2004 Nissan Armada on 2040-cars

Auto blog

Is the skill of rev matching being lost to computers?

If the ability to drive a vehicle equipped with a manual gearbox is becoming a lost art, then the skill of being able to match revs on downshifts is the stuff they would teach at the automotive equivalent of the Shaolin Temple. The usefulness of rev matching in street driving is limited most of the time – aside from sounding cool and impressing your friends. But out on a race track or the occasional fast, windy road, its benefits are abundantly clear. While in motion, the engine speed and wheel speed of a vehicle with a manual transmission are kept in sync when the clutch is engaged (i.e. when the clutch pedal is not being pressed down). However, when changing gear, that mechanical link is severed briefly, and the synchronization between the motor and wheels is broken. When upshifting during acceleration, this isn't much of an issue, as there's typically not a huge disparity between engine speed and wheel speed as a car accelerates. Rev-matching downshifts is the stuff they would teach at the automotive equivalent of the Shaolin Temple. But when slowing down and downshifting – as you might do when approaching a corner at a high rate of speed – that gap of time caused by the disengagement of the clutch from the engine causes the revs to drop. Without bringing up the revs somehow to help the engine speed match the wheel speed in the gear you're about to use, you'll typically get a sudden jolt when re-engaging the clutch as physics brings everything back into sync. That jolt can be a big problem when you're moving along swiftly, causing instability or even a loss of traction, particularly in rear-wheel-drive cars. So the point of rev matching is to blip the throttle simultaneously as you downshift gears in order to bring the engine speed to a closer match with the wheel speed before you re-engage the clutch in that lower gear, in turn providing a much smoother downshift. When braking is thrown in, you get heel-toe downshifting, which involves some dexterity to use all three pedals at the same time with just two feet – clutch in, slow the car while revving, clutch out. However, even if you're aware of heel-toe technique and the basic elements of how to perform a rev match, perfecting it to the point of making it useful can be difficult.

Junkyard Gem: 1996 Nissan Quest XE with 338,549 miles

When I hit the junkyard, I always look for vehicles with impressive final figures showing on their odometers. I find so many Hondas and Toyotas with better than 300,000 miles that I don't consider them especially noteworthy (the exception being super-low-spec cheap models, such as a Tercel or Civic VX), and it goes without saying that the bar is quite high for Mercedes-Benzes as well. It has been surprisingly difficult to find discarded Nissans that made it past the 300k mark; today's Junkyard Gem is just the fourth I've documented. The highest-mile junked Nissan I'd found prior to today's minivan is a 1994 Maxima with 364,238 miles, followed by a 1987 Maxima with 341,176 miles and a 1986 200SX with 309,222 miles. Keep in mind that Nissan didn't go to six-digit odometers on most of its US-market cars until the early 1980s, and then went to tough-to-read-in-the-junkyard electronic odometers in the early 2000s; this means the pool of potential high-mile Nissans is limited to about the 1983-2000 range of model years. Ford has just as much right to claim credit to this van's impressive mile total as does Nissan, since the Quest was a collaboration between Ford and Nissan that also produced the Mercury Villager; this van was built by Ford at the Ohio Assembly plant. The Quest/Villager platform was derived from the Maxima's, and the engine is pure Nissan: a 3.0-liter VG30 V6 rated at 151 horsepower. The only transmission available in the first-generation (1993-1999) Quest/Villager was a four-speed automatic. This one appears to have been sold new at Landrum Nissan in Pueblo. The rear glass has been painted flat black, possibly to keep prying eyes from seeing valuable cargo. The rear seats are long gone, so this van probably hauled cargo for much of its long life. The front interior seems to be in good shape. Why is this van here? There's body damage on the left rear and right front, suggesting a crash that may have bent the suspension past the worth-fixing threshold. Perhaps the crinkled metal just made this van too unsightly, or maybe some powertrain problem was the culprit. This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings. It's time to expect more from a minivan. This content is hosted by a third party. To view it, please update your privacy preferences. Manage Settings. It's all fun and games until the toddler takes the wheel.

Kaz and Shiro talk Gran Turismo 7 details, Titan Nismo and more in AMA

One of the greatest innovations to come about thanks to the gigantic popularity of Reddit is the Ask Me Anything (AMA) question and answer format. The AMA becomes especially worthwhile, of course, when the person(s) answering the questions have detailed information or insight on products we love.
So, in the case of the recent AMA session with Gran Turismo creator and mastermind Kazunori Yamauchi (above), and his buddy and Nissan chief designer Shiro Nakamura (right), it was basically must-read stuff.
The pair really lived up to our expectations, too, with Kaz offering a lot of useful information about the future of the Gran Turismo franchise (especially the upcoming GT7 for Playstation 4), and Shiro promising to bring some interesting new ideas back to his colleagues at Nissan.