2004 Pontiac Gto Base Coupe 2-door 5.7l on 2040-cars

Auto blog

Junkyard Gem: 1968 Pontiac Catalina sedan

During the late 1960s, General Motors ruled the American car landscape, growing so dominant that the federal government considered antitrust action to break up the company. The General offered sporty Corvettes and muscular GTOs and rugged pickups and opulent Fleetwoods, sure, but the fat part of the sales numbers came from the bread-and-butter full-sized sedans and coupes, which boasted superior engineering and modern-looking styling; in 1967 alone, the Chevrolet Division moved 972,600 full-sized cars, and that's not even counting the 155,100 full-sized Chevy station wagons that year. Pontiac, Buick and Oldsmobile sold the same big cars with division-specific engines and bodywork, and they flew off the showroom floors. For 1968, the entry-level full-sized car from Pontiac was the Catalina, and I've found an example of the most affordable version of the most affordable big Pontiac for 1968, discarded in a northeastern Colorado wrecking yard about 50 miles south of Cheyenne, Wyoming. A '68 GM full-sized coupe, convertible, or even a four-door hardtop might be worth the cost and effort of a restoration, but a no-options base-trim-level post sedan with rust and plenty of body filler just won't get many takers these days. Like so many vehicles that sit outside for decades on the High Plains, this one is full of rodent nests. I wouldn't want to work on the interior of this car without a respirator and a lot of work with a shop-vac, because hantavirus is a significant danger in these parts. Alfred Sloan's plan to offer a stepladder of prestige for GM buyers, in which your first new car was a Chevrolet and you moved up through Pontiac, Oldsmobile, and Buick until you became sufficiently prosperous for Cadillac ownership, worked brilliantly for decades. In 1968, the Catalina was a notch above its Impala sibling on the Snob-O-Meter, with the sedan starting at $3,004 (about $22,600 in 2019 dollars). In fact, the V8-equipped 1968 Chevrolet Impala sedan listed at $3,033, and the Oldsmobile Delmont 88 went for $3,146, so the lines were beginning to blur between the relative positions of the lower-end GM divisions by this time. The base engine in the 1968 Catalina was a 400-cubic-inch (6.5 liter) V8 rated at 265 horsepower and enough torque to tow an aircraft carrier.

GM Recalling Another 2.7 Million Vehicles In Five Separate Campaigns

The recalls keep rolling in from General Motors, evidently keen to avoid repeating the mistakes of the ignition-switch debacle and clean house. This time they're all coming at once, with five separate recalls announced together covering approximately 2.7 million vehicles. The largest of the five actions involves over 2.4 million units of the previous-generation Chevrolet Malibu and Malibu Maxx, Pontiac G6 and Saturn Aura in order to fix brake light wiring harness, which have been found to be susceptible to corrosion. The recall is separate from the 56k Aura sedans which GM recently recalled over faulty shift cables, not to mention the previous massive recall of 1.3 million vehicles – some of them the same models – but appears to have resulted from the National Highway Traffic Safety Administration investigation that started with the G6 almost a year ago. The second-largest campaign involves the 2014 Chevy Malibu, specifically those fitted with GM's 2.5-liter engine and stop/start system, approximately 140,000 examples of which has been found to have problematic brakes. The issue does not appear to be connected to the recall of 8k Malibu and Buick LaCrosse sedans (also involving brake woes) which we reported upon last week. Four crashes have been reported in such models, but GM admits it's not yet clear if the problem was a contributing factor in the accidents. A further 112k Corvette models from the 2005-2007 model years are being called in for problems with their low-beam headlamps resulting from a flexing relay control circuit wire that's not meant to bend. GM says it is "aware of several hundred complaints" about this issue, but notes that there have been no reports of related accidents. In addition, over 19k examples of Cadillac CTS from the 2013 and 2014 model years are being recalled over windshield wipers that might not work after a jump start. Finally, GM is also bringing in 477 examples of its 2014 Chevy Silverado, Tahoe and GMC Sierra (though not the Yukon) to fix a problem with a tie rod in its steering rack. As ever, all recall repairs will be performed free of charge, and GM is now estimating that recall-related actions this quarter will result in an estimated $200-million charge against its second-quarter earnings. Read the full announcement from GM below for further details.

Gordon Murray, F1-driven production and .. the Pontiac Fiero

Gordon Murray's design and engineering chops are unquestionable. But does his carmaking approach owe something to the short-lived Pontiac Fiero, a scrappy little car program that emerged from GM against serious resistance? Murray had a Formula One career that ran from 1969 to 1991, with stints at Brabham ('69 to '86) and McLaren ('87-'91), that resulted in several shelves' worth of trophies for the cars he was instrumental in designing. He moved on to McLaren Cars, the consumer side of things, where, during his tenure from 1991 to 2004, he helped design the McLaren F1 and the Mercedes-Benz SLR McLaren, two cars that took learnings from his two decades in Formula One. What do all of these cars have in common? Three things: They are light. They were built in limited numbers. And they were (and are) exceedingly expensive—when the McLaren F1 debuted in 1994, it stickered at $815,000. Murray went on to establish Gordon Murray Design in 2007. GMD has created some interesting concept vehicles, such as the diminutive T.25 city car (94.5 inches long, 51.1 inches wide and 55.1 inches high), and the OX, a lightweight truck for the developing world that packs like an IKEA shelf and is working toward realization through a worthy crowdfunding campaign established by the Global Vehicle Trust. Now he has created a vehicle manufacturing company, Gordon Murray Automotive, that will use manufacturing methods that he developed under the moniker "iStream." Unlike a unibody, there are the "iFrame," a cage-like construction made with metallic components, and the "iPanels," which are composite. The panels aren't simply a decorative skin; they actually provide structure to the vehicle. Presumably this has something of the F1 monocoque about it. Going back to the three elements, (1) this arrangement results in a vehicle that can be comparatively light; (2) Murray has indicated that his manufacturing company will be doing limited-run production; and (3) to launch Gordon Murray Automotive they are going to be building a flagship model, about which Murray said, "With our first new car, we will demonstrate a return to the design and engineering principles that have made the McLaren F1 such an icon." Which seems to imply that it will be on the pricey side. According to the company's verbiage, "iStream forges an entirely new production method that defies conventionality with its Formula One-derived construction and materials technologies." It also sounds a whole lot like ...