2024 Ram Promaster Tradesman on 2040-cars

Auto blog

2017 Ram EcoDiesel trucks hitting dealerships again, finally

If you've been patiently waiting for 2017 Ram EcoDiesel trucks to hit dealerships near you, you're in luck. According to Automotive News, the diesel-powered pickups are now hitting showroom floors after FCA received approval from the Environmental Protection Agency in late July to begin producing them again. And you may want to get in line now, because the EPA has yet to approve the EcoDiesel for the 2018 model year. The EPA, along with the California Air Resources Board, accused FCA in January of 2017 of using eight undeclared pieces of software code in certain Fiat Chrysler diesel vehicles. That, naturally, led to "substantially" higher than allowable levels of nitrogen oxide emissions. The violation applies to about 104,000 vehicles sold between 2014 and 2016. EcoDiesel production was stopped in late 2016. FCA says it's continuing to cooperate with the EPA and CARB. Assuming the two agencies approve the plan, the automaker will recall 2014-2016 Ram and Jeep Grand Cherokee vehicles to install the new code. We'd assume that same updated software will be used in 2018 EcoDiesels, too, again assuming they get EPA approval. Related Video:

Ram recalling 65k trucks for rear-axle heat treating

A problem with the rear axle has promoted Fiat Chrysler Automobiles to recall a selection of Ram trucks. The campaign affects 2015-16 Ram 1500 series trucks – specifically those manufactured between June 17 and September 28, 2015. All told, that amounts to over 65,760 units across the United States. The issue stems, according to the statements below, from the rear axle shaft. Some of those trucks may have not had those axle shafts properly heat-treated, which could cause them to fracture and separate from the wheel. And that, it should go without saying, could lead to a crash. FCA states that most of the vehicles in question are in dealer hands, but while the manufacturer says it is aware of one accident to have resulted from the issue, no injuries have been reported. The owners of the affected vehicles will be notified to bring their trucks in to their local dealership to have them inspected. If necessary, the dealership with replace the rear axle assembly. This recall follows three prior (but unrelated) ones, also issued for Ram pickups, that between them affected well over a million units. Related Video: RECALL Subject : Incorrectly Heat Treated Rear Axle Shaft Report Receipt Date: OCT 15, 2015 NHTSA Campaign Number: 15V661000 Component(s): POWER TRAIN Potential Number of Units Affected: 65,760 Manufacturer: Chrysler (FCA US LLC) SUMMARY: Chrysler (FCA US LLC) is recalling certain model year 2015-2016 Ram 1500 trucks manufactured June 17, 2015, to September 28, 2015. The affected vehicles may have been built with rear axles that were incorrectly heat treated. CONSEQUENCE: If the rear axle shaft was not properly heated treated, it may fracture and a wheel separation could occur, increasing the risk of a crash. REMEDY: Chrysler will notify owners, and dealers will inspect the vehicles and replace the axle assemblies, as necessary, free of charge. The manufacturer has not yet provided a notification schedule. Owners may contact Chrysler customer service at 1-800-853-1403. Chrysler's number for this recall is R59. NOTES: Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov. ### Statement: Heat-treating October 27, 2015 , Auburn Hills, Mich. - FCA US LLC is voluntarily recalling an estimated 65,760 U.S.-market trucks – most of which are in dealer hands – to inspect and replace, as required, their rear axle shafts or rear axles.

The Hemi deserves to die | Opinion

Hi. I'm Byron and I love V8s. I want them to stick around for a long, long time. But not all V8s are created equal, and I will not mourn the passing of the modern Hemi. You shouldn't either. While we may agree that its death is untimely, if you ask me, that's only because it came far too late.  Stellantis’ announcement of its new, turbocharged inline-six that is all but guaranteed to kill off the Hemi V8 has led to quite a few half-baked internet takes. The notion being suggested by some, that automotive media were brainwashed into believing the Hemi was in need of replacement, is so far divorced from reality that I openly guffawed at the notion. Journalists have been challenging Chrysler, FCA and now Stellantis for years to deliver better high-performance engines. The response has always been the same: “Why?” Why replace a heavy V8 with a lighter, all-aluminum one? Why repackage powertrains for smaller footprints and better handling vehicles? Why be better when “good enough” sells really, really well? I too mourn the departure of good gasoline-burning engines, but since when was the Hemi one? HereÂ’s a quiz: Name every SRT model with an all-aluminum engine. TimeÂ’s up. If you named any, you failed. They donÂ’t exist. This isnÂ’t GMÂ’s compact, lightweight small-block, nor is it a DOHC Ford Coyote that at least revs high enough to justify its larger footprint. The Hemi is an overweight marketing exercise that happened to be in the right place at the right time. That time was 2003, when Chrysler was still Chrysler — except it was Daimler-Chrysler and the "merger of equals" was doing a bang-up job of bleeding the company's cash reserves dry while doing virtually nothing to address its mounting legacy costs. "That thang got a Hemi?" was emblematic of the whimsical, nostalgia-driven marketing of the colonial half of the "marriage made in heaven." That was 20 years ago. 20 years prior to that, emissions-choked American V8s were circling the drain faster than a soapy five-carat engagement ring in a truck stop sink.