White 1965 Pontiac Lemans on 2040-cars

Auto blog

Junkyard Gem: 2010 Pontiac Vibe

Just over a month before filing for Chapter 11 bankruptcy in June 2009, General Motors announced that the 83-year-old Pontiac Division would be "phased out" by the end of 2010. Only three Pontiac vehicles were sold as 2010 models in the United States: the Solstice, Vibe and G6 (new G3s were sold here during 2010 but they were all 2009 models, while the G5 was available as a 2010 model only in Canada and Mexico). Today's bit of junkyard automotive history is one of the very last Vibes ever built, found in a yard near Denver, Colorado. This car is significant not just as one of the final vehicles to bear Pontiac badges but also as one of the last cars built by the New United Motor Manufacturing Incorporated GM-Toyota joint venture in California, better known as NUMMI. The NUMMI factory began life as GM's Fremont Assembly, which built its first vehicle (a C-Series pickup) in 1963 and closed in 1982 after building its final vehicle (an Oldsmobile Cutlass Ciera). Rebooted as NUMMI, the first 1985 Chevrolet Nova (an Americanized AE82 Toyota Corolla Sprinter) rolled off the line in December of 1984. A quarter-century and better than eight million vehicles hence, NUMMI shut down production after its last Corolla was finished on April 1, 2010. While there was some noise about the Oakland Athletics building a new stadium on the site at the time, Tesla ended up buying most of the site soon after that. Tesla now builds more vehicles per year there than NUMMI ever did. The Vibe was co-developed with Toyota and based on the same platform as the ninth-generation Corolla. The Toyota Matrix was mechanically identical and was built in Canada, while the Japanese-market version (known as the Toyota Voltz) was built on the same NUMMI line as the Vibe and shipped across the Pacific. The Vibe/Matrix/Voltz got a redesign for the 2009 model year, but few noticed due to all the turmoil in the GM world at the time. The final Vibe was built in August 2009. This car was built in July of 2009, just before the end. It was living in West Texas just prior to coming to Colorado. El Paso is about a ten-hour drive from this car's current location. Once in the Centennial State, it got parked somewhere it shouldn't have been and ended up being auctioned to Pick Your Part. An occupant of this Vibe had time to sample some of the local agricultural products before that happened.

GM reintroduces Tripower name in the worst way possible

The story of General Motors' use of the Tripower moniker begins way back in 1957, when Semon E. "Bunkie" Knudsen, then General Manager of GM's Pontiac division, directed his engineers to inject more performance into his brand's line of V8-powered automobiles. Fuel injection was an option, but hot rodders flocked instead to Tri-Power (marketed way back when with a hyphen), which grafted a trio of two-barrel Rochester carburetors onto a single intake manifold. A legend was born. And that legend was born of performance. At idle and when full power wasn't required, Pontiac's Tri-Power system used just the middle carburetor, which helped make the setup easier to tune. Depending on the year and model, either a vacuum system or a mechanical linkage opened up the two outer carbs, thereby switching from two barrels to six, and allowing the engine to take in more fuel and air. And it was an easy marketing win – six barrels is better than four barrels, right? Because performance! So, when news filtered in that GM has resurrected the Tripower name, those of us who grew up attending classic car shows and wrenching on old Pontiacs did a double-take. And then we all collectively sighed. Turns out that today's Tripower refers to a trio of fuel-saving measures that include cylinder deactivation, active thermal management, and intake valve lift control, according to Automotive News. And, at least for now, it applies to GM's line of fullsize trucks powered by a 2.7-liter turbocharged four-cylinder engine. We're all for saving fuel whenever possible. And we have zero say in how any automaker chooses to market its products and technologies. But, we'll offer our two cents anyway: Relaunching a storied name from the past is fine. Relaunching a storied name from the past while completely overlooking the reasons the name got famous in the first place is only going to irritate the people who remember the name in the first place. Couldn't they just call this new technology package something else? Related Video: News Source: Automotive NewsImage Credit: Getty Green Marketing/Advertising Chevrolet GM Pontiac Automotive History Truck chevrolet silverado

2013 Hurst Edition Trans Am

No, you didn't read our title wrong. This is a 2013 model year Trans Am, and yes, that is a Pontiac logo affixed to the front of the car. But don't bother dialing up your local General Motors dealership just yet. This is the new Hurst Edition Trans Am created by the Trans Am Depot located in Tallahassee, FL. Having spent a number of years restoring early Trans Am models, the crew at Trans Am Depot finally did what many Pontiac enthusiasts wish GM would have done - create a modern Trans Am using the fifth-generation Chevrolet Camaro.
As the former owner of a 1977 model, I've been wanting to check out Trans Am Depot ever since I first saw the company have American Choppers build a trio of motorcycles inspired by its Pontiac remakes. So I jumped at the chance to head to Florida's capital city to visit the shop and drive its latest creation, the new Hurst Edition Trans Am. As a collaboration with Hurst, this car made its debut at the 2012 SEMA Show and then popped up again on our radar with a cheesy yet perfectly fitting video back in March.
Driving Notes