toyota should pay $11 million for its role in the crash of a 1996 Camry that resulted in three deaths and sent a man to jail. A stuck pedal caused the Camry of Koua Fong Lee to accelerate uncontrollably and impact an Oldsmobile Cutlass Ciera, killing its driver and his nine-year-old son, and paralyzing a six-year-old girl, who later died of her injuries. Two other passengers in the Olds were seriously injured. Lee spent nearly three years in prison on a charge of vehicular homicide, until the unintended acceleration recall erupted. He filed a motion for a new trial and won, and then joined the suit against Toyota filed by the victims and their families of the 2006 crash that left him imprisoned. The jury found Toyota 60 percent responsible for the accident, with the remaining 40 percent of blame going to Lee. Toyota has denied that the 1996 Camry, which wasn't included in the company's sweeping accelerator pedal recalls, was at fault. Toyota released a statement saying the company respects the jury's decision but believes the evidence clearly showed the vehicle wasn't the accident's cause. The company said it will study the record and consider its legal options. Under Minnesota law, the way the jury allocated fault means Toyota is responsible for paying all damages, minus 40 percent of the amount awarded to Lee, said Lee's attorney, Bob Hilliard. That brings Toyota's total liability to $10.94 million. Lee will receive $750,000 of that total. During the trial, Hilliard, told jurors there was a defect in the car's design. He said the Camry's auto-drive assembly could stick, and when tapped or pushed while stuck, it could stick again at a higher speed. He also accused Toyota of never conducting reliability tests on nylon resin pulleys that could be damaged under heat and cause the throttle to stick. "This is what makes the car go. This is what turns it into a torpedo, a missile, a deadly weapon," Hilliard said during his closing argument. Toyota said there was no defect in the design of the 1996 Camry. The company's attorney, David Graves, suggested that Lee was an inexperienced driver and mistook the gas pedal for the brake. Toyota also noted that Lee's car was never subject to the recalls of later-model Toyotas.

Toyota i-Road is no less strange in the flesh

We've seen plenty of three-wheeled creations in our day, but none quite like the Toyota i-Road Concept. The "personal mobility vehicle" offers seating for two with driver and passenger positioned in a tandem position. While that may sound more like a motorcycle than a car, the closed cockpit means riders don't need a helmet. The design also takes a page from the 2008 Peugeot HyMotion3 Concept with an articulating front suspension that allows the driver to lean through corners thanks to "Active Lean" self-balancing technology. Unlike the funky Pug, however, the i-Road is a fully electric plug-in vehicle.
While there are just five-horsepower on hand from an electric motor, the i-Road should serve up a range of around 30 miles thanks to its lithium-ion battery, and Toyota claims the cells can be topped off in three hours with a "conventional domestic power supply." Sounds majestic. Take in the full press release below.

Toyota getting into 3D printing with i-Road in Tokyo

Think of it as Pimp My Ride for the Japanese green concept car set. Toyota is further publicizing its funky, really skinny, leaning i-Road electric concept vehicle by putting on a contest that, among other things, encourages folks to customize parts of the car's surface via 3D printing. Hey, it is a really small car. Toyota's Open Road Project in Tokyo, which will last about a year and will let about 100 participants work with 10 vehicles, also includes a component that lets contestants find the most creative parking spots by seeking out "small unused spaces with access to plug sockets" (we're sure Tokyo is full of them). What grabbed us, though, was the possibility of printing out panels for a three-wheeled car that's less than eight feet long and less than three feet wide. Earlier this year, we reported that Toyota would add five i-Road vehicles to a Tokyo carsharing pilot project. Toyota's unusual promotions for the admittedly unusual concept two-seater date back to early 2013, when the Japanese automaker featured a video of four i-Roads dancing their way through a sun-kissed Mediterranean village. Meantime, take a look at Toyota's press release below, and get more information on the project here.