2022 Ram 3500 Big Horn on 2040-cars

Auto blog

FCA fibbed on sales according to internal report

Following last week's news that Fiat Chrysler Automobiles (FCA) is under investigation by the Department of Justice and Securities and Exchange Commission for allegedly fudging sales figures, a new report in Automotive News says an internal investigation at FCA uncovered misreported sales. According to the AN story, 5,000 to 6,000 vehicles from various FCA brands were reported sold by dealers, but no customers existed for those cars. FCA sales chief Reid Bigland has already put a stop to the practice. One potential reason for the practice was to maintain the company's month-to-month sales increase streak, currently at 75 months. In April, FCA added a lengthy disclaimer to its sales announcements: "FCA US reported vehicle sales represent sales of its vehicles to retail and fleet customers, as well as limited deliveries of vehicles to its officers, directors, employees and retirees. Sales from dealers to customers are reported to FCA US by dealers as sales are made on an ongoing basis through a new vehicle delivery reporting system that then compiles the reported data as of the end of each month. "Sales through dealers do not necessarily correspond to reported revenues, which are based on the sale and delivery of vehicles to the dealers. In certain limited circumstances where sales are made directly by FCA US, such sales are reported through its management reporting system." FCA did not provide comment to Automotive News. Click through for the full story and more details. Related Video: Earnings/Financials Government/Legal Chrysler Dodge Fiat Jeep RAM sales Sergio Marchionne FCA USDOJ reid bigland

500+ hp Stellantis 'Hurricane' I6 previews a world without Hemis

After years of rumored development, Stellantis has revealed its new six-cylinder engine family. The 3.0-liter, twin-turbocharged "Hurricane" I6 will offer V8 power, forced induction torque and six-cylinder efficiency in a package designed to fit into any of the company's North American rear-wheel-drive platforms.  What is "V8 power," exactly? Well, in standard output guise, the new I6 cranks out more than 400 horsepower (the specific figure will vary by application) and 450 pound-feet of torque, while the high-output variant is good for more than 500 horses and 475 lb-ft. The final figures will be dependent on the application. We'll save you a little legwork: In current Ram, Jeep and Dodge products, the 5.7-liter Hemi tops out at about 395 hp and 410 lb-ft, give or take, and the 6.4-liter around 485 hp and 475 lb-ft.    This is a clean-sheet design that is only related to the company's turbocharged four-cylinder by some common measurements. The I6 is exclusively direct-injection (no hybrid/port-injection here) and the two I6 variants share 96 common parts, including the block and oil pan design. The differences are found in their internals, intake plumbing, valvetrain components and the turbochargers themselves. Stellantis is not yet ready to share specs or supplier info for the turbos but says announcements will come from its partners soon.  The standard-output I6 has a compression ratio of 10.4:1 and revs to 5,800 rpm. It will run on regular fuel, albeit with reduced performance; 91 octane is recommended for maximum output. The high-output variant has a compression ratio of 9.4:1 and will rev to 6,100 rpm. That one will require premium. The new I6's advantages go beyond basic power output. Every Hemi family engine currently in production is based on an iron block design, so they're heavy. The aluminum-block I6 shaves weight off the total engine package, even if some of that gets added back thanks to the turbos and their associated plumbing. The standard-output I6 weighs 430 pounds, Stellantis engineers told us; the high-output adds just another 11. Fully dressed 5.7-liter V8s are in the 550-560-pound ballpark, and 6.4-liters close in on 600 pounds.  You may be wondering, "Why a clean-sheet gasoline engine now, when the industry is moving toward battery-electrics?" A valid inquiry, and one Stellantis was prepared to address. While the company will be pivoting to electrification over the next decade, it won't be instantaneous.

Ram forced to build and hold 1500 Classic trucks due to chip shortage

DETROIT — The impact of the global semiconductor shortage on the auto industry spread on Saturday, as Stellantis warned its highly profitable pickup trucks were hit, while Ford said it would cut more U.S. production. Stellantis, the world's fourth largest automaker, said it will build and hold for final assembly its Ram 1500 Classic trucks at its Warren, Michigan, and Saltillo, Mexico, assembly plants. When chips become available, the vehicles will be completed and shipped to dealers. The action will last "a number of weeks," a Stellantis spokeswoman said, declining to reveal how many trucks would be affected. The chip shortage, which has hit automakers globally, stems from a confluence of factors. Carmakers shut North American plants for two months during the COVID-19 pandemic last year and canceled chip orders. Meanwhile, demand for chips surged from the consumer electronics industry as people worked from home and played video games. Now carmakers must compete for chips. Carmakers have repeatedly said they will prioritize chips for their most profitable vehicles, but the impact on the Ram, as well as previous reports by Ford and General Motors of lost or impacted production of their full-size trucks, shows the shortage is hitting companies where it hurts. Stellantis Chief Executive Carlos Tavares said earlier this month the problems might not be fully resolved by the second half of 2021, as some auto rivals have flagged, describing supplies as the "big unknown" for revenues in 2021. Ford said Saturday it will idle its Ohio assembly plant next week, while its Kentucky Truck Plant in Louisville will only work two of three shifts. Both plants will return to full production the week of March 29. The U.S. automaker said the latest action is part of a prior forecast it made that the shortage could hit 2021 profits by $1 billion to $2.5 billion. On Thursday, Ford said it would assemble its flagship, highly profitable F-150 pickup truck as well as Edge SUVs in North America without certain parts and then hold them "for a number of weeks" until they can be completed and shipped, affecting "thousands" of vehicles. It also said it would idle production at plants in Louisville, Kentucky, and Cologne, Germany. Related Video: This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings.