Sport New 5.7l 50-state Emissions System Class Iv Receiver Hitch on 2040-cars

Auto blog

More Ram trucks recalled over tailgate issue

Almost a year ago Fiat Chrysler recalled roughly 1.6 million Ram trucks over an issue with the locking power tailgate. The actuator limiter tab for the power locking mechanism could fracture, which would permit the actuator's lock-rod control to move beyond its limits. That would pull the locking rods open, thereby allowing the tailgate to open at any time. The 2018 recall covered Ram 1500, 2500, and 3500 pickups from the 2015 to 2017 model years, with the five-foot-seven and six-foot-four beds and the power locking tailgate option. Trucks with eight-foot beds, and those with manual-locking tailgates, were excluded. The trucks with eight-foot beds have been added to the recall as of earlier this month, putting 410,351 more trucks in the pool. According to Consumer Reports, Ram redesigned the locking assembly on the other two shorter bed sizes for trucks built after August 2, 2017, which was the end of the 2017 model year. But the eight-foot long-bed trucks didn't get the redesigned part until April 2, 2018 for some reason, making all eight-foot-bed pickups from the 2015 model year to April 1, 2018 part of the recall equation. FCA says it's not aware of any accidents or injuries because of the issue. The company plans to notify owners on June 28. The paperwork filed with the National Highway Traffic Safety Administration doesn't advise owners to stop driving the trucks, but nor does it instruct owners on how to address the problem in the meantime. Sounds like bungee cords might be the go. The fix is estimated to take 30 minutes at the dealer and entails removing the tailgate cover and installing a stop block to prevent the locking actuator's pivot arm from traveling too far. FCA says it will reimburse owners for any other repairs made to address the problem. Meanwhile, owners can contact Fiat Chrysler Automobiles customer service at 800-853-1403, and refer to FCA's number for this recall, V44. The NHTSA campaign number is 19V-347. Last year's recall comes under FCA number U74, and NHTSA campaign number 18V-486. Ram's not alone on this field. The NHTSA continues to investigate the 2017 Ford Super Duty pickups for a similar issue.

2020 Ram 1500's new EcoDiesel horsepower and torque revealed

Following on the reveals of Ford and GM's light-duty diesel full-size pickup truck engines, Ram has finally revealed its second-generation EcoDiesel V6 for the 2020 Ram 1500 and 2019 Ram 1500 Classic. The engine is once again a 3.0-liter V6, but it now makes 260 horsepower and 480 pound-feet of torque. That's an increase of 20 horsepower and 60 pound-feet of torque over the previous engine. Ram notes a number of changes were made to achieve these numbers, including adding a water-cooled variable geometry turbo, reducing compression ratio from 16.5:1 to 16:1, adding lighter pistons, revising the intake ports, and using a new fuel injection system and exhaust gas recirculation system. Those numbers also put the new Ram diesel at the top of its class for torque. Just behind it is the 3.0-liter inline-six in the 2020 Chevy Silverado and GMC Sierra that makes a bit more power at 277 horsepower but less torque at 460 pound-feet. Then there's the 2019 Ford F-150's 3.0-liter V6 that makes 250 horsepower and 440 pound-feet of torque. The Ram engine also hits peak torque at 1,600 rpm, which is sooner than the Ford engine at 1,750 rpm. The Chevy engine's torque arrives even earlier than both at 1,500 rpm. The Ram's maximum towing capacity of 12,560 pounds also tops the F-150 diesel's 11,400 pounds. There are still a number of unknowns regarding the new EcoDiesel engine, though. Ram hasn't announced payload capacity, pricing or fuel economy for the engine. We expect fuel economy will be slightly improved over its predecessor's 20 mpg in the city and 27 on the highway. But we don't know if it will match or surpass the F-150 diesel's 22 mpg in the city and 30 on the highway. All these numbers should be announced closer to the engine's release window of fourth quarter of 2019. The engine will also be available in every single trim and configuration of the 2020 Ram 1500 including the Rebel, which used to be a gas-only trim. The engine will even be available on the 2019 Ram 1500 Classic. This should also be the engine that will soon appear in the Jeep Gladiator and Wrangler.

2019 Ram 1500 spotted with split tailgate

A little over three years ago, we discovered a patent from Fiat-Chrysler that showed a pickup truck tailgate that not only dropped down like a normal one, but was also split into two swing-out halves. It appears to be a reality now, since one of the Ram 1500 prototypes shown above has just such a tailgate. The tailgate above does look a bit different from the one shown in the patent drawings. For one thing, it's not a 50/50 split in the middle. Instead, Ram seems to have opted for something like a 60/40, or maybe 70/30 split. We're not sure exactly why this is, but there could be a few advantages. For one, It probably allows for the use of the same or nearly the same handle as on conventional Rams, as well as the same badging. For another, if the tailgate operates as described in the patent, it might be possible to open just one side without opening the other, and having the shorter piece could offer some flexibility in tight areas where a larger half couldn't open fully. Testing alongside the split tailgate truck were some other Ram 1500s that had their tailgates completely covered. They did reveal some other cargo management features that should show up on the production truck, such as a return of the RamBox bedside storage compartments. One of the trucks also revealed some ribbed bedsides that would allow the positioning of a cargo divider just about anywhere in the bed. We expect to see the new Ram 1500 to be fully revealed at the Detroit Auto Show in January. In the meantime, you can check out what we believe the production truck will look like, as well as everything we know about it, here. Related Video: