2019 Ram 1500 Big Horn on 2040-cars

Auto blog

Ram 1500 TRX too tame for you? Hennessey cranks its Hemi V8 to 1,012 horsepower

Ram captured the top spot on the horsepower podium when it released the Hellcat-powered 1500 TRX in 2020. The truck's 702-horsepower output places it comfortably ahead of the Ford F-150 Raptor, at least for now, but American tuner Hennessey saw plenty of room for improvement. It added over 300 horses to the TRX's cavalry. Hennessey is a master in V8-ology, so it was only a matter of time before it injected more power into the TRX. It announced two models named Mammoth 900 and Mammoth 1000, respectively, and each number vaguely corresponds to the V8's new output. The 900's 6.2-liter produces 912 horsepower and 873 pound-feet of torque, increases of 210 and 223, respectively, compared to the standard TRX. Hennessey achieved these figures by upgrading the supercharger pulleys and making relatively basic changes to the intake and exhaust systems. Stepping up to the 1000 unlocks 1,012 horsepower and 969 pound-feet of torque, numbers that give the 6,300-plus-pound truck the uncanny ability to reach 60 mph from a stop in 3.2 seconds. It flies through the quarter mile in 11.4 seconds at 120 mph. Building a pickup with supercar-like acceleration required installing a bigger, 2.65-liter supercharger, adding high-flow fuel injectors, and recalibrating the ECU. Intake and exhaust modifications are on the menu, too. Surprisingly, it doesn't sound like Hennessey made significant internal changes to the engine or to the transmission, which suggests the standard components can handle a massive amount of power. Context is useful here. Released in 2013, the fifth and final generation of the Dodge-turned-SRT-turned-Dodge again Viper took 3.3 seconds to sprint from zero to 60 mph, and it logged an 11.5-second quarter-mile time. Previewed in a computer-generated sketch, the Mammoth 1000 (shown above) also receives 20-inch wheels wrapped by 35-inch off-road tires, a 2.5-inch suspension lift, custom bumpers on both ends, extra LEDs up front, electronic fold-out steps, plus an array of model-specific emblems. Inside, Hennessey added a numbered plaque. 200 units of the Mammoth 1000 will be available for the 2021 model year, and pricing starts at $135,350 including the cost of the donor truck (which carries a base price of $71,790) and a warranty valid for two years or 24,000 miles. Put another way, you get 30.6% more power than stock for about 40% more money.

Chrysler recalling 2009-2010 Ram 1500, Dodge Dakota pickups over axle pinion nut

Chrysler is issuing a recall for the 2009 and 2010 Ram 1500 and Dodge Dakota pickup trucks due to improper installation of the rear axle pinion nut. According to the National Highway Traffic Safety Administration, a total of 44,300 trucks are affected by the recall, and there have been 12 confirmed incidents including one crash.
The issue on both trucks is that the pinion nut is loosening on some trucks due to a lack of thread adhesive, and it is causing the rear axle to lock up resulting in loss of vehicle control. NHTSA's recall notice says that eight incidents occurred at speeds over 35 miles per hour and most also exhibited driveshaft failures as well since the loss of the pinion nut would cause the gear to separate from the driveshaft. In one complaint, the driveshaft separated from the rear axle and punctured the gas tank.
Chrysler will begin sending out recall notices to affected owners in November, but scroll down to see the official NHTSA notice.

Ram trucks set for export to Australia, New Zealand

Looking across the Pacific at Australia's car-based utes is always a little exciting because it's a glimpse at a land where models not unlike the classic Chevrolet El Camino survive. Now, the Aussies are about to see how the US builds big trucks thanks to a deal to import the Ram 2500 and 3500 into the country. This new market entry comes about thanks to a deal between Ram and the New Zealand importer of FCA products, and once across the ocean, the trucks are converted to right-hand drive. The automaker has "worked closely with our engineers to produce a vehicle that is as close to an official factory right-hand-drive vehicle as it can be without it having actually run down the factory production line," Clyde Campbell, co-owner of Fiat Chrysler New Zealand," said to Drive. The first batch of pickups is set to go on sale to Kiwis and Aussies in October, but further details about them aren't disclosed yet, including available powertrains and price. Drive estimates the Ram 3500 to retail for over 100,000 Australian dollars ($76,000). The trucks are being aimed at those with heavy loads to haul like industrial companies or people with large horse trailers. These might not be the last two Ram models to make it Down Under, either. According to Drive, the New Zealand importer is working to strike a similar deal to bring the Ram 1500 across the Pacific in the future.