2001 Pontiac Firebird Trans Am 5.7l V8 Auto 1 Owner Low Mileage Leather on 2040-cars

Auto blog

GM recalling another 1.3-million cars over power steering woes

When it rains, it pours. General Motors has announced yet another major recall, covering 1.3 million units in the American market over concerns that the power steering could suddenly fail. As reported by The Detroit News' David Shepardson, GM has now recalled nearly ten times as many cars as it did all of last year.
It's important to note that should this problem arise in these cars, the steering won't fail completely, however, power steering could suddenly stop functioning. Manual steering would still be possible, but as GM says, there's an increased risk of accidents, particularly at lower speeds.
Like the ignition switch recall, this latest problem covers a wide range of vehicles from Chevrolet, Saturn and Pontiac. Normally, we'd give you the full rundown in paragraph form, but the variety of models and model years means a list is just easier. So, have a look, directly from GM's press release:

Junkyard Gem: 2007 Pontiac G6 GT Convertible

GM's Pontiac Division sold its first convertibles during the 1927 model year (just a year after the division's creation), then proceeded to offer memorable drop-tops for most of the following 83 years. The best-selling convertible to bear Pontiac badges during our current century was the retractable-hardtop-equipped G6, available from the G6's introduction in 2006 through the second-to-last model year of 2009 (the Sunfire convertible was available just through 2000, while the Firebird convertible vanished with the demise of the slow-selling Firebird itself after 2002). Here's one of those G6 GT convertibles, found in a Denver-region boneyard after a crash ended its driving career. Mashed right front, popped airbags. This sort of damage might have been worth repairing in 2009, but not today. The 2007 G6 was available as a coupe, sedan, or convertible. All the convertibles had the GT trim level and the 3.5-liter V6 and its 224 horsepower. The MSRP on this car was $28,750 (about $42,325 in 2022 dollars), making it the most expensive G6. The power hardtop roof folded up into the trunk, leaving 1.8 cubic feet of trunk storage space with the top down. This Karmann-designed roof system made the interior much quieter than that of a traditional soft-top convertible. All G6s were built at Orion Assembly in Michigan, where Chevy Bolts are born today. The G6 was built through the 2010 model year, making it one of the very last Pontiac models (the Vibe also made it to 2010, though it was really a Toyota Matrix). In hindsight, 2007 turned out to be an ominous year for GM. 

Gordon Murray, F1-driven production and .. the Pontiac Fiero

Gordon Murray's design and engineering chops are unquestionable. But does his carmaking approach owe something to the short-lived Pontiac Fiero, a scrappy little car program that emerged from GM against serious resistance? Murray had a Formula One career that ran from 1969 to 1991, with stints at Brabham ('69 to '86) and McLaren ('87-'91), that resulted in several shelves' worth of trophies for the cars he was instrumental in designing. He moved on to McLaren Cars, the consumer side of things, where, during his tenure from 1991 to 2004, he helped design the McLaren F1 and the Mercedes-Benz SLR McLaren, two cars that took learnings from his two decades in Formula One. What do all of these cars have in common? Three things: They are light. They were built in limited numbers. And they were (and are) exceedingly expensive—when the McLaren F1 debuted in 1994, it stickered at $815,000. Murray went on to establish Gordon Murray Design in 2007. GMD has created some interesting concept vehicles, such as the diminutive T.25 city car (94.5 inches long, 51.1 inches wide and 55.1 inches high), and the OX, a lightweight truck for the developing world that packs like an IKEA shelf and is working toward realization through a worthy crowdfunding campaign established by the Global Vehicle Trust. Now he has created a vehicle manufacturing company, Gordon Murray Automotive, that will use manufacturing methods that he developed under the moniker "iStream." Unlike a unibody, there are the "iFrame," a cage-like construction made with metallic components, and the "iPanels," which are composite. The panels aren't simply a decorative skin; they actually provide structure to the vehicle. Presumably this has something of the F1 monocoque about it. Going back to the three elements, (1) this arrangement results in a vehicle that can be comparatively light; (2) Murray has indicated that his manufacturing company will be doing limited-run production; and (3) to launch Gordon Murray Automotive they are going to be building a flagship model, about which Murray said, "With our first new car, we will demonstrate a return to the design and engineering principles that have made the McLaren F1 such an icon." Which seems to imply that it will be on the pricey side. According to the company's verbiage, "iStream forges an entirely new production method that defies conventionality with its Formula One-derived construction and materials technologies." It also sounds a whole lot like ...