2014 Ram 2500 Slt on 2040-cars

Auto blog

500+ hp Stellantis 'Hurricane' I6 previews a world without Hemis

After years of rumored development, Stellantis has revealed its new six-cylinder engine family. The 3.0-liter, twin-turbocharged "Hurricane" I6 will offer V8 power, forced induction torque and six-cylinder efficiency in a package designed to fit into any of the company's North American rear-wheel-drive platforms.  What is "V8 power," exactly? Well, in standard output guise, the new I6 cranks out more than 400 horsepower (the specific figure will vary by application) and 450 pound-feet of torque, while the high-output variant is good for more than 500 horses and 475 lb-ft. The final figures will be dependent on the application. We'll save you a little legwork: In current Ram, Jeep and Dodge products, the 5.7-liter Hemi tops out at about 395 hp and 410 lb-ft, give or take, and the 6.4-liter around 485 hp and 475 lb-ft.    This is a clean-sheet design that is only related to the company's turbocharged four-cylinder by some common measurements. The I6 is exclusively direct-injection (no hybrid/port-injection here) and the two I6 variants share 96 common parts, including the block and oil pan design. The differences are found in their internals, intake plumbing, valvetrain components and the turbochargers themselves. Stellantis is not yet ready to share specs or supplier info for the turbos but says announcements will come from its partners soon.  The standard-output I6 has a compression ratio of 10.4:1 and revs to 5,800 rpm. It will run on regular fuel, albeit with reduced performance; 91 octane is recommended for maximum output. The high-output variant has a compression ratio of 9.4:1 and will rev to 6,100 rpm. That one will require premium. The new I6's advantages go beyond basic power output. Every Hemi family engine currently in production is based on an iron block design, so they're heavy. The aluminum-block I6 shaves weight off the total engine package, even if some of that gets added back thanks to the turbos and their associated plumbing. The standard-output I6 weighs 430 pounds, Stellantis engineers told us; the high-output adds just another 11. Fully dressed 5.7-liter V8s are in the 550-560-pound ballpark, and 6.4-liters close in on 600 pounds.  You may be wondering, "Why a clean-sheet gasoline engine now, when the industry is moving toward battery-electrics?" A valid inquiry, and one Stellantis was prepared to address. While the company will be pivoting to electrification over the next decade, it won't be instantaneous.

Fiat Chrysler dumped 40,000 unordered vehicles on dealers

In a move that echoes recent history, Fiat Chrysler has been making more cars and trucks than dealers in the U.S. are willing to accept, with Bloomberg reporting that at one point the automaker had built up a glut of around 40,000 unordered vehicles. That’s led some dealers to accuse FCA of reviving the dreaded “sales bank” accounting practice of obscuring inventory to improve the balance sheet. The company reportedly began building up its inventory of unordered cars this summer despite an industrywide slowdown in sales and an eagerness by some dealers to thin their inventories because rising interest rates are making it more expensive to hold unsold cars. The inventory build-up also coincided with Fiat ChryslerÂ’s efforts to find a merger partner, first with Renault, which fell through, then last monthÂ’s announcement that it will merge with FranceÂ’s PSA Group. FCA denies any such scheme and tells Bloomberg the rising inventory is down to a new predictive analytics system designed to better square supply with demand from dealers that is helping the company save money and narrow the numbers of unsold vehicles. The company recently agreed to pay a $40 million civil penalty to the U.S. Securities and Exchange Commission to settle a complaint that it paid dealers to report fake sales figures over a span of five years. While no one is suggesting that FCA is in dire financial straits — the company saw higher than expected earnings in the third quarter and record profits in North America — the practice has strong historical precedent by Chrysler, which built up bloated inventories in the run-up to its two federal bailouts, in 1980 and 2009. It was also common at GM and Ford during the 2000s, when all three Detroit automakers struggled with excess manufacturing capacity and plummeting sales in the lead-up to the Great Recession. Back in 2012, CFO Magazine wrote about a report that explained automakersÂ’ rationale for the practice and how it works: Say fixed costs for a given factory are $100, and that the factory can make 50 cars. Consumers, however, demand only 10. Under absorption costing, if the company makes all 50 cars, its cost-per-car is $2. If it makes only up to demand, or 10 cars, the cost-per-car is $10. Although each car adds variable costs for steel and other parts, if those costs are low, the company still has an incentive to make more cars to keep the cost-per-car down.

Detroit Three's lucrative pickup war intensifies as Ram makes big gains

DETROIT — The battle for profits from sales of large pickup trucks is intensifying among the Detroit Three automakers as sales of small cars in the United States shrivel. For decades Ford has had the single best-selling truck brand in its F-Series trucks. General Motors' Chevrolet brand was a solid No. 2, and Fiat Chrysler Automobiles' Ram was a distant third. Now, that hierarchy may be in flux. Sales figures for December and the fourth quarter released on Thursday show Ram tied with GM's Chevy for the No. 2 spot, as sales of the redesigned Ram pickup surged, fueled in part by demand for an optional 12-inch (30.48 cm) dashboard screen. Chevy not long ago held second place to Ford by a wide margin. GM executives said on Thursday they are bullish on their new GMC and Chevy trucks for 2019.Related: How the Detroit Three's pickups compare on paper 2019 Ram 1500 Laramie review 2019 Chevy Silverado 2.7L four-cylinder review 2019 Ford F-150 2.7L EcoBoost review "There's no doubt this segment (pickup trucks) is one of the epicenters of the auto wars," said Sandor Piszar, director of marketing for Chevrolet at GM. "It's been that way forever, and we wouldn't have it any other way." On Wall Street, investors give electric car leader Tesla a higher valuation than any of the Detroit automakers. But in the nation's heartland, big pickups remain far more popular and profitable than any electric car — and most other consumer vehicles of any kind. Large pickups generate at least $17,000 a vehicle in pretax profit for GM, the company has indicated in disclosures to investors. By contrast, many Detroit Three sedans are so unprofitable, their manufacturers have decided not to build them anymore. 'Hotly contested' Sustaining sales and pricing in the large-pickup segment will be critical in a year when most forecasters expect overall U.S. car and light truck sales to fall. Ford's U.S. sales chief, Mark LaNeve, on Thursday called the F Series "the backbone of our franchise" during a conference call, and added the "segment will continue to be strong, but hotly contested" in 2019. Automakers are banking on pickup truck sales to stay strong even if U.S. interest rates continue to rise. Rising interest rates translate into higher monthly car payments and are expected to deter some buyers in 2019. GM has said 27 percent of Chevrolet and GMC trucks — which can haul trailers by day and substitute for a luxury sedan by night — sell for more than $55,000.