Bj`s Auto Repair / Cape San Blas, Florida

Rating: ★★★

4 years in Business

Auto Repair & Service, Tire Dealers

Address: 772B W Highway 98, Cape-San-Blas

Postal code: 32456

Phone: (850) 229-2886

specializing in measurable marketing through technology

PMG is a diverse network of locations utilized by wealthy consumers created to provide measurable marketing

Categories:

Auto Repair & Service, Tire Dealers

Open hours:

No info

Reviews:

Very Helpful

Drove my custom axle 4x4 to Mexico Beach and had a bearing go out. BJ loaned me tools and pressed my bearings in. Only charged me $15.00. I will look him up when I am in town.

bill.baker.52056 / 4/26/2013

I have used them twice. First ...

I have used them twice. First time by necessity, wife had flat tire. They fixed it immediately at normal price even though it happened as they were closing. Called her the next day to let her know she dropped her credit card and they had it. Next time they diagnosed and gave an estimate for replacing a bad speed senso on a Kia Sorento. When I picked it up they charged *less* than the estimate by $30 and said they th... view moreought the book time Kia estimated for the repair was too high, it did not take them that long. so reduced the labor charge. While I was waiting they fixed a vacationing familys motor home. The customer thought he needed a new starter, but it turned out to be a bad wire at the starter switch. The estimated charge went from "maybe $250?" to $30. They are very honest and competent. If you just drive up, be prepared to wait, they spend most of the time in the shop, and office work is not their strong point. Phones do get answered, so call.

GaryMCarroll / 3/20/2012

I do not recomend anyone going...

I do not recomend anyone going to Bj`s Auto Repair. I took my wheel bearing to be replaced. I even bought my own bearings. All I needed was for the new bearings to be pressed into the wheel hub. I waited 5min just to talk to someone about doing this. After asking if they were able to press the bearings no one would give me a price. The guy behide the desk was on the phone the whole time I was there. At one point he j... view moreust walked away and never came back. I came back later that day to see if my bearings had been pressed, they hadent. I know that pressing bearings does not take that long. I would I have done it myselt but I dont have a press. I went back the next day to pick up my hubs and to pay my bill. They over charched me for 1.5 hours of labor. That is just crazy!! It should not have taken that long. I have bearings pressed into four different wheel hubs that only cost me $30 so why did BJ`s charge me $129.06!!???

Lottiemay / 12/30/2011