2012 Ram 3500 St Crew Cab Pickup, 4-door 6.7l Ho, 4 Wd, 8' Box, Drw on 2040-cars

Auto blog

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.

2019-20 Ram 2500 and 3500 trucks recalled for bed step that can fail

It hasn't even been a full month since Chrysler issued a recall for 425,588 Ram 1500s, 1500 Classics, and Jeep Compass vehicles due to faulty windshield wipers, yet Ram trucks are already back in the recall news roll. This time, Chrysler has recalled 2019-2020 Ram 2500 and Ram 3500 pickups that have an accessory bed step. NHTSA campaign No. 20V207000, published April 9, 2020, states that, "In certain side loading conditions, the bed step may unexpectedly fail while in use." More specifically, recall documents reveal that certain pressure could crack the the mounting bracket that holds the step in place. This potentially could cause injury.  In total, the recall affects 37,580 vehicles, and the report estimates 100% of those vehicles have the defect. Of the more than 35,000 affected, 25,822 of those are 2019-2020 Ram 2500 pickups, and 11,758 are Ram 3500 pickups.  To remedy the situation, Chrysler will replace all affected bed step support braces for free. Chrysler says it expects the recall to begin May 29, 2020.      Recalls RAM Truck RAM 2500 Ram 3500

2020 Ram 1500's new EcoDiesel horsepower and torque revealed

Following on the reveals of Ford and GM's light-duty diesel full-size pickup truck engines, Ram has finally revealed its second-generation EcoDiesel V6 for the 2020 Ram 1500 and 2019 Ram 1500 Classic. The engine is once again a 3.0-liter V6, but it now makes 260 horsepower and 480 pound-feet of torque. That's an increase of 20 horsepower and 60 pound-feet of torque over the previous engine. Ram notes a number of changes were made to achieve these numbers, including adding a water-cooled variable geometry turbo, reducing compression ratio from 16.5:1 to 16:1, adding lighter pistons, revising the intake ports, and using a new fuel injection system and exhaust gas recirculation system. Those numbers also put the new Ram diesel at the top of its class for torque. Just behind it is the 3.0-liter inline-six in the 2020 Chevy Silverado and GMC Sierra that makes a bit more power at 277 horsepower but less torque at 460 pound-feet. Then there's the 2019 Ford F-150's 3.0-liter V6 that makes 250 horsepower and 440 pound-feet of torque. The Ram engine also hits peak torque at 1,600 rpm, which is sooner than the Ford engine at 1,750 rpm. The Chevy engine's torque arrives even earlier than both at 1,500 rpm. The Ram's maximum towing capacity of 12,560 pounds also tops the F-150 diesel's 11,400 pounds. There are still a number of unknowns regarding the new EcoDiesel engine, though. Ram hasn't announced payload capacity, pricing or fuel economy for the engine. We expect fuel economy will be slightly improved over its predecessor's 20 mpg in the city and 27 on the highway. But we don't know if it will match or surpass the F-150 diesel's 22 mpg in the city and 30 on the highway. All these numbers should be announced closer to the engine's release window of fourth quarter of 2019. The engine will also be available in every single trim and configuration of the 2020 Ram 1500 including the Rebel, which used to be a gas-only trim. The engine will even be available on the 2019 Ram 1500 Classic. This should also be the engine that will soon appear in the Jeep Gladiator and Wrangler.