2005 Subaru Outback 3.0r L.l. Bean on 2040-cars

Auto blog

2020 Subaru Outback Roof Rack Driveway Test | Double cross

There is only one vehicle on the market with a roof rack system like the 2020 Subaru Outback. Literally everything else has either flush-mounted or raised rails where some form of crossbars are connected with "towers" (OK, so there's whatever you'd call this on the 4Runner TRD Pro). While car manufacturers will sometimes include crossbars, quite often it's left to the accessory catalog or third-party companies such as Yakima and Thule. In any event, keeping crossbars on your car regardless of how they are affixed increases wind noise and can harm fuel economy. They can also sully the view out your sunroof, but that's obviously a lesser concern. The Outback doesn't have to worry about any of that, including buying aftermarket pieces. Its roof rails are the crossbars. Making this transformation could not be easier. Simply lift up on a little tab, pull the rail out of its round socket and swing it over to the other side. Repeat with the other bar. Plug the rail into a socket on the opposite side. Done. You have crossbars.  Compare that to the process of mounting the Yakima Timberline towers and bars on my 2013 Audi Allroad.  Find bars and towers in garage. Move Christmas tree. Find special Yakima screwdriver thingy. Line up bars to roughly the 32-inch gap Yakima products are designed to fit to. Wrap rubber "band" connectors around the raised side rails and tighten two screws with Yakima screwdriver thingy. Repeat three more times. Of course, none of that is especially hard. In fact, it's incredibly easy and intuitive once you've set the bars/towers up to fit your car. It is, however, far more time consuming than what you can accomplish in the Outback. You're less likely to take them off, which again, isn't ideal. Here is another advantage of the Outback's racks. Although other Subarus have these, they are nevertheless unique to the brand. There are sturdy tie down points on each corner of the rail for those times when your rack itself isn't enough. I should note, however, that the new Ford Bronco is available with such tie-down points mounted to the hood. Nifty.  Back to the crossbars. Another potential advantage is that they sit lower to the roof than most crossbars (although something like the Thule AeroBlade Edge comes close). Don't quote me here, but less of a gap between the roof and whatever is above seems likely to be an aerodynamic advantage.

Everything we know about the Subaru BRZ STI

May 30, 2017: It seems an STI-tuned Subaru BRZ was even closer than we thought. Subaru posted to its official Twitter page a teaser image of the upcoming car. It's a shot of the trunk lid with a big STI logo on the endplates. If that weren't enough confirmation of the car, the tweet included the hashtag "#STI." The only other information given was the date of June 8, 2017, and the promise of more information. This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings. May 23, 2017: Spy shots reveal our first look at a new STI-tuned Subaru BRZ, and it will likely come to the US. The reason we say this is that the car was spotted near a Subaru office in Ann Arbor, Michigan. We also know this is an STI badge because we can make out the distinctive logo underneath pieces of tape at the front and back. It features a huge wing that isn't found on any other BRZ, though the body kit appears to be the optional one available on regular models. There aren't any obvious signs of forced induction on the car either. No top-mounted intercooler scoops or front-mounted intercoolers are visible anywhere. We hope Subaru will give this car more power, but we're not optimistic, especially when the last STI-badged BRZ for Japan didn't get any power upgrades. April 1, 2015: Subaru reveals an amazing STI-tuned BRZ concept. Like the Subaru BRZ tS by STI, this STI Performance Concept has a huge rear wing, and subtle, functional-looking aerodynamic parts. Most importantly for BRZ fans, it also has a more powerful engine. Under the hood is a turbocharged 2.0-liter flat-four used by the GT300-class race car. It makes about 300 horsepower and 330 pound-feet of torque. However, Subaru said that it's unlikely a turbocharged model like this will come out soon. We expect that Subaru will first launch a tS-style BRZ in the near future, and possibly introduce a turbocharged BRZ variant with a new generation of the car. Subaru STI Performance Concept | 2015 NYIAS View 24 Photos April 19, 2013: Subaru announces the first STI-tuned BRZ, and it's not quite what we were hoping for. It's called the Subaru BRZ tS, and it has the same naturally aspirated engine, and thus, the same amount of horsepower. It's furnished with suspension upgrades, Brembo brakes, a front spoiler, and on the GT model, a big rear wing. Only 500 units will be made - and they're all for Japan. View 27 Photos

Subaru puts Japanese production on pause in the wake of deadly typhoon

Subaru idled its main factory in Gunma, Japan, in the wake of the deadly typhoon that wreaked havoc on the eastern part of the country. The shutdown is tentatively scheduled to last about a week. Located roughly two hours northwest of Tokyo, the Gunma factory fell silent at the end of the morning shift on October 16, according to Automotive News. The facility wasn't directly affected by the typhoon, but some of its suppliers suffered flood damage. "These suppliers are currently working to normalize their operations with our human and material support as well, but we expect some impairment of their supply of automotive components and parts to Subaru," the firm said in a statement. It didn't name the suppliers, and it didn't identify the parts they make, but it added production should resume on October 25. About 2,500 cars leave the Gunma factory daily, Automotive News learned, so approximately 11,250 vehicles will be delayed by the shutdown.The BRZ, Forester, Crosstrek, and the WRX all come from the facility. It also makes the Impreza, though American-spec models are built in Indiana, and the Levorg, which isn't sold in the United States. Subaru confirmed to Autoblog its plant in Lafayette isn't affected by the storm, which suggests it sources parts from other suppliers. Subaru is the first car manufacturer to idle a factory in the wake of typhoon Hagibis, which killed 77 people when it touched down on October 12, but it might not be last. Suppliers normally work with several carmakers, and Toyota and Mitsubishi are reportedly keeping a very close eye on their parts inventory. Auto News Plants/Manufacturing Subaru